Formation of Thick Dense Yttrium Iron Garnet Films Using Aerosol Deposition

Aerosol deposition (AD) is a thick-film deposition process that can produce layers up to several hundred micrometers thick with densities greater than 95% of the bulk. The primary advantage of AD is that the deposition takes place entirely at ambient temperature; thereby enabling film growth in material systems with disparate melting temperatures. This report describes in detail the processing steps for preparing the powder and for performing AD using the custom-built system. Representative characterization results are presented from scanning electron microscopy, profilometry, and ferromagnetic resonance for films grown in this system. As a representative overview of the capabilities of the system, focus is given to a sample produced following the described protocol and system setup. Results indicate that this system can successfully deposit 11 µm thick yttrium iron garnet films that are  > 90% of the bulk density during a single 5 min deposition run. A discussion of methods to afford better control of the aerosol and particle selection for improved thickness and roughness variations in the film is provided.

Technique for the dry transfer of epitaxial graphene onto arbitrary substrates

To make graphene technologically viable, the transfer of graphene films to substrates appropriate for specific applications is required. We demonstrate the dry transfer of epitaxial graphene (EG) from the C-face of 4H-SiC onto SiO(2), GaN and Al(2)O(3) substrates using a thermal release tape. Subsequent Hall effect measurements illustrated that minimal degradation in the carrier mobility was induced following the transfer process in lithographically patterned devices. Correspondingly, a large drop in the carrier concentration was observed following the transfer process, supporting the notion that a gradient in the carrier density is present in C-face EG, with lower values being observed in layers further removed from the SiC interface. X-ray photoemission spectra collected from EG films attached to the transfer tape revealed the presence of atomic Si within the EG layers, which may indicate the identity of the unknown intrinsic dopant in EG. Finally, this transfer process is shown to enable EG films amenable for use in device fabrication on arbitrary substrates and films that are deemed most beneficial to carrier transport, as flexible electronic devices or optically transparent contacts.

Gallium arsenide metal-semiconductor-metal photodiodes as optoelectronic mixers for microwave single-sideband modulation

Gallium arsenide (GaAs) metal-semiconductor-metal (MSM) photodetectors have unique properties including high-bandwidth, linearity, and biphase response that make them suitable as mixers and programmable weights for microwave and communications applications. An optical technique for microwave single-sideband modulation that uses GaAs MSM photodiodes as mixers is reported. It uses MSM Schottky photodiodes formed in a GaAs/Al(0.3)Ga(0.7)As materials system to detect microwave in-phase and quadrature signals on optical carriers. Modulation of the photodetector bias voltages results in a single-sideband modulation of the microwave signal. Radio frequency and undesired-sideband suppression of 36 and 27 dB, respectively, were achieved. The optical wavelength was 850 nm, and the bandwidth of the photodetectors was > or = 29 GHz.

Planar, Al0.3Ga0.7As-passivated-base, heterojunction bipolar phototransistors

New planar GaAs heterojunction bipolar phototransistors have been designed and demonstrated. The devices use a GaAs/Al(0.3)Ga(0.7) As molecular-beam-epitaxy materials system with an Al(0.3)Ga(0.7) As passivated, 10-nm-thick base; a depleted, high-low emitter; and a low emitter-base capacitance. Electrical contact to the emitter is made by a set of parallel, ohmic fingers and to the collector by an ohmic contact formed in a large, approximately 1.48-microm deep via. Rise times in response to impulse optical excitation at 810 nm were 747-891 ps except at the two lowest optical excitation powers measured. Photocurrent gains measured at 810 and 850 nm were 0.67-19, depending on experimental conditions. These devices are promising for use in heterodyne photodetector arrays for coherent optical processing channelizers requiring a 100-MHz bandwidth.