High Quantum Efficiency AlGaN/GaN Solar-Blind Photodetectors Grown by Metalorganic Chemical Vapor Deposition

High-Performance Solar-Blind AlGaN Schottky Photodiodes

High-performance solar-blind AlGaN-based Schottky photodiodes have been demonstrated. The detectors were fabricated on MOCVD-grown AlGaN/GaN hetero-structures using a microwave-compatible fabrication process. Current-voltage, spectral responsivity, noise, and high-speed characteristics of the detectors were measured and analyzed. Dark currents lower than 1 pA at bias voltages as high as 30 V were obtained. True solar-blind detection was achieved with a cut-off wavelength lower than 266 nm. A peak device responsivity of 78 mA/W at 250 nm was measured under 15 V reverse bias. A visible rejection of more than 4 orders of magnitude was observed. The solar-blind photodiodes exhibited noise densities below the measurement setup noise floor of 3×10−29 A2/Hz around 10 KHz. High-speed measurements at the solar-blind wavelength of 267 nm resulted in 3-dB bandwidths as high as 870 MHz.

A comprehensive review of semiconductor ultraviolet photodetectors: from thin film to one-dimensional nanostructures

Ultraviolet (UV) photodetectors have drawn extensive attention owing to their applications in industrial, environmental and even biological fields. Compared to UV-enhanced Si photodetectors, a new generation of wide bandgap semiconductors, such as (Al, In) GaN, diamond, and SiC, have the advantages of high responsivity, high thermal stability, robust radiation hardness and high response speed. On the other hand, one-dimensional (1D) nanostructure semiconductors with a wide bandgap, such as β-Ga2O3, GaN, ZnO, or other metal-oxide nanostructures, also show their potential for high-efficiency UV photodetection. In some cases such as flame detection, high-temperature thermally stable detectors with high performance are required. This article provides a comprehensive review on the state-of-the-art research activities in the UV photodetection field, including not only semiconductor thin films, but also 1D nanostructured materials, which are attracting more and more attention in the detection field. A special focus is given on the thermal stability of the developed devices, which is one of the key characteristics for the real applications.