Segmental inertial properties in dogs determined by magnetic resonance imaging

Data regarding the segmental inertial properties of the dog are currently unavailable, although such parameters are needed for dynamic analyses of canine motion. The purpose of this study was to measure the segmental inertial properties in three medium sized dogs of average build using magnetic resonance imaging. The parameters included the mass, location of centre of mass and moments of inertia for each body segment. The normalised results will serve as a preliminary foundation for various biomechanical studies in dogs, although further study is required to characterise them for specific dog breeds and to determine how they may be affected by age and gender.

Reproducibility and error sources of micro-MRI-based trabecular bone structural parameters of the distal radius and tibia

The mechanical competence of trabecular bone is significantly determined, next to material density, by its three-dimensional (3D) structure. Recent advances in micromagnetic resonance imaging (micro-MRI) acquisition and processing techniques allow the 3D trabecular structure to be analyzed in vivo at peripheral sites such as the distal radius and tibia. The practicality of micro-MRI-based noninvasive virtual bone biopsy (VBB) for longitudinal studies of patients hinges on the reproducibility of the derived structural parameters, which largely determine the size of the effect that can be detected at a given power and significance level. In this paper, the reproducibility of micro-MRI-derived trabecular bone structure measures was examined by performing repeat studies in six healthy subjects in whom the distal aspects of the radius and tibia were scanned with a 3D spin-echo sequence at 137 x 137 x 410 microm3 voxel size. Bone volume fraction (BV/TV) and digital topological analysis (DTA) structural parameters including the topological bone surface-to-curve ratio (SCR) and topological erosion index (TEI) were evaluated after subjecting the raw images to a cascade of processing steps. The average coefficient of variation was 4-7% and was comparable for the two anatomic sites and for all parameters measured. The reliability expressed in terms of the intraclass correlation coefficient ranged from 0.95 to 0.97 in the radius and 0.68 to 0.92 in the tibia. Error analysis based on simulations suggests involuntary patient motion, primarily rotation, to be the chief source of imprecision, followed by failure to accurately match the analysis volumes in repeat studies.

Digital topological analysis of in vivo magnetic resonance microimages of trabecular bone reveals structural implications of osteoporosis

Osteoporosis is a disease characterized by bone volume loss and architectural deterioration. The majority of work aimed at evaluating the structural implications of the disease has been performed based on stereologic analysis of histomorphometric sections. Only recently noninvasive imaging methods have emerged that provide sufficient resolution to resolve individual trabeculae. In this article, we apply digital topological analysis (DTA) to magnetic resonance microimages (mu-MRI) of the radius obtained at 137 x 137 x 350 microm3 voxel size in a cohort of 79 women of widely varying bone mineral density (BMD) and vertebral deformity status. DTA is a new method that allows unambiguous determination of the three-dimensional (3D) topology of each voxel in a trabecular bone network. The analysis involves generation of a bone volume fraction map, which is subjected to subvoxel processing to alleviate partial volume blurring, followed by thresholding and skeletonization. The skeletonized images contain only surfaces, profiles, curves, and their mutual junctions as the remnants of trabecular plates and rods after skeletonization. DTA parameters were compared with integral BMD in the lumbar spine and femur as well as MR-derived bone volume fraction (BV/TV). Vertebral deformities were determined based on sagittal MRIs of the spine with a semiautomatic method and the number of deformities counted after threshold setting. DTA structural indices were found the strongest discriminators of subjects with deformities from those without deformities. Subjects with deformities (n = 29) had lower topological surface (SURF) density (p < 0.0005) and surface-to-curve ratio (SCR; a measure of the ratio of platelike to rodlike trabeculae; p < 0.0005) than those without. Profile interior (PI) density, a measure of intact trabecular rods, was also lower in the deformity group (p < 0.0001). These data provide the first in vivo evidence for the structural implications inherent in postmenopausal osteoporosis accompanying bone loss, that is, the conversion of trabecular plates to rods and disruption of rods due to repeated osteoclastic resorption.

Topological analysis of trabecular bone MR images

Recently, imaging techniques have become available which permit nondestructive analysis of the three-dimensional (3-D) architecture of trabecular bone (TB), which forms a network of interconnected plates and rods. Most osteoporotic fractures occur at locations rich in TB, which has spurred the search for architectural parameters as determinants of bone strength. In this paper, we present a new approach to quantitative characterization of the 3-D microarchitecture of TB, based on digital topology. The method classifies each voxel of the 3-D structure based on the connectivity information of neighboring voxels. Following conversion of the 3-D digital image to a skeletonized surface representation containing only one-dimensional (1-D) and two-dimensional (2-D) structures, each voxel is classified as a curve, surface, or junction. The method has been validated by means of synthesized images and has subsequently been applied to TB images from the human wrist. The topological parameters were found to predict Young's modulus (YM) for uniaxial loading, specifically, the surface-to-curve ratio was found to be the single strongest predictor of YM (r2 = 0.69). Finally, the method has been applied to TB images from a group of patients showing very large variations in topological parameters that parallel much smaller changes in bone volume fraction (BVF).