Novel zone elution mode in coiled tube field-flow fractionation for online separation and characterization of environmental submicron particles

Coiled tube field-flow fractionation (CTFFF) is currently applied to environmental and material studies. In the present work, a novel zone elution mode in CTFFF has been proposed and developed. Zone elution mode is based on the separation of particles by stepwise decreasing the flow rate of the carrier fluid and their subsequent elution at a constant flow rate. The fractionation parameters were optimized using a mixture of standard silica submicron particles (150, 390, and 900 nm). Taking samples of volcanic ash as examples, it has been demonstrated that zone elution mode can be successfully used for the fractionation of environmental nano- and submicron particles. For the first time, CTFFF was coupled online with a dynamic light scattering detector for the size characterization of eluted particles. Zone elution in CTFFF can serve for the further development of hyphenated techniques enabling efficient fractionation and size/elemental characterization of environmental particles in nano- and submicrometric size ranges.

Assessment of sources, environmental, ecological, and health risks of potentially toxic elements in urban dust of Moscow megacity, Russia

Potentially toxic elements (PTEs) in urban dust of Moscow megacity and related risks have been studied. 78 samples were collected in the Moscow downtown in sites with different anthropogenic load, namely, major highways, residential area, and recreation zones. The concentrations of PTEs in urban dust were determined by ICP-MS and ICP-AES. Then, environmental, ecological and health risks of PTEs in urban dust were assessed. In addition, potential sources of PTEs in dust were identified. It is shown that Moscow dust is mainly contaminated by Sb, Zn, Pb, Cd, Cu, Sn, and Mo, which according to the data of principal component and correlation analyses can be attributed to anthropogenic sources (non-exhaust vehicle emissions). Potential ecological risk factor demonstrates that Cu, Mo, and Cd have moderate potential ecological risks in 13% of studied area, while Sb has this risk in 62% of area. Potential ecological risk indices indicate that 41% of studied territory is of moderate ecological risk. Concerning the human risks through ingestion, dermal contact, and inhalation pathways, PTEs in Moscow dust have no significant non-carcinogenic risks for adults. However, the value of total hazard index for children is 1.8 showing that non-carcinogenic risks may occur. Moreover, possible carcinogenic risks caused by Cr are evaluated. The finding of the present study can be used for ecological management in the megacity to reduce both ecological and human risks. A special attention should be given to periods of hot and dry weather and to traffic-related emissions.

Nanospeciation of metals and metalloids in volcanic ash using single particle inductively coupled plasma mass spectrometry

Volcanic activity is one of the main sources of natural nanoparticles. It has been found earlier that the concentration of toxic metals/metalloids in nanoparticles of volcanic ash may be one or two orders of magnitude higher than in bulk sample. However, fate and behavior of toxic metals/metalloids depend on the type of their binding to nanoparticles. Hence, element species adsorbed onto pyroclastic nanoparticles and individual nanophases of metal/metalloid oxides or salts should be distinguished. For the first time, the single particle inductively coupled plasma mass spectrometry has been applied to the nanospeciation of volcanic particles. Ashes of four volcanoes of Kamchatka (Russia) were under study. Nanoparticles were separated from bulk ash samples using coiled-tube field-flow fractionation. It has been shown that the nanospeciation of Ni, Zn, Ag, Cd, Tl, As, Pb, Bi, Te, and Hg is dependent on element and volcano. In most cases these elements can be found both as species absorbed onto pyroclastic nanoparticles and as individual nanophases. The ratios of individual nanophases and adsorbed species vary with the sample. In nanoparticles of Tolbachik volcano ash, Ni, Zn, Tl, and Hg are present only as individual nanophases, while Bi, As, Pb, Ag, Cd, and Te are found both as adsorbed species and individual nanophases. The results obtained open a new door into study on the chemical composition of volcanic ash nanoparticles and their fate in the environment.

Characterization of volcanic ash nanoparticles and study of their fate in aqueous medium by asymmetric flow field-flow fractionation-multi-detection

Dimensional and elemental characterization of environmental nanoparticles is a challenging task that requires the use of a set of complementary analytical methods. Asymmetric flow field-flow fractionation coupled with UV-Vis, multi-angle laser light scattering and ICP-MS detection was applied to study the nanoparticle fraction of a volcanic ash sample, in a Milli-Q water suspension at pH 6.8. It has been shown that the separated by sedimentation nanoparticle fraction of the Klyuchevskoy volcano ash suspension contains 3 polydisperse populations for which size ranges (expressed in gyration radius, rG), hydrodynamic behaviours (evaluated via shape index) and elemental compositions are different. These 3 populations did not dissolve over the 72-h study but aggregated and settled out differently. Thus, the population of particles with gyration radii <140 nm (P1), which contained 6% Al₂O₃ and represented approximately 20% by mass of the nanoparticle fraction, remained in suspension without observable aggregation. The populations P2 and P3, which represented 67% and 13% by mass in the initial suspension, covered the rG range 25-250 nm and contained 17% and 15% Al₂O₃, respectively. Over time, populations P2 and P3 aggregated and their concentration in suspension at 72 h decreased by approximately 40% compared with the initial suspension. The decrease of these nanoparticle populations occurred either from the beginning of the temporal monitoring (P2) or after 30 h (P3). Aggregation generated a new population (P4) in suspension with rG up to 300 nm and mostly consisting of P2. This population represented only up to 6 to 7% of the nanoparticle fraction and decreased beyond 50 h. As a result, the trace elements present in the nanoparticle fraction and monitored (Cu and La) were also no longer found in the suspension. The results obtained can offer additional insights into the fate of volcanic ash nanoparticles in the environment.

Separation of nanoparticles from polydisperse environmental samples: comparative study of filtration, sedimentation, and coiled tube field-flow fractionation

Nanoparticles (NPs) in the environment have a potential risk for human health and the ecosystem due to their ubiquity, specific characteristics, and properties (extreme mobility in the environment, abilities to accumulate of toxic elements and penetrate into living organisms). There is still a gap in studies on the chemical composition of natural NPs. The main reason is the difficulty to recover NPs, which may represent only one-thousandth or less of the bulk environmental sample, for further dimensional and quantitative characterization. In the present study, a methodology for the recovery of the nanoparticle fraction from polydisperse environmental samples was developed taking as example volcanic ashes from different regions of the world. For the first time, three separation methods, namely, filtration through a 0.45-μm membrane, sedimentation, and coiled tube field-flow fractionation (CTFFF), were comparatively studied. The separated fractions were characterized by laser diffraction and scanning electron microscopy and then analyzed by inductively coupled plasma atomic emission and mass spectrometry. It has been shown that all three methods provide the separation of NPs less than 400 nm from the bulk material. However, the fraction separated by sedimentation also contained a population (5% in mass) of submicron particles (~ 400-900 nm). The filtration resulted in low recovery of NPs. The determination of most trace elements was then impossible; the concentration of elements was under the limit of detection of the analytical instrument. The sedimentation and CTFFF made it possible to determine quantifiable concentrations for both major and trace elements in separated fractions. However, the sedimentation took 48 h while CTFFF enabled the fractionation time to be decreased down to 2 h. Hence, CTFFF looked to be the most promising method for the separation of NPs followed by their quantitative elemental analysis.

Assessment of elemental composition and properties of copper smelter-affected dust and its nano- and micron size fractions

A comprehensive approach has been developed to the assessment of composition and properties of atmospherically deposited dust in the area affected by a copper smelter. The approach is based on the analysis of initial dust samples, dynamic leaching of water soluble fractions in a rotating coiled column (RCC) followed by the determination of recovered elements and characterization of size, morphology and elemental composition of nano-, submicron, and micron par ticles of dust separated using field-flow fractionation in a RCC. Three separated size fractions of dust (<0.2, 0.2-2, and >2 μm) were characterized by static light scattering and scanning electron microscopy, whereupon the fractions were analyzed by ICP-AES and ICP-MS (after digestion). It has been evaluated that toxic elements, which are characteristics for copper smelter emissions (As, Cu, Zn), are accumulated in fraction >2 μm. At the same time, up to 2.4, 3.1, 8.2, 6.7 g/kg of As, Cu, Zn, Pb, correspondently, were found in nanoparticles (<0.2 μm). It has been also shown that some trace elements (Sn, Sb, Ag, Bi, and Tl) are accumulated in fraction <0.2, and their content in this fraction may be one order of magnitude higher than that in the fraction >2 μm, or the bulk sample. It may be assumed that Sn, Sb, Ag, Bi, Tl compounds are adsorbed onto the finest dust particles as compared to As, Cu, Zn compounds, which are directly emitted from the copper smelter as microparticles.

A contribution of nanoscale particles of road-deposited sediments to the pollution of urban runoff by heavy metals

Road-deposited sediments (RDS) present a sink for traffic-related pollutants including heavy metals (HMs). HMs associated with RDS particles enter the urban aquatic environment during rainfall events and have adverse effects for biota. RDS nanoscale particles (NSPs) require special consideration due to their specific properties, extremely high mobility in the environment, and ability to penetrate into living organisms. In the present work, the contribution of NSPs of RDS to the pollution of urban runoff by HMs has been evaluated for the first time. It has been shown that bulk RDS samples are polluted by HMs as compared to background urban soils (geo-accumulation indexes of Cu and Zn may attain 2-3). Meanwhile, NSPs of RDS are enriched by HMs as compared to bulk samples; concentration factor for Ni, Cu, Zn, Cd, Sn, and Pb in NSPs being varied from 2 to 10. The water-soluble fractions of RDS samples were also analyzed. Results have shown that the content of water-soluble HMs in RDS is insignificant and rarely exceeds 0.5% of the total contents of HMs in the bulk samples; the highest contents are identified for Cu and Pb. It should be noted that the water-soluble fraction is nearly free from Zn and this element is almost entirely present as particulate matter (NSPs). In general, the overall contribution of NSPs and water-soluble fraction of HMs to the pollution of urban runoff is comparable.

Assessment of elemental composition and properties of copper smelter-affected dust and its nano- and micron size fractions

A comprehensive approach has been developed to the assessment of composition and properties of atmospherically deposited dust in the area affected by a copper smelter. The approach is based on the analysis of initial dust samples, dynamic leaching of water soluble fractions in a rotating coiled column (RCC) followed by the determination of recovered elements and characterization of size, morphology and elemental composition of nano-, submicron, and micron particles of dust separated using field-flow fractionation in a RCC. Three separated size fractions of dust (<0.2, 0.2-2, and >2 μm) were characterized by static light scattering and scanning electron microscopy, whereupon the fractions were analyzed by ICP-AES and ICP-MS (after digestion). It has been evaluated that toxic elements, which are characteristics for copper smelter emissions (As, Cu, Zn), are accumulated in fraction >2 μm. At the same time, up to 2.4, 3.1, 8.2, 6.7 g/kg of As, Cu, Zn, Pb, correspondently, were found in nanoparticles (<0.2 μm). It has been also shown that some trace elements (Sn, Sb, Ag, Bi, and Tl) are accumulated in fraction <0.2, and their content in this fraction may be one order of magnitude higher than that in the fraction >2 μm, or the bulk sample. It may be assumed that Sn, Sb, Ag, Bi, Tl compounds are adsorbed onto the finest dust particles as compared to As, Cu, Zn compounds, which are directly emitted from the copper smelter as microparticles.

Continuous-flow leaching in a rotating coiled column for studies on the mobility of toxic elements in dust samples collected near a metallurgic plant

Continuous-flow (dynamic) leaching in a rotating coiled column has been applied to studies on the mobility of Zn, Cd, Cu, Pb, Ni, Sb, As, S, and other potentially toxic elements in atmospherically deposited dust samples collected near a large copper smelter (Chelyabinsk region, Russia). Water and simulated "acid rain" (pH 4) were used as eluents. The technique enables not only the fast and efficient leaching of elements but as well time-resolved studies on the mobilization of heavy metals, sulphur, and arsenic in environmentally relevant forms to be made. It is shown that up to 1.5, 4.1, 1.9, 11.1, and 46.1% of Pb, As, Cu, Zn, and S, correspondingly, can be easily mobilized by water. Taking into consideration that the total concentrations of these elements in the samples under investigation are surprisingly high and vary in the range from 2.7 g/kg (for arsenic) to 15.5 g/kg (for sulphur), the environmental impact of the dust may be dramatic. The simulated acid rain results in somewhat higher recoveries of elements, except Cu and Pb. The proposed approach and the data obtained can very useful for the risk assessment related to the mobility of potentially toxic elements and their inclusion in the biogeochemical cycle.