CdSe nanorod/TiO2 nanoparticle heterojunctions with enhanced solar- and visible-light photocatalytic activity

CdSe/TiO2NTs Heterojunction-Based Nonenzymatic Photoelectrochemical Sensor for Glucose Detection

Compared with a single semiconductor, the heterojunction formed by two different semiconductors usually has higher light utilization and better photoelectric performance. By using stable TiO2 nanotubes as the main subject, CdSe/TiO2NTs heterojunctions were synthesized by a hydrothermal method. XRD, TEM, SEM, PL, UV-vis, and EIS were used to characterize the fabricated CdSe/TiO2NTs. Under visible light irradiation, CdSe/TiO2NTs heterojunctions exhibited a higher absorption intensity and lower degree of photogenerated carrier recombination than TiO2. The electrons and holes were proven to be effectively separated in this heterojunction via theoretical calculation. Under CdSe/TiO2NTs' optimal conditions, the glucose concentrations (10-90 μM) had a linear relationship with the photocurrent value, and the detection limit was 3.1 μM. Moreover, the CdSe/TiO2NTs sensor exhibited good selectivity and stability. Based on the experimental data and theoretical calculations, its PEC sensing mechanism was also illuminated.

Enhanced Photoelectrocatalytic Activity of TiO2 Nanowire Arrays via Copolymerized G-C3N4 Hybridization

Photoelectrocatalytic (PEC) oxidation is an advanced technology that combines photocatalytic oxidation (PC) and electrolytic oxidation (EC). PEC activity can be greatly enhanced by the PC and EC synergy effect. In this work, novel copolymerized g-C3N4 (denoted as CNx)/TiO2 core-shell nanowire arrays were prepared by chemical vapor deposition. CNx were deposited on the surface of TiO2 nanowire arrays using organic monomer 4,5-dicyanidazole and dicyandiamide as copolymerization precursor. TiO2 nanowire arrays provide a direct and fast electron transfer path, while CNx is a visible light responsive material. After CNx deposition, the light response range of TiO2 is broadened to 600 nm. The deposition of CNx shell effectively improves the PC efficiency and PEC efficiency of TiO2. Under visible light irradiation and 1 V bias potential, the rate constant k of PEC degradation of CNx/TiO2 core-shell nanowire arrays is 0.0069 min−1, which is 72% higher than that of pure TiO2 nanowires. The built-in electric field formed in the interface between TiO2 core and CNx shell would effectively promote photogenerated charge separation and PEC activity.

Enhanced visible light-driven photocatalytic performance of CdSe nanorods

Cadmium selenide (CdSe) semiconductor nanorods are prepared in hydrothermal process using hydrazine hydrate (N₂H₄.H₂O) and ammonia (NH₃.H₂O) as reducing agents. The reaction time is increased to 7 h and the amount of hydrazine hydrate used is also increased to 15 mL which have resulted in diminished stacking faults in the CdSe nanorods prepared. The crystal structure, morphological variations, and size of the prepared CdSe nanorods are examined by XRD analysis. The crystalline size of the CdSe nanorods is 20-30 nm in diameter. HRTEM images reveal the formation of high order CdSe nanorods of the length about 25-40 nm. The bandgap in the CdSe nanoparticles is determined to be 2.17 eV. The peak at 595 nm in photoluminescence (PL) spectrum indicates oxygen vacancy defects in the prepared CdSe sample. The variation of dielectric properties with respect to temperature and frequency of pelletized CdSe is studied. High photocatalytic efficiency (98%) of catalyst/H₂O₂ is also achieved for decomposition of Rhodamine-B dye.

Y2O3 decorated TiO2 nanoparticles: Enhanced UV attenuation and suppressed photocatalytic activity with promise for cosmetic and sunscreen applications

Nanoparticulate titanium dioxide (TiO₂) is widely used in cosmetic products and sunscreens. However, primarily due to their photocatalytic activity, some TiO₂ products have been shown to be cytotoxic. Thus, the aim of this study was to reduce the photoactivity and consequent cytotoxicity of TiO₂nanoparticles. As such, in this work, yttrium oxide (Y₂O₃) was deposited onto TiO₂, at 5% and 10% Y/Ti weight ratio, via a hydrothermal method. The nanocomposites produced, TiO₂@Y₂O₃ 5 and 10 wt%, were characterised to assess their physical, photochemical and toxicological properties. These materials exhibit a uniform yttria coating, enhanced UV attenuation in the 280-350 nm range and significantly reduced photoactivity compared with a pristine commercial TiO₂ sample (Degussa Aeroxide® P25). Furthermore, the comparative cytotoxicity and photo-cytotoxicity of these materials to a human keratinocyte cell line (HaCaT), was assessed using a colorimetric tetrazolium salt (MTS) assay. Following 24-hour incubation with cells, both Y₂O₃ loadings exhibited improved biocompatibility with HaCaT cells, compared to the pristine TiO₂ sample, under all subsequent test conditions. In conclusion, the results highlight the potential of these materials for use in products, applied topically, with sun protection in mind.

Ag2WO4 nanorods decorated with AgI nanoparticles: Novel and efficient visible-light-driven photocatalysts for the degradation of water pollutants

To develop efficient and stable visible-light-driven (VLD) photocatalysts for pollutant degradation, we synthesized novel heterojunction photocatalysts comprised of AgI nanoparticle-decorated Ag2WO4 nanorods via a facile method. Various characterization techniques, including XRD, SEM, TEM, EDX, and UV-vis DRS were used to investigate the morphology and optical properties of the as-prepared AgI/Ag2WO4 catalyst. With AgI acting as the cocatalyst, the resulting AgI/Ag2WO4 heterostructure shows excellent performance in degrading toxic, stable pollutants such as rhodamine B (RhB), methyl orange (MO) and para-chlorophenol (4-CP). The high performance is attributed to the enhanced visible-light absorption properties and the promoted separation efficiency of charge carriers through the formation of the heterojunction between AgI and Ag2WO4. Additionally, AgI/Ag2WO4 exhibits durable stability. The active species trapping experiment reveals that active species (O2•- and h+) dominantly contribute to RhB degradation. The AgI/Ag2WO4 heterojunction photocatalyst characterized in this work holds great potential for remedying environmental issues due to its simple preparation method and excellent photocatalytic performance.