Comparison of the Antibacterial Activity of Selected Deep Eutectic Solvents (DESs) and Deep Eutectic Solvents Comprising Organic Acids (OA-DESs) Toward Gram-Positive and Gram-Negative Species

Deep eutectic solvents (DESs) have been intensively investigated in recent years for their antibacterial properties, with DESs that comprise organic acids (OA-DESs) showing promising antibacterial action. However a majority of the reports focused only on a limited number strains and techniques, which is not enough to determine the antibacterial potential of a substance. To bridge this gap, the antibacterial activity of classical DESs and OA-DESs is assessed on twelve Gram-negative and Gram-positive bacteria strains, with some of them exhibiting specific resistance toward antibiotics. The investigated formulations of OA-DESs comprise glycolic, malic, malonic, and oxalic acids as representatives of this group. Using a range of microbiological assays as well as physicochemical characterization methods, a major difference of the effectiveness between the two groups is demonstrated, with OA-DESs exhibiting, as expected, greater antibacterial effectiveness than classical DESs. Most interestingly, slight differences in the minimum inhibitory and bactericidal concentration values as well as time-kill kinetics profiles are observed between Gram-positive and Gram-negative strains. Transmission electron microscopy analysis reveals the effect of the treatment of the bacteria with the representatives of both groups of DESs, which allows us to better understand the possible mechanism-of-action of these novel materials.

A Kinetically Superior Rechargeable Zinc-Air Battery Derived from Efficient Electroseparation of Zinc, Lead, and Copper in Concentrated Solutions

Zinc electrodeposition is currently a hot topic because of its widespread use in rechargeable zinc-air batteries. However, Zn deposition has received little attention in organic solvents with much higher ionic conductivity and current efficiency. In this study, a Zn-betaine complex is synthesized by using ZnO and betainium bis[(trifluoromethyl)sulfonyl]imide and its electrochemical behavior for six organic solvents and electrodeposited morphology are studied. Acetonitrile allowed dendrite-free Zn electrodeposition at room temperature with current efficiencies of up to 86 %. From acetonitrile solutions in which Zn, Pb, and Cu complexes are dissolved in high concentrations, Zn and Pb/Cu are efficiently separated electrolytically under potentiostatic control, allowing the purification of solutions prepared directly from natural ores. Additionally, a highly flexible Zn anode with excellent kinetics is obtained by using a carbon fabric substrate. A rechargeable zinc-air battery with these electrodes shows an open-circuit voltage of 1.63 V, is stable for at least 75 cycles at 0.5 mA cm^-2 or 33 cycles at 20 mA cm^-2 , and allows intermediate cycling at 100 mA cm^-2 .

Ionometallurgical Step-Electrodeposition of Zinc and Lead and its Application in a Cycling-Stable High-Voltage Zinc-Graphite Battery

Ionometallurgy is a new development aiming at the sustainable low-temperature conversion of naturally occurring metal ores and minerals to their metals or valuable chemicals in ionic liquids (ILs) or deep eutectic solvents. The IL betainium bis((trifluoromethyl)sulfonyl)imide, [Hbet][NTf₂ ], is especially suited for this process due to its redox-stability and specific-functionalization. The potentiostatic electrodeposition of zinc and lead starting directly from ZnO and PbO, which dissolve in [Hbet][NTf₂ ] in high concentrations is reported. The initial reduction potentials of zinc(II) and lead(II) are about -1.5 and -1.0 V, respectively. The ionic conductivity of the solution of ZnO in [Hbet][NTf₂ ] is measured and the effect of various temperatures and potentials on the morphology of the deposited material is explored. The IL proves to be stable under the chosen conditions. From IL-solutions, where ZnO, PbO, and MgO have been dissolved, metallic Zn and Pb are deposited under potentiostatic control either consecutively by step-electrodeposition or together in a co-electrodeposition. Using the method, Zn is also deposited on 3D copper foam and assembles into high-voltage zinc-graphite battery. It exhibits a working-voltage up to 2.7 V, an output midpoint discharge-voltage of up to 2.16 V, up to 98.6% capacity-retention after 150 cycles, and good rate performance.

Correlation of Morphology and Crystal Structure of Metal Powders Produced by Electrolysis Processes

In this review paper, morphologies of metal powders produced by the constant (potentiostatic and galvanostatic) regimes of electrolysis from aqueous electrolytes are correlated with their crystal structure at the semiquantitative level. The main parameters affecting the shape of powder particles are the exchange current density (rate of electrochemical process) and overpotential for hydrogen evolution reaction. Depending on them, various shapes of dendrites (the needles, the two-dimensional (2D) fern-like, and the three-dimensional (3D) pine-like dendrites), and the particles formed under vigorous hydrogen evolution (cauliflower-like and spongy-like particles) are produced by these regimes of electrolysis. By decreasing the exchange current density value, the crystal structure of the powder particles is changed from the strong (111) preferred orientation obtained for the needle-like (silver) and the 2D (lead) dendrites to the randomly orientated crystallites in particles with the spherical morphology (the 3D dendrites and the cauliflower-like and the spongy-like particles). The formation of metal powders by molten salt electrolysis and by electrolysis in deep eutectic solvents (DESs) and the crystallographic aspects of dendritic growth are also mentioned in this review.

Speciation of Copper(II)-Betaine Complexes as Starting Point for Electrochemical Copper Deposition from Ionic Liquids

The application of ionic liquids for the dissolution of metal oxides is a promising field for the development of more energy- and resource-efficient metallurgical processes. Using such solutions for the production of valuable chemicals or electrochemical metal deposition requires a detailed understanding of the chemical system and the factors influencing it. In the present work, several compounds are reported that crystallize after the dissolution of copper(II) oxide in the ionic liquid [Hbet][NTf2 ]. Dependent on the initial amount of chloride, the reaction temperature and the purity of the reagent, copper crystallizes in complexes with varying coordination geometries and ligands. Subsequently, the influence of these different complex species on electrochemical properties is shown. For the first time, copper is deposited from the ionic liquid [Hbet][NTf2 ], giving promising opportunities for more resource-efficient copper plating. The copper coatings were analyzed by SEM and EDX measurements. Furthermore, a mechanism for the decomposition of [Hbet][NTf2 ] in the presence of chloride is suggested and supported by experimental evidence.

Synthesis and Dissolution of Metal Oxides in Ionic liquids and Deep Eutectic Solvents

Ionic liquids (ILs) and deep eutectic solvents (DESs) have proven to be suitable solvents and reactants for low-temperature reactions. To date, several attempts were made to apply this promising class of materials to metal oxide chemistry, which, conventionally, is performed at high temperatures. This review gives an overview about the scientific approaches of the synthesis as well as the dissolution of metal oxides in ILs and DESs. A wide range of metal oxides along with numerous ILs and DESs are covered by this research. With ILs and DESs being involved, many metal oxide phases as well as different particle morphologies were obtained by means of relatively simple reactions paths. By the development of acidic task-specific ILs and DESs, even difficultly soluble metal oxides were dissolved and, hence, made accessible for downstream chemistry. Especially the role of ILs in these reactions is in the focus of discussion.

Pb electrodeposition from PbO in the urea/1-ethyl-3-methylimidazolium chloride at room temperature

In this study, we dissolved PbO in a new electrolyte urea/1-ethyl-3-methylimidazolium chloride (EMIC) and electrochemically extracted Pb.