Characterization of vibration and acoustic noise in a gradient-coil insert

High-speed switching of current in gradient coils within high magnetic field strength magnetic resonance imaging (MRI) scanners results in high acoustic sound pressure levels (SPL) in and around these machines. To characterize the vibration properties as well as the acoustic noise properties of the gradient coil, a finite-element (FE) model was developed using the dimensional design specifications of an available gradient-coil insert and the concentration of the copper windings in the coil. This FE model was then validated using experimentally collected vibration data. A computational acoustic noise model was then developed based on the validated FE model. The validation of the finite-element analysis results was done using experimental modal testing of the same gradient coil in a free-free state (no boundary constraints). Based on the validated FE model, boundary conditions (supports) were added to the model to simulate the operating condition when the gradient-coil insert is in place in an MRI machine. Vibration analysis results from the FE model were again validated through experimental vibration testing with the gradient-coil insert installed in the MRI scanner and excited using swept sinusoidal time waveforms. The simulation results from the computational acoustic noise model were also validated through experimental noise measurement from the gradient-coil insert in the MRI scanner using swept sinusoidal time waveform inputs. Comparisons show that the FE model predicts the vibration properties and the computational acoustic noise model predicts the noise characteristic properties extremely accurately.

Failure diagnosis of a type of hydraulic knee joint controller

The development of the hydraulic artificial knee joint controller has significantly improved the quality of life for many amputees. Even though the controller unit is very reliable, gradual deterioration inevitably takes place because the unit consists of many moving parts and is subjected to repetitive loads. This paper describes a simple method to test the reliability of hydraulic artificial knee joint controllers. A life cycle testing machine for artificial knee controllers was designed part of this programme. This study included life cycle testing of 5 knee controllers. Performance measurements representing the different degrees of deterioration were recorded and correlated against the actual deterioration found during refurbishment of the units. The results can be used (with care), together with simple tests, to judge performance of a given unit.

Gradient-induced acoustic and magnetic field fluctuations in a 4T whole-body MR imager

Both the acoustic and magnetic fluctuation frequency response functions for a Siemens AS25 body gradient coil inside a 4 Tesla whole-body MR system were measured and analyzed in this study. In an attempt to correlate the acoustic noise inside the gradient coil with magnetic field oscillations, triangular and trapezoidal gradient impulses of varying amplitudes and widths were used to excite the gradient coil. The acoustic and magnetic responses to these inputs were measured. The results show the existence of discrete resonances in both acoustic and uniform magnetic field fluctuation spectra, while gradient magnetic field fluctuation spectra show no such resonances. In addition, the dominant amplitude peaks in spectra fluctuate similarly with respect to trapezoidal gradient impulse flat-top widths. This implies that these phenomena are correlated, and that the trapezoidal impulse flat-top width may be used as a way to suppress both acoustic noise and uniform magnetic field oscillations.