Natural and Anthropogenic Sources of Seismic, Hydroacoustic, and Infrasonic Waves: Waveforms and Spectral Characteristics (and Their Applicability for Sensor Calibration)

The record of seismic, hydroacoustic, and infrasonic waves is essential to detect, identify, and localize sources of both natural and anthropogenic origin. To guarantee traceability and inter-station comparability, as well as an estimation of the measurement uncertainties leading to a better monitoring of natural disasters and environmental aspects, suitable measurement standards and reliable calibration procedures of sensors, especially in the low-frequency range down to 0.01 Hz, are required. Most of all with regard to the design goal of the Comprehensive Nuclear-Test-Ban Treaty Organisation's International Monitoring System, which requires the stations to be operational nearly 100% of the time, the on-site calibration during operation is of special importance. The purpose of this paper is to identify suitable excitation sources and elaborate necessary requirements for on-site calibrations. We give an extensive literature review of a large variety of anthropogenic and natural sources of seismic, hydroacoustic, and infrasonic waves, describe their most prominent features regarding signal and spectral characteristics, explicitly highlight some source examples, and evaluate the reviewed sources with respect to requirements for on-site calibrations such as frequency bandwidth, signal properties as well as the applicability in terms of cost-benefit. According to our assessment, earthquakes stand out across all three waveform technologies as a good natural excitation signal meeting the majority of the requirements. Furthermore, microseisms and microbaroms allow a calibration at very low frequencies. We also find that in each waveform technique man-made controlled sources such as drop weights or air guns are in good agreement with the required properties, although limitations may arise regarding the practicability. Using these sources, procedures will be established allowing calibration without record interrupting, thereby improving data quality and the identification of treaty-related events.

Estimation of Avalanche Development and Frontal Velocities Based on the Spectrogram of the Seismic Signals Generated at the Vallée de la Sionne Test Site

The changes in the seismic signals generated by avalanches recorded at three sites along a path at the Vallée de la Sionne (VdlS) experimental site are presented. We discuss and correlate the differences in the duration, signal amplitudes, and frequency content of the sections (Signal ONset (ON), Signal Body (SBO), and Signal TAil and Signal ENd STA-SEN) of the spectrograms with the evolution of the powder, transitional and wet snow avalanches along a path. The development of the avalanche front was quantified using the exponential function in time F (t) = K’ exp (β t) fitted to the shape of the signal ONset (SON section of the spectrogram. The speed of the avalanche front is contained in β. To this end, a new method was developed. The three seismic components were converted into one seismic component (FS), when expressing the vector in polar coordinates. We linked the theoretical function of the shape of the FS-SON section of the spectrogram to the numerical coefficients of its shape after considering the spectrogram as an image. This allowed us to obtain the coefficients K’ and β. For this purpose, the Hough Transform (HT) was applied to the image. The values of the resulting coefficients K’ and β are included in different ranges in accordance with the three types of avalanche. Curves created with these coefficients enable us to estimate the development of the different avalanche types along the path. Our results show the feasibility of classifying the type of avalanche through these coefficients. Average speeds of the avalanches approaching the recording sites were estimated. The speed values of wet and transitional avalanches are consistent with those derived from GEODAR (GEOphysical Doppler radAR) measurements, when available. The absence of agreement in the speed values obtained from seismic signals and GEODAR measurements for powder snow avalanches indicates, for this type of avalanche, a different source of the measured signal. Hence, the use of the two measuring systems proves to be complementary.