Analysis of the wool thickness and medullation characteristics based on sex and color in a herd of alpacas in Poland

Fiber quality and fertility in male alpacas in the Cusco region of Peru

Introduction

High testosterone levels might be associated with coarser fiber in alpacas, affecting fiber quality. In the husbandry systems employed in the Andes, males with higher libido might have an increased frequency of successful matings than males with lower libido. This study aimed to determine some of the factors affecting fiber quality in Peruvian alpacas and to evaluate the association between fiber quality and male mating behavior.

Methods

The study population consisted of 189 adult male alpacas at La Raya, Cusco, Peru, at 4,400 m above sea level, belonging to the National University of San Marcos, Lima, and the National University of San Antonio Abad of Cusco. Fiber samples were collected from male alpacas in September 2015; body condition score (BCS) was evaluated. After washing and drying, the fiber samples were analyzed using an Optical Fiber Diameter Analyser 2000; linear regression analysis between predictor variables (location of alpacas, age, BCS, and fiber color) and fiber quality outcomes was conducted. Fertility data were available only for some males belonging to San Marcos University, consisting of hand-written records from the breeding season January to April 2015; individual fertility quotients were calculated for each male.

Results

Age was associated with fiber quality, young alpacas having the finest fibers (p < 0.05). An increased BCS was associated with increased fiber length, fiber diameter and spinning fineness, but decreased comfort factor (p < 0.05). White fibers were thinner (p = 0.05) than colored fibers, with lower comfort factor and spinning fineness. A significant association between the fertility quotient and fiber curvature was observed (p = 0.018).

Discussion

These results suggest that careful selection of breeding individuals and attention to husbandry could result in improved fiber quality among alpaca herds in Peru. However, it would be advisable to increase the number of males studied, using more reliable methods for evaluating male fertility and pregnancy diagnosis than were available for this study.

Variation in Wool Characteristics across the Body in a Herd of Alpacas Kept in Poland

Simple Summary

Alpaca wool is luxurious and, hence, arouses great interest among consumers. However, the drawbacks of this wool are its variation in thickness and the proportion of medullated fibers. Knowing about variations in the quality characteristics of the wool on an animal’s body can help in properly evaluating and using this wool. This study has shown that the wool from the belly, front and hind legs, and the neck need to be separated from the total fleece. The most appropriate site from where to collect a representative sample of wool from the fleece for testing purposes is at the midside of the animal.

Abstract

Wool characteristics vary depending on where on the body the wool is produced. Knowledge of this variation is important in order to separate the fleece into more homogenous parts. Similar parts from different animals can then be pooled to create batches of wool with similar characteristics. This will allow for better alpaca products with less variation. The aim of this study was to determine the variation in fiber diameter, medullation, and staple length across the body of alpacas from one herd. Wool samples were collected from 16 adult (3–5 years old) females: from the saddle (S), midside (MS), neck (N), and pieces (P). The mean fiber diameter (MFD) and medullation were measured using a projection microscope according to the IWTO-8-2011 standard. The fiber diameter of the pieces was greater (p < 0.05) than for the S, MS, and N areas. The highest medullation was found on the neck. The neck was also characterized by the shortest wool. The MFD for the fleece, excluding P, showed the strongest correlation (r = 0.927) with the MFD of MS. The study showed that due to the variation of fiber diameter, the incidence of medullation, and staple length, the wool from the pieces and the neck should be separated from the total fleece. The most appropriate site from where to collect a representative sample of wool from the fleece for testing purposes is the midside site of the animal.