Three-Dimensional Morphometric Analysis of the Coracohumeral Distance Using Magnetic Resonance Imaging

Is it the subcoracoid impingement or the subacromial impingement that tears the subscapularis tendon? A comparison of the MRI findings of the operated and healthy shoulders of the patients

BACKGROUND

: The purpose of this study is to investigate whether the etiological factors accepted as causes of idiopathic subscapularis tears are true or not when the comparison is made with the opposite side healthy shoulder of the patients who underwent arthroscopic repair for an isolated subscapularis tear.

METHODS

Sixteen patients who underwent shoulder arthroscopy between February 2016 and January 2018 and were diagnosed with isolated subscapularis tear were evaluated. The coracohumeral distance (CHDax), coracoid overlap (CO), and tuberculum minus cysts (TMC) were evaluated on the axial images of the MRI studies while the acromiohumeral distance (AHDsag), CHDsag, and subscapularis tendon slip number (STSN) on the sagittal oblique images and the AHDcor and SLAP lesion on the coronal oblique images. Degeneration of the coracoacromial ligament was evaluated during arthroscopy.

RESULTS

The mean CHDsag (11.26-10.08), CHDax (10.63-9.98), CO (14.2-15.43), AHDsag (8-7.66), and AHDcor (7.65-7.68) measurements (operated side-healthy side, respectively) were statistically similar (p > 0.05). No statistically significant difference was found between TMC and STSN in healthy and operated shoulders (p > 0.05). There was mild coracoacromial ligament fraying in 4 (25%) and obvious coracoacromial ligament fraying in 8 (50%) which indicated subacromial impingement in 75% of the patients.

DISCUSSION

The parameters of the coracoid process did not reveal any significant difference between the operated (for an isolated subscapularis tear) and opposite-side healthy shoulders of the patients. However, coracoacromial ligament degeneration was present in 75% of the patients.

Biomechanical Analysis of Coracoid Stability After Coracoplasty: How Low Can You Go?

Background:

Arthroscopic coracoplasty is a procedure for patients affected by subcoracoid impingement. To date, there is no consensus on how much of the coracoid can be resected with an arthroscopic burr without compromising its stability.

Purpose:

To determine the maximum amount of the coracoid that can be resected during arthroscopic coracoplasty without leading to coracoid fracture or avulsion of the conjoint tendon during simulated activities of daily living (ADLs).

Study Design:

Controlled laboratory study.

Methods:

A biomechanical cadaveric study was performed with 24 shoulders (15 male, 9 female; mean age, 81 ± 7.9 years). Specimens were randomized into 3 treatment groups: group A (native coracoid), group B (3-mm coracoplasty), and group C (5-mm coracoplasty). Coracoid anatomic measurements were documented before and after coracoplasty. The scapula was potted, and a traction force was applied through the conjoint tendon. The stiffness and load to failure (LTF) were determined for each specimen.

Results:

The mean coracoid thicknesses in groups A through C were 7.2, 7.7, and 7.8 mm, respectively, and the mean LTFs were 428 ± 127, 284 ± 77, and 159 ± 87 N, respectively. Compared with specimens in group A, a significantly lower LTF was seen in specimens in group B (P = .022) and group C (P < .001). Postoperatively, coracoids with a thickness ≥4 mm were able to withstand ADLs.

Conclusion:

While even a 3-mm coracoplasty caused significant weakening of the coracoid, the individual failure loads were higher than those of the predicted ADLs. A critical value of 4 mm of coracoid thickness should be preserved to ensure the stability of the coracoid process.

Clinical Relevance:

In correspondence with the findings of this study, careful preoperative planning should be used to measure the maximum reasonable amount of coracoplasty to be performed. A postoperative coracoid thickness of 4 mm should remain.

Less than 9.5-mm coracohumeral distance on axial magnetic resonance imaging scans predicts for subscapularis tear

Background

Diagnosis of subscapularis (SSC) tendon lesions on magnetic resonance imaging (MRI) can be challenging. A small coracohumeral distance (CHD) has been associated with SSC tears. This study was designed to define a specific threshold value for CHD to predict SSC tears on axial MRI scans.

Methods

This retrospective study included 172 shoulders of 168 patients who underwent arthroscopic surgery for rotator cuff tear or glenohumeral instability. Diagnostic arthroscopy confirmed an SSC tear in 62 cases (36.0%, test group a), rotator cuff tear tears other than SSC in 71 cases (41.3%, control group b) and glenohumeral instability without any rotator cuff tear in 39 cases (22.7%, zero-sample group c). All patients had a preoperative MRI of the shoulder (1.5T or 3T). Minimum CHD was measured on axial fat-suppressed proton density-, T2-, or T1-weigthed sequences. Receiver operating characteristics analysis was used to determine the threshold value for CHD, and sensitivity and specificity were calculated.

Results

CHD measurement had a good interobserver reliability (Intraclass correlation coefficient 0.799). Mean CHD was highly significantly (P < .001) less for test group a (mean 7.3 mm, standard deviation ± 2.2) compared with control group b (mean 11.1 mm, standard deviation ± 2.3) or zero-sample group c (mean 13.6 mm, standard deviation ± 2.9). A threshold value of CHD <9.5 mm had a sensitivity of 83.6% and a specificity of 83.9% to predict SSC tears.

Conclusion

A CHD <9.5 mm on MRI is predictive of SSC lesions and a valuable tool to diagnose SSC tears.

Use of a 3D Virtually Reconstructed Patient-Specific Model to Examine the Effect of Acetabular Labral Interference on Hip Range of Motion

Background:

The labrum is likely to influence impingement, which may also depend on acetabular coverage. Simulating impingement using 3-dimensional (3D) computed tomography (CT) is a potential solution to evaluating range of motion (ROM); however, it is based on bony structures rather than on soft tissue.

Purpose:

To examine ROM when the labrum is considered in a 3D dynamic simulation. A particular focus was evaluation of maximum flexion and internal rotation angles before occurrence of impingement, comparing them in cases of cam-type femoroacetabular impingement (FAI) and borderline developmental dysplasia of the hip (BDDH).

Study Design:

Descriptive laboratory study.

Methods:

Magnetic resonance imaging (MRI) and CT scans of 40 hips (20 with cam-type FAI and 20 with BDDH) were reviewed retrospectively. The thickness and width of the labrum were measured on MRI scans. A virtual labrum was reconstructed based on patient-specific sizes measured on MRI scans. The impingement point was identified using 3D dynamic simulation and was compared with the internal rotation angle before and after labral reconstruction.

Results:

The thickness and width of the labrum were significantly larger in BDDH than in FAI (P < .001). In FAI, the maximum internal rotation angles without the labrum were 30.3° at 90° of flexion and 56.9° at 45° of flexion, with these values decreasing to 18.7° and 41.4°, respectively, after labral reconstruction (P < .001). In BDDH, the maximum internal rotation angles were 48.0° at 90° of flexion and 76.7° at 45° of flexion without the labrum, decreasing to 31.1° and 55.3°, respectively, after labral reconstruction (P < .001). The differences in the angles before and after labral reconstruction were larger in BDDH than in FAI (90° of flexion, P = .03; 45° of flexion, P = .01).

Conclusion:

As the labrum was significantly more hypertrophic in BDDH than in FAI, the virtual labral model revealed that the labrum’s interference with the maximum internal rotation angle was also significantly larger in BDDH.

Clinical Relevance:

The labrum has a significant effect on impingement; this is more significant for BDDH than for FAI.

Coracoid morphology is not associated with subscapularis tears

BACKGROUND

The observation of the roller-wringer effect fueled the idea that coracoid morphology is related to subscapularis pathology. We aimed to examine this relationship, specifically focusing on how the coracohumeral distance (CHD) and 2 new metrics of coracoid morphology relate to subscapularis tears.

METHODS

In this retrospective study, we identified consecutive patients 45 years or older who underwent shoulder arthroscopy for any indication. We blindly reviewed preoperative magnetic resonance imaging studies of each patient, measuring the CHD, lateral extent (LE), and caudal extent (CE) of the coracoid process. Patients' subscapularis condition was assessed via operative reports; stratified according to Lafosse grade criteria; and compared for differences in the CHD, LE, and CE by 1-way analysis of variance and 2-tailed t tests.

RESULTS

The study included 201 patients. Of these, 112 had no evidence of subscapularis injury, whereas Lafosse grade I injuries were identified in 52 patients; grade II, in 19; and grades III-V, in 18. The CHD, LE, and CE were not correlated with subscapularis injury (CHD, P = .36; LE, P = .36; and CE, P = .13).

CONCLUSIONS

We found no correlation between subscapularis injury and the CHD, LE, and CE. These findings support the idea that coracoid morphology may not be a cause of subscapularis pathology and suggest that coracoplasty may not be necessary prophylactically or as part of subscapularis repair.