Metallorganic routes to nanoscale iron and titanium oxide particles encapsulated in mesoporous alumina: formation, physical properties, and chemical reactivity

Structurally Dependent Electrochemical Properties of Ultrafine Superparamagnetic 'Core/Shell' γ-Fe2O3/Defective α-Fe2O3 Composites in Hybrid Supercapacitors

The paper presents a method for obtaining electrochemically active ultrafine composites of iron oxides, superparamagnetic ‘core/shell’ γ-Fe₂O₃/defective α-Fe₂O₃, which involved modifying sol-gel citrate synthesis, hydrothermal treatment of the formed sol, and subsequent annealing of materials in the air. The synthesized materials’ phase composition, magnetic microstructure, and structural, morphological characteristics have been determined via X-ray analysis, Mossbauer spectroscopy, scanning electron microscopy (SEM), and adsorption porometry. The mechanisms of phase stability were analyzed, and the model was suggested as FeOOH → γ-Fe₂O₃ → α-Fe₂O₃. It was found that the presence of chelating agents in hydrothermal synthesis encapsulated the nucleus of the new phase in the reactor and interfered with the direct processes of recrystallization of the structure with the subsequent formation of the α-Fe₂O₃ crystalline phase. Additionally, the conductive properties of the synthesized materials were determined by impedance spectroscopy. The electrochemical activity of the synthesized materials was evaluated by the method of cyclic voltammetry using a three-electrode cell in a 3.5 M aqueous solution of KOH. For the ultrafine superparamagnetic ‘core/shell’ γ-Fe₂O₃/defective α-Fe₂O composite with defective hematite structure and the presence of ultra-dispersed maghemite with particles in the superparamagnetic state was fixed increased electrochemical activity, and specific discharge capacity of the material is 177 F/g with a Coulomb efficiency of 85%. The prototypes of hybrid supercapacitor with work electrodes based on ultrafine composites superparamagnetic ‘core/shell’ γ-Fe₂O₃/defective α-Fe₂O₃ have a specific discharge capacity of 124 F/g with a Coulomb efficiency of 93% for current 10 mA.

Immobilized glucose oxidase on magnetic silica and alumina: Beyond magnetic separation

Here we report immobilization of glucose oxidase (GOx) on magnetic silica (Fe₃O₄-SiO₂) and alumina (Fe₃O₄-Al₂O₃) functionalized with amino groups using glutaraldehyde as a linker. Magnetic support based biocatalysts demonstrate high catalytic activity in d-glucose oxidation to D-gluconic acid at pH 5-7.5 and temperature of 30-50 °C with the best activities of 95% and 91% for magnetic silica and alumina, respectively. A comparison of magnetic and non-magnetic alumina and silica shows a significant enhancement of the relative catalytic activity for magnetic supports, while the silica based biocatalysts show a higher activity than the biocatalysts based on alumina. A noticeably higher activity of GOx immobilized on magnetic supports is explained by synergy of the GOx inherent activity and enzyme-like activity of iron oxide nanoparticles, while the enhancement with silica based catalysts is most likely due to a larger pore size and stronger Brønsted acid sites. Excellent relative activity of Fe₃O₄-SiO₂-GOx (95% of native GOx) in a tolerant pH and temperature range as well as high stability in a repeated use (6% relative activity loss after five catalytic cycles) makes this catalyst promising for practical applications.

Facile Solventless Synthesis of a Nylon-6,6/Silver Nanoparticles Composite and Its XPS Study

Silver nanoparticles were synthesized and supported on thin nylon membranes by means of a simple method of impregnation and chemical reduction of Ag ions at ambient conditions. Particles of less than 10 nm were obtained using this methodology, in which the nylon fibers behave as constrained nanoreactors. Pores on nylon fibres along with oxygen and nitrogen from amide moieties in nylon provide effective sites forin situreduction of silver ions and for the formation and stabilization of Ag nanoparticles. Transmission electron microscopy (TEM) analysis showed that silver nanoparticles are well dispersed throughout the nylon fibers. Furthermore, an interaction between nitrogen of amides moieties of nylon-6,6 and silver nanoparticles has been found by X-ray photoelectron spectroscopy (XPS).

A 3D monolithic CNT block structure as a reductant, support and scavenger for nanoscopic gold, platinum and zinc oxide

ZnO (8-10 nm), gold (10-50 nm), and platinum (2-5 nm) nanoparticles were deposited on monoliths of regularly arranged three-dimensional (3D) carbon nanotubes of 40 nm diameter and length up to 30 microm. The single-source precursor complex di-aqua-bis[2-(methoxyimino)propanato](2)Zn(ii) in dimethylformamide was used for the deposition of nanoparticulate ZnO on an ordered 3D CNT scaffold by solution-phase deposition at temperatures as low as 150 degrees C. Au and Pt nanoparticles were deposited by the spontaneous reduction of aqueous solutions of HAuCl(4) and K(2)PtCl(4) on the surface of the macroscopic 3D CNT scaffolds. X-Ray diffraction (XRD) and transmission electron microscopy (TEM) indicate the crystalline nature and nanosize structure of the deposited ZnO, Au and Pt nanoparticles. Scanning electron microscopy (SEM) and transmission electron microscopy (TEM) investigations revealed a dense and homogeneous decoration of the individual CNTs throughout the 3D CNT scaffold structure. Thus the nanovoids of the carbon scaffold structure are therefore completely accessible leading to a homogenous particle deposition on the complete CNT outer surface. The kinetics of the spontaneous reduction of gold(iii) and platinum(ii) ions on the CNTs of the scaffold was followed by UV-vis spectroscopy and indicate (i) first-order reaction kinetics with respect to Au(3+) and Pt(2+) concentration and (ii) that the rate of reduction of Au(3+) is one order of magnitude slower than that of Pt(2+).

Vertically oriented Ti-Fe-O nanotube array films: toward a useful material architecture for solar spectrum water photoelectrolysis

In an effort to obtain a material architecture suitable for high-efficiency visible spectrum water photoelectrolysis, herein we report on the fabrication and visible spectrum (380-650 nm) photoelectrochemical properties of self-aligned, vertically oriented Ti-Fe-O nanotube array films. Ti-Fe metal films of variable composition, iron content ranging from 69% to 3.5%, co-sputtered onto FTO-coated glass are anodized in an ethylene glycol + NH4F electrolyte. The resulting amorphous samples are annealed in oxygen at 500 degrees C, resulting in nanotubes composed of a mixed Ti-Fe-O oxide. Some of the iron goes into the titanium lattice substituting titanium ions, and the rest either forms alpha-Fe2O3 crystallites or remains in the amorphous state. Depending upon the Fe content, the band gap of the resulting films ranges from about 380 to 570 nm. The Ti-Fe oxide nanotube array films are utilized in solar spectrum water photoelectrolysis, demonstrating 2 mA/cm2 under AM 1.5 illumination with a sustained, time-energy normalized hydrogen evolution rate by water splitting of 7.1 mL/W.hr in a 1 M KOH solution with a platinum counter electrode under an applied bias of 0.7 V. The surface morphology, structure, elemental analysis, optical, and photoelectrochemical properties of the Ti-Fe oxide nanotube array films are considered.