Computed tomography measurement of the bone matrix of vertebral pedicle and its clinical significance

Modified Tap-drilling Technique for Mid-cervical Pedicle Screw Placement: A Case Series of 473 Consecutive Screws

STUDY DESIGN

Retrospective cohort study.

OBJECTION

To report our modified tap-drilling technique for mid-cervical pedicle screw placement and to evaluate its safety and accuracy.

SUMMARY OF BACKGROUND DATA

Cervical pedicle screw fixation, which provides a strong stabilization, has been a major concern due to the potential risks to neurovascular structures despite its increasing use. Several insertion techniques have been described so far to improve the cervical pedicle screw placement accuracy.

METHODS

This study retrospectively reviewed patients who underwent mid-cervical (C3-C6) pedicle screw fixation between September 2005 and September 2020. Laminectomy, laminoforaminotomy, or notch-referred anatomic landmark methods were used to adjust the entry point and the direction of the screws. After the cortical bone was removed at the entry point with a diamond burr, the cancellous bone was slowly drilled with a hand drill starting from 8 to 10 millimeters in length. Then, all of the bone walls were checked with a ball-tip probe to determine if there was any breach. The procedure was repeated several times. After completing the drilling, the screw was inserted without tapping. The breach rate of pedicle screws was analyzed on postoperative computed tomography scans.

RESULTS

A total of 473 mid-cervical pedicle screws were placed in 122 consecutive patients. No navigation or computer-assisted system was used, and the first 2 authors inserted all of the screws. All patients completed the surgery, and no evident intraoperative complications occurred. Postoperative CT scans were obtained for 405 screws. Although deviation was observed for 131 pedicle screws, a critical deviation was observed for only 25 pedicle screws.

CONCLUSIONS

Cervical pedicle screw insertion is a risky but applicable technique. Checking all of the bone walls with a ball-tip probe before gradually advancing the hand drill in small amounts, as presented in this article, may lead to the safe and effective placement of cervical pedicle screws.

Correlation of CT-based bone mineralization with drilling-force measurements in anatomical specimens is suitable to investigate planning of trans-pedicular spine interventions

This interdisciplinary study examined the relationship between bone density and drilling forces required during trans-pedicular access to the vertebra using fresh-frozen thoraco-lumbar vertebrae from two female body donors (A, B). Before and after biomechanical examination, samples underwent high-resolution CT-quantification of total bone density followed by software-based evaluation and processing. CT density measurements (n = 4818) were calculated as gray values (GV), which were highest in T12 for both subjects (GVmaxA = 3483.24, GVmaxB = 3160.33). Trans-pedicular drilling forces F (Newton N) were highest in L3 (FmaxB = 5.67 N) and L4 (FmaxA = 5.65 N). In 12 out of 13 specimens, GVs significantly (p < 0.001) correlated with force measurements. Among these, Spearman correlations r were poor in two lumbar vertebrae, fair in five specimens, and moderately strong in another five specimens, and highest for T11 (rA = 0.721) and L5 (rB = 0.690). Our results indicate that CT-based analysis of vertebral bone density acquired in anatomical specimens is a promising approach to predict the drilling force appearance as surrogate parameter of its biomechanical properties by e.g., linear regression analysis. The study may be of value as basis for biomechanical investigations to improve planning of the optimal trajectory and to define safety margins for drilling forces during robotic-assisted trans-pedicular interventions on the spine in the future.