How efficacious is the combination of substitute bone graft with autogenous bone graft in comparison with substitute bone graft alone in the horizontal bone gain? A systematic review and meta-analysis

Horizontal ridge augmentation using guided bone regeneration with an association of particulate allografts mixed with platelet-rich fibrin, collagen membrane and tent-screws: A prospective study

BACKGROUND

Guided Bone Regeneration (GBR) is a versatile technique employed not only to correct pre-implant alveolar bone defects but also to facilitate bone defect correction during simultaneous implant placement. The effectiveness of GBR varies significantly among different protocols, as reported in the literature. This study specifically aimed to radiologically evaluate the horizontal bone gain obtained using a GBR procedure combining a particulate allograft, platelet-rich fibrin, resorbable collagen membrane, and screw tents.

MATERIALS AND METHODS

A total of 42 patients with an insufficient alveolar bone width for dental implant placement were treated with a GBR technique using a mixture of particulate allograft (demineralised freeze-dried bone allograft 300-500 and 500-1000 µm), advanced platelet-rich fibrin (A-PRF), resorbable collagen membranes and screws tents (1.2 mm in diameter). Over the course of the study, a total of 63 GBR procedures were performed on these patients. Bone gains were measured by cone-beam computed tomography at 9.1 ± 2.0 months post-operative.

RESULTS

A significant mean increase (P < 0.001) of 3.2 ± 0.9 mm at the sites of the greatest bone defect was observed. This improvement was consistent across various locations, including both maxillary and mandibular regions, and in cases of terminal and embedded edentulism, without any post-operative complications during the entire post-operative follow-up. All patients benefited from implant placement following the bone augmentation protocol.

CONCLUSION

GBR combining particulate allografts, A-PRF, collagen membranes, and screw tents achieves reliable, predictable, and reproducible clinical gains that allow for future implant placement.

Applications of selected polysaccharides and proteins in dentistry: A review

In the last ten years, remarkable characteristics and a variety of functionalities have been created in biopolymeric materials for clinical dental applications. This review gives an overview of current knowledge of natural biopolymers (biological macromolecules) in terms of structural, functional, and property interactions. Natural biopolymers such as polysaccharides (chitosan, bacterial cellulose, hyaluronic acid, and alginate) and polypeptides (collagen and silk fibroin) have been discussed for dental uses. These biopolymers exhibit excellent properties alone and when employed with other composite molecules making them ideal for treatment of periodontitis, endodontics, dental pulp regeneration and oral wound healing. These biopolymers together with the composite materials exhibit better biocompatibility, inertness, elasticity and flexibility which makes them a leading candidate to be used for other dental applications like caries management, oral appliances, dentures, dental implants and oral surgeries.

Allogeneic versus autogenous shell technique augmentation procedures: a prospective-observational clinical trial comparing surgical time and complication rates

OBJECTIVES

Autogenous and allogeneic blocks for shell augmentation of the jaw have shown comparable results. This observational clinical study aimed to compare both materials for shell augmentation concerning surgery time and intra- and postoperative complications.

MATERIAL AND METHODS

Bone augmentation with the shell technique using autogenous or allogenous bone was performed in 117 patients with segmental jaw atrophy. The primary study parameter was the surgical time, comparing both materials. Subsequently, intra- and postoperative complications were recorded.

RESULTS

Allogeneic (n = 60), autogenous (n = 52), or both materials (n = 5) were used. The use of allogeneic material led to a significantly shorter operation time (p < 0.001). A more experienced surgeon needed significantly less time than a less experienced surgeon (p < 0.001). An increasing number of bone shells (p < 0.001), an additional sinus floor elevation, and intraoperative complications also significantly increased the operation time (p = 0.001). Combining allogeneic and autogenous shells (p = 0.02) and simultaneous sinus floor elevation (p = 0.043) significantly impacted intraoperative complications. No correlations were found between the included variables for postoperative complications (all p > 0.05). In total, 229 implants were inserted after a healing time of 4-6 months, with a survival of 99.6% after a mean follow-up duration of 9 months.

CONCLUSIONS

Compared to the autogenous technique, allogeneic shell augmentation has a shorter surgical time and a similar rate of intra- and postoperative complications as autogenous bone. Together with its promising clinical results, this technique can be recommended.

The effect of osteocyte-derived RANKL on bone graft remodeling: An in vivo experimental study

OBJECTIVES

Autologous bone is considered the gold standard for grafting, yet it suffers from a tendency to undergo resorption over time. While the exact mechanisms of this resorption remain elusive, osteocytes have been shown to play an important role in stimulating osteoclastic activity through their expression of receptor activator of NF-κB (RANK) ligand (RANKL). The aim of this study was to assess the function of osteocyte-derived RANKL in bone graft remodeling.

MATERIALS AND METHODS

In Tnfsf11fl/fl ;Dmp1-Cre mice without osteocyte-specific RANKL as well as in Dmp1-Cre control mice, 2.6 mm calvarial bone disks were harvested and transplanted into mice with matching genetic backgrounds either subcutaneously or subperiosteally, creating 4 groups in total. Histology and micro-computed tomography of the grafts and the donor regions were performed 28 days after grafting.

RESULTS

Histology revealed marked resorption of subcutaneous control Dmp1-Cre grafts and new bone formation around subperiosteal Dmp1-Cre grafts. In contrast, Tnfsf11fl/fl ;Dmp1-Cre grafts showed effectively neither signs of bone resorption nor formation. Quantitative micro-computed tomography revealed a significant difference in residual graft area between subcutaneous and subperiosteal Dmp1-Cre grafts (p < .01). This difference was not observed between subcutaneous and subperiosteal Tnfsf11fl/fl ;Dmp1-Cre grafts (p = .17). Residual graft volume (p = .08) and thickness (p = .13) did not differ significantly among the groups. Donor area regeneration was comparable between Tnfsf11fl/fl ;Dmp1-Cre and Dmp1-Cre mice and restricted to the defect margins.

CONCLUSIONS

The results suggest an active function of osteocyte-derived RANKL in bone graft remodeling.