Engineering Cathode-Electrolyte Interface of High-Voltage Spinel LiNi0.5Mn1.5O4 via Halide Solid-State Electrolyte Coating

The high-voltage spinel LiNi0.5Mn1.5O4 (LNMO) cathode material with high energy density, low cost, and excellent rate capability has grabbed the attention of the field. However, a high-voltage platform at 4.7 V causes severe oxidative side reactions when in contact with the organic electrolyte, leading to poor electrochemical performance. Furthermore, the contact between the liquid electrolyte and LNMO leads to Mn dissolution during cycles. In this work, we applied the sol-gel method to prepare Li3InCl6-coated LNMO (LIC@LNMO) to address the mentioned problems of LNMO. By introducing a protective layer of halide-type solid-state electrolyte on LNMO, we can prevent direct contact between LNMO and electrolyte while maintaining good ionic conductivity. Thus, we could demonstrate that 5 wt % LIC@LNMO exhibited a good cycle performance with a Coulombic efficiency of 99% and a capacity retention of 80% after the 230th cycle at the 230th cycle at 1C at room temperature.

Biocomposites Based on Poly(3-Hydroxybutyrate-co-3-Hydroxyvalerate) (PHBHV) and Miscanthus giganteus Fibers with Improved Fiber/Matrix Interface

In this paper, green biocomposites based on poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBHV) and Miscanthus giganteus fibers (MIS) were prepared in the presence of dicumyl peroxide (DCP) via reactive extrusion. The objective of this study was to optimize the interfacial adhesion between the reinforcement and the matrix, improving the mechanical properties of the final material. To this aim, two fibers mass fractions (5 and 20 wt %) and two different fiber sizes obtained by two opening mesh sieves (1 mm and 45 μm) were investigated. The impregnation of fibers with DCP before processing was carried out in order to promote the PHBHV grafting onto MIS fibers during the process, favoring, in this way, the interfacial adhesion between fibers and matrix, instead of the crosslinking of the matrix. All composites were realized by extrusion and injection molding processing and then characterized by tensile tests, FTIR-ATR, SEM, DSC and XRD. According to the improved adhesion of fibers to matrix due to DCP, we carried out an implementation of models involving that can predict the effective mechanical properties of the biocomposites. Three phases were taken into account here: fibers, gel (crosslinked matrix), and matrix fractions. Due to the complexity of the system (matrix–crosslinked matrix–fibers) and to the lack of knowledge about all the phenomena occurring during the reactive extrusion, a mathematical approach was considered in order to obtain information about the modulus of the crosslinked matrix and its fraction in the composites. This study aims to estimate these last values, and to clarify the effect caused by the presence of vegetal fibers in a composite in which different reactions are promoted by DCP.