Influence of nano alumina coating on the flexural bond strength between zirconia and resin cement

Adhesive Cementation of Zirconia Based Ceramics-Surface Modification Methods Literature Review

Introduction: The conditioning procedures for glass-based ceramic restorations before adhesive cementation are generally recognized. In the case of polycrystalline ceramics, which include zirconium oxide, there is still no standardized protocol. The aim of this work was to present conditioning methods of the cementation surface of zirconium oxide fixed dentures. The new generation high translucency zirconia has been also considered. Material and method: The following keywords for the PUBMED and EMBASE databases were used: zirconium oxide, zirconium oxide with increased translucency, bond strength, bending strength, surface treatment. The inclusion criteria were original papers in English published between 2015–2021. Results: Out of 1537 publications, 53 articles were selected for the study, covering methods of conditioning zirconium ceramics, including new materials with increased translucency. These procedures were divided into 5 main groups. Summary: Due to the widespread use of zirconia ceramics and the introduction of new zirconia-based materials, the use of a predictable and standardized cementation protocol is one of the most important factors contributing to the long-term clinical success of prosthetic restorations. Therefore, the research showed differences in the properties of the covered materials after conditioning. It suggests the need to create separate conditioning protocols for highly translucent and traditional zirconia.

Novel Coatings on Zirconia for Improved Bonding with Veneer Ceramics

This study aimed to compare the effects of two surface-coating methods on the shear bond strength (SBS) of veneering ceramics (VC) to zirconia. Eighty pre-sintered zirconia cubes were randomly assigned into four study groups: E60S, E60P, N60S, and N60P. The zirconia surface was coated with a mixture of two types of glaze and alumina (<60 μm) by airbrush spraying and fine- brush painting. Surface roughness (Ra), X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), and SBS measurements (both initial and artificial aged conditions, including one month of water storage) were performed. The Ra results revealed significant differences among all groups (p < 0.001). The N60P group exhibited higher values of Ra (5.717 ± 0.20 µm) and SBS before and after water storage with values of 37.22 ± 4.954 MPa and 34.42 ± 3.977 MPa, respectively. The fine-brush coatings showed significantly higher SBS than that of airbrush coatings, in both initial and artificial conditions. Both coating methods and various coating materials (p < 0.001) produced a significant influence on VC-zirconia SBS. A significant correlation between Ra and SBS (Spearman’s rho = 0.808; p < 0.001) was found. The novel coating by fine-brush painting is a promising surface treatment and an easy technique for obtaining a rougher surface, which subsequently improves the bond strength to VC.