Zn-Doped Calcium Magnesium Phosphate Bone Cement Based on Struvite and Its Antibacterial Properties

The development of magnesium calcium phosphate bone cements (MCPCs) has garnered substantial attention. MCPCs are bioactive and biodegradable and have appropriate mechanical and antimicrobial properties for use in reconstructive surgery. In this study, the cement powders based on a (Ca + Mg)/P = 2 system doped with Zn²⁺ at 0.5 and 1.0 wt.% were obtained and investigated. After mixing with a cement liquid, the structural and phase composition, morphology, chemical structure, setting time, compressive strength, degradation behavior, solubility, antibacterial activities, and in vitro behavior of the cement materials were examined. A high compressive strength of 48 ± 5 MPa (mean ± SD) was achieved for the cement made from Zn²⁺ 1.0 wt.%-substituted powders. Zn²⁺ introduction led to antibacterial activity against Staphylococcus aureus and Escherichia coli strains, with an inhibition zone diameter of up to 8 mm. Biological assays confirmed that the developed cement is cytocompatible and promising as a potential bone substitute in reconstructive surgery.

Strontium Substituted β-Tricalcium Phosphate Ceramics: Physiochemical Properties and Cytocompatibility

Sr²⁺-substituted β-tricalcium phosphate (β-TCP) powders were synthesized using the mechano-chemical activation method with subsequent pressing and sintering to obtain ceramics. The concentration of Sr²⁺ in the samples was 0 (non-substituted TCP, as a reference), 3.33 (0.1SrTCP), and 16.67 (0.5SrTCP) mol.% with the expected Ca₃(PO₄)₂, Ca_2.9Sr_0.1(PO₄)₂, and Ca_2.5Sr_0.5(PO₄)₂ formulas, respectively. The chemical compositions were confirmed by the energy-dispersive X-ray spectrometry (EDX) and the inductively coupled plasma optical emission spectroscopy (ICP-OES) methods. The study of the phase composition of the synthesized powders and ceramics by the powder X-ray diffraction (PXRD) method revealed that β-TCP is the main phase in all compounds except 0.1SrTCP, in which the apatite (Ap)-type phase was predominant. TCP and 0.5SrTCP ceramics were soaked in the standard saline solution for 21 days, and the phase analysis revealed the partial dissolution of the initial β-TCP phase with the formation of the Ap-type phase and changes in the microstructure of the ceramics. The Sr²⁺ ion release from the ceramic was measured by the ICP-OES. The human osteosarcoma MG-63 cell line was used for viability, adhesion, spreading, and cytocompatibility studies. The results show that the introduction of Sr²⁺ ions into the β-TCP improved cell adhesion, proliferation, and cytocompatibility of the prepared samples. The obtained results provide a base for the application of the Sr²⁺-substituted ceramics in model experiments in vivo.

In Vitro Study of Octacalcium Phosphate Behavior in Different Model Solutions

Octacalcium phosphate (OCP), a new-generation bone substitute material, is a considered precursor of the biological bone apatite. The two-layered structure of OCP contains the apatitic and hydrated layers and is intensively involved in ion-exchange surface reactions, which results in OCP hydrolysis to hydroxyapatite and adsorption of ions or molecular groups presented in the environment. During various in vitro procedures, such as biomaterial solubility, additive release studies, or the functionalization technique, several model solutions are applied. The composition of the environmental solution affects the degree and rate of OCP hydrolysis, its surface reactivity, and further in vitro and in vivo properties. The performed study was aimed to track the structural changes of OCP-based materials while treating in the most popular model solutions of pH values 7.2-7.4: simulated body fluid (SBF), Dulbecco's phosphate-buffered saline (DPBS), supersaturated calcification solution (SCS), normal saline (NS), and Dulbecco's modified Eagle's medium (DMEM). Various degrees of OCP hydrolysis and/or precipitate formation were achieved through soaking initial OCP granules in the model solutions. Detailed data of X-ray diffraction, Fourier-transform infrared spectroscopy, atomic emission spectrometry with inductively coupled plasma, and scanning electron microscopy are presented. Cultivation of osteosarcoma cells was implemented on OCP pre-treated in DMEM for 1-28 days. It was shown that NS mostly degraded the OCP structure. DPBS slightly changed the OCP structure during the first treatment term, and during further terms, the crystals got thinner and OCP hydrolysis took place. Treatment in SBF and SCS caused the precipitate formation along with OCP hydrolysis, with a larger contribution of SCS solution to precipitation. Pre-treating in DMEM enhanced the cytocompatibility of materials. As a result, on performing the in vitro procedures, careful selection of the contact solution should be made to avoid the changes in materials structure and properties and get adequate results.

Mesoporous Iron(III)-Doped Hydroxyapatite Nanopowders Obtained via Iron Oxalate

Mesoporous hydroxyapatite (HA) and iron(III)-doped HA (Fe-HA) are attractive materials for biomedical, catalytic, and environmental applications. In the present study, the nanopowders of HA and Fe-HA with a specific surface area up to 194.5 m²/g were synthesized by a simple precipitation route using iron oxalate as a source of Fe³⁺ cations. The influence of Fe³⁺ amount on the phase composition, powders morphology, Brunauer–Emmett–Teller (BET) specific surface area (S), and pore size distribution were investigated, as well as electron paramagnetic resonance and Mössbauer spectroscopy analysis were performed. According to obtained data, the Fe³⁺ ions were incorporated in the HA lattice, and also amorphous Fe oxides were formed contributed to the gradual increase in the S and pore volume of the powders. The Density Functional Theory calculations supported these findings and revealed Fe³⁺ inclusion in the crystalline region with the hybridization among Fe-3d and O-2p orbitals and a partly covalent bond formation, whilst the inclusion of Fe oxides assumed crystallinity damage and rather occurred in amorphous regions of HA nanomaterial. In vitro tests based on the MG-63 cell line demonstrated that the introduction of Fe³⁺ does not cause cytotoxicity and led to the enhanced cytocompatibility of HA.

Analysis of Reparative Activity of Platelet Lysate: Effect on Cell Monolayer Recovery In Vitro and Skin Wound Healing In Vivo

Platelet lysate prepared from donor platelet concentrate and pooled according to a developed technique stimulates migration of multipotent mesenchymal stromal cells of the human adipose tissue and promotes healing of the monolayer defect in cultures of human fibroblasts and multipotent mesenchymal stromal cells in vitro in concentrations close those of fetal calf serum (5-10%). Lysate of platelets from platelet-rich rat blood plasma stimulated healing of the skin defect by promoting epithelialization and granulation tissue formation. The regenerative properties of platelet lysate in vivo increased with increasing its concentration.

Some Physical, Chemical, and Biological Parameters of Samples of Scleractinium Coral Aquaculture Skeleton Used for Reconstruction/Engineering of the Bone Tissue

Physical and chemical (phase and chemical composition, dynamics of resorption, and strength properties), and biological (cytological compatibility and scaffold properties of the surface) properties of samples of scleractinium coral skeletons from aquacultures of three types and corresponding samples of natural coral skeletons (Pocillopora verrucosa, Acropora formosa, and Acropora nobilis) were studied. Samples of scleractinium coral aquaculture skeleton of A. nobilis, A. formosa, and P. verrucosa met the requirements (all study parameters) to materials for osteoplasty and 3D-scaffolds for engineering of bone tissue.

Scleractinium coral aquaculture skeleton: a possible 3D scaffold for cell cultures and bone tissue engineering

Cytocompatibility of 5 coral aquaculture skeleton species derived from two families (Acroporidae and Pocilloporidae) was studied over the course of in vitro culturing in continuous human fibroblast culture by the MMT test. Biocompatibility and capacity of scaffold to "transfer" cell cultures (specifically, multipotent mesenchymal stromal cells) to sites of implantation were studied in vivo by subcutaneous implantation of skeletal fragments to rats. All coral skeleton aquaculture specimens were cytocompatible (nontoxic and with surface matrix characteristics satisfactory for cells), biocompatible, and could be tried as 3D matrices for bone tissue engineering.

Study of growth parameters and potentialities of differentiation of multipotent mesenchymal stromal cells from rat bone marrow in vitro

The dynamics of growth and proliferative activity of the population of multipotent mesenchymal stromal cells from rat bone marrow was studied during 7 passages. The efficiency of colony formation, the morphology of multipotent mesenchymal stromal cells, and the possibility of spontaneous and induced differentiation were studied. The rat bone marrow fibroblast-like multipotent mesenchymal stromal cells are capable of clonal growth; their proliferative activity and the yield remained high until passage 4, but then decreased. Induction of osteo- or adipogenic differentiation of bone marrow multipotent mesenchymal stromal cells increased the percentage of morphologically modified cells carrying specific markers.

[Tumor-associated antigen CA-125 in patients with ovarian cancer receiving various combinations of therapy]

A dynamic immuno-enzymatic assay of CA 125 was carried out in 43 patients (230 tests) with ovarian tumors receiving chemotherapy alone (group 1), surgery + adjuvant chemotherapy (group 2), or neoadjuvant chemotherapy + surgery + adjuvant chemotherapy (group 3). Mean concentration of CA 125 before treatment was 1,635.0 (362.8 Unit/ml. Direct correlation between number of cases with normal level and that of chemotherapy courses received was established in group 1. After 4-7 courses, the antigen level came back to normal in 80.0%. However, chemotherapy alone failed to bring the marker concentration down below 5.0 Unit/ml, which is believed to promise favorable prognosis. In group 2, CA 125 came back to normal after adjuvant chemotherapy in all patients. The best results in that group were obtained following 3 courses: 5.0 Unit/ml--41.7%, and < 10.0 Unit/ml--75%. Additional 1-3 courses failed to improve the results. Normal concentration was reported after first-line adjuvant chemotherapy in 63.6-75.0% in group 3. The best results after a second course of adjuvant chemotherapy were: > 5.0 Unit/ml--12.5%, and > 10.0 Unit/ml--56.3%.