Superporous collagen-sericin scaffolds

Towards a sustainable chitosan-based composite scaffold derived from Scylla serrata crab chitosan for bone tissue engineering

Bone tissue engineering offers a novel therapy for repairing bone defects or fractures. However, it is becoming increasingly challenging because an ideal scaffold should possess a similar porous structure, high biocompatibility, and mechanical properties that match those of natural bone. To fabricate such a scaffold, biodegradable polymers are often preferred due to their degradability and tailored structure. This study involved the isolation of chitosan from crab shells (Scylla serrata) waste to use as a biomaterial in combination with hydroxyapatite (HAP) and collagen I (COL I) to mimic the extracellular matrix (ECM) composition of bone. After being cast and freeze-dried, it resulted in an interconnected porous scaffold with a porosity of 51.44% ± 2.28% and a pore diameter of 109.88 μm ± 49.84 μm. The swelling ratio of the crab scaffold was measured at 358.31% ± 25.23%, 363.04% ± 1.56%, and 370.11% ± 3.7% at 1, 3, and 6 h, respectively. Consequently, the scaffold exhibited a degradation ratio of 8.17% ± 2.59%, 21.62% ± 5.43%, 22.59% ± 14.23%, and 23.12% ± 6.28% over the course of 1 to 4 weeks. It demonstrated excellent biocompatibility with MG-63 osteosarcoma cells. Although the compression strength was lower than 2-12 MPa, the crab scaffold can still be applied effectively for non-load-bearing bone defects. Crab shell waste emerges as a promising source of chitosan for tissue engineering applications.

Silk-based microcarriers: current developments and future perspectives

Cell-seeded microcarriers (MCs) are currently one of the most promising topics in biotechnology. These systems are supportive structures for cell growth and expansion that allow efficient nutrient and gas transfer between the media and the attached cells. Silk proteins have been increasingly used for this purpose in the past few years due to their biocompatibility, biodegradability and non-toxicity. To date, several silk fibroin spherical MCs in combination with alginate, gelatin and calcium phosphates have been reported with very interesting outcomes. In addition, other silk-based three-dimensional structures such as microparticles with chitosan and collagen, as well as organoids, have been increasingly studied. In this study, the physicochemical and biological properties of these biomaterials, as well as the recent methodologies for their processing and for cell culture, are discussed. The potential biomedical applications are also addressed. In addition, an analysis of the future perspectives is presented, where the potential of innovative silk-based MCs processing technologies is highlighted.

3 D nano bilayered spatially and functionally graded scaffold impregnated bromelain conjugated magnesium doped hydroxyapatite nanoparticle for periodontal regeneration

Chronic periodontal disease affect the tissues supporting around the teeth like gingival tissue, connective tissue, alveolar bone and periodontal ligaments. Hitherto, periodontal treatment was targeted to selectively repopulate the defect site with cell that has capability to regenerate lost tissue by promoting the concept of guided tissue regeneration but it requires second surgery due to non- biodegradability. The use of polymeric biodegradable nanofibrous coated scaffold that have the ability to deliver bioactives required for regeneration to occur is relatively a newer concept. The functionalization of polymeric scaffold with Bromelain and magnesium doped hydroxyapatite nanoparticle enhanced the mechanical, physico-chemical, thermal and biological properties of the scaffold by imitating the intricate extracellular matrix (ECM) architecture which provided the necessary bioactive cues that offered control over cellular functions by showing antibacterial potential, hemocompatibility and increasing the proliferation and migration rate in vitro. In addition, in ovo chicken chorioallantoic membrane assay and ex vivo aortic ring assay confirmed the efficacy of the developed scaffold by encouraging angiogenesis required for maintaining its viability after implanting onto the infected area. Further, the scaffold positively interacted with the host and actively contributed to the process of tissue regeneration in vivo in Wistar rat model.

Efficiency of Multiparticulate Delivery Systems Loaded with Flufenamic Acid Designed for Burn Wound Healing Applications

Burns are soft tissue injuries that require particular care for wound healing. Current tissue engineering approaches are aimed at identifying the most efficient treatment combinations to restore the tissue properties and function by using adapted scaffolds or delivery platforms for tissue repair and regeneration by triggering molecules. To reduce the inflammation associated with skin burns, the addition of an anti-inflammatory factor in these scaffolds would greatly increase the quality of the therapy. Therefore, this study is aimed at obtaining and validating a novel multiparticulate system based on a collagen matrix with controlled delivery of flufenamic acid anti-inflammatory drug for burn wound healing applications. In this work, we have characterized the properties and biocompatibility of these multiparticulate drug delivery systems (MDDS) and we have demonstrated their efficiency against burns and soft tissue lesions, particularly when the drug was microencapsulated, and thus with a controlled release. This study contributes to the advancement in therapy of burns and burn wound healing applications.

Effect of molecular weight on the structure and mechanical properties of silk sericin gel, film, and sponge

In this study, the effect of the MW on the structure and properties of sericin film, sponge, and gel was examined. As the MW of sericin increased, the gelation of the sericin aqueous solution was found to be accelerated, and the gel strength, and the gel-sol transition temperature increased. Irrespective of the casting solvent (water and formic acid) and form of sericin (gel, film, or sponge), the crystallization of the sericins was accelerated. The mechanical properties of the sericin sponge were remarkably improved upon increasing the MW of sericin. The MW of sericin almost did not have an effect on the cell toxicity. As the MW of sericin is increased, the sericin sponge becomes denser and its porosity is reduced, leading to a decrease in the swelling ratio. These results indicate that various characteristics of the sericin forms can be modulated by controlling the MW of sericin, with enhanced potential for biomedical and cosmetic applications.

New strategy for design and fabrication of polymer hydrogel with tunable porosity as artificial corneal skirt

In order to obtain an ideal material using for artificial corneal skirt, a porous polymer hydrogel containing 2-hydroxyethyl methacrylate (HEMA), trimethylolpropane triacrylate (TMPTA) and butyl acrylate was prepared through one-step radical polymerization method and the usage of CaCO₃ whisker as porogen. The physical-chemical properties of the fabricated polymer hydrogel can be adjusted by CaCO₃ whisker content, such as pore size, porosity, water content of materials and surface topography. Then a series of cell biology experiments of human corneal fibroblasts (HCFs) were carried out to evaluate its properties as an artificial corneal skirt, such as the adhesion of cells on the materials with different pore size and porosity, the apoptosis on materials with different characteristics, the distribution of the cells on the material surface. The results revealed that high porosity not only could improve water content of hydrogel, but also strengthen the adhesion of HCFs on hydrogel. In addition, high porosity hydrogel with the whisker shape of pores showed much elongate spindle-like morphology than those low porosity hydrogels. MTT assay certified that the resulted polymer hydrogel material possessed excellent biocompatibility and was suitable for HCFs growing, making it promising for being developed as artificial corneal skirt.

Rheological study of in-situ crosslinkable hydrogels based on hyaluronanic acid, collagen and sericin

The elaboration of chemically crosslinked hydrogels based on collagen (C), hyaluronanic acid (HA) and sericin (S) with different polymer ratios was investigated by in-situ rheology. This reaction was performed via amide or ester bond reaction activated by carbodiimide, in pure water. Prior to molecule crosslinking, the rheological behaviour of the biopolymers (alone or in mixture) was characterized in a semi-dilute concentration regime. Both flow and dynamic measurements showed that uncrosslinked collagen alone appears to be rather elastic with yield stress properties, whereas uncrosslinked HA alone appears to be rather shear thinning and viscoelastic in agreement with entangled polymer behaviour. Sericin exhibited Newtonian low viscosity behaviour according to its very low molar mass. Before crosslinking, HA exhibited viscoelastic behaviour at concentrations above the critical entangled concentration (C*) in the mixtures, thus HA shows promise as a matrix for future crosslinked networks, whereas sericin did not significantly modify the rheology. During the reaction, followed by rheology, the kinetics were slower for pure HA systems compared with the mixtures (i.e., with added collagen and/or to a lesser extent sericin). At the same time, the final network of hydrogels (i.e., the elastic modulus) was more structured in the mixture based systems. This result is explained by ester bonds (the only possibility for pure HA systems), which are less favourable and reactive than amide bonds (possible with sericin and collagen). The presence of collagen in the HA matrix reinforced the hydrogel network. SEM studies confirmed the structure of the hydrogels, and in vitro degradability was globally consistent with the effect of the selected enzyme according to the hydrogel composition. All the elaborated hydrogels were non-cytotoxic in vitro.

Crosslinked hydrogels based on biological macromolecules with potential use in skin tissue engineering

Zero-length crosslinked hydrogels have been synthesized by covalent linking of three natural polymers (collagen, hyaluronic acid and sericin), in the presence of 1-ethyl-3-(3-dimethylaminopropyl) carbodiimide and N-hydroxysuccinimide. The hydrogels have been investigated by FT-IR spectroscopy, microcalorimetry, in vitro swelling, enzymatic degradation, and in vitro cell viability studies. The obtained crosslinked hydrogels showed a macroporous structure, high swelling degree and in vitro enzymatic resistance compared to uncrosslinked collagen. The in vitro cell viability studies performed on normal human dermal fibroblasts assessed the sericin proliferation properties indicating a potential use of the hydrogels based on collagen, hyaluronic acid and sericin in skin tissue engineering.

A 3D Porous Gelatin-Alginate-Based-IPN Acts as an Efficient Promoter of Chondrogenesis from Human Adipose-Derived Stem Cells

Cartilage has limited regeneration potential. Thus, there is an imperative need to develop new strategies for cartilage tissue engineering (CTE) amenable for clinical use. Recent CTE approaches rely on optimal cell-scaffold interactions, which require a great deal of optimization. In this study we attempt to build a novel gelatin- (G-) alginate- (A-) polyacrylamide (PAA) 3D interpenetrating network (IPN) with superior performance in promoting chondrogenesis from human adipose-derived stem cells (hADSCs). We show that our G-A-PAA scaffold is capable of supporting hADSCs proliferation and survival, with no apparent cytotoxic effect. Moreover, we find that after exposure to prochondrogenic conditions a key transcription factor known to induce chondrogenesis, namely, Sox9, is highly expressed in our hADSCs/G-A-PAA bioconstruct, along with cartilage specific markers such as collagen type II, CEP68, and COMP extracellular matrix (ECM) components. These data suggest that our G-A-PAA structural properties and formulation might enable hADSCs conversion towards functional chondrocytes. We conclude that our novel G-A-PAA biomatrix is a good candidate for prospective in vivo CTE applications.

Preparation and evaluation of a novel pADM-derived micro- and nano electrospun collagen membrane

A novel pADM-derived micro- and nano electrospun collagen membrane (PDEC) was successfully prepared by the electrospinning technique.

Modification of collagen with a natural derived cross-linker, alginate dialdehyde

The interaction between collagen and a natural derived cross-linker alginate dialdehyde (ADA) was investigated. Fourier transform infrared (FTIR) spectroscopy and the circular dichroism (CD) measurements indicate that the structure integrity of collagen is still maintained after the ADA treatment, while the differential scanning calorimetry (DSC) study suggests that ADA could promote collagen-ADA membrane's thermostability compared to pure collagen. And the atomic force microscopy (AFM) of cross-linked collagen reveals a denser network structure. Besides, the water contact angle test indicates that the hydrophilic property of collagen-ADA membrane is promoted, which is favorable for cell's attachment and proliferation. Meanwhile, the cytocompatibility results imply that not only no extra cytotoxicity is introduced into the collagen-ADA membrane after ADA treatment, but also collagen-ADA membrane facilitates cell's proliferation when the content of ADA is less than 20%. In conclusion, our study reveals that ADA stabilizes collagen as a cross-linker and preserves its triple helical structure.

Biocompatibility assessment of novel collagen-sericin scaffolds improved with hyaluronic Acid and chondroitin sulfate for cartilage regeneration

Cartilage tissue engineering (CTE) applications are focused towards the use of implantable biohybrids consisting of biodegradable scaffolds combined with in vitro cultured cells. Hyaluronic acid (HA) and chondroitin sulfate (CS) were identified as the most potent prochondrogenic factors used to design new biomaterials for CTE, while human adipose-derived stem cells (ASCs) were proved to display high chondrogenic potential. In this context, our aim was not only to build novel 3D porous scaffolds based on natural compounds but also to evaluate their in vitro biological performances. Therefore, for prospective CTE, collagen-sericin (Coll-SS) scaffolds improved with HA (5% or 10%) and CS (5% or 10%) were used as temporary physical supports for ASCs and were analyzed in terms of structural, thermal, morphological, and swelling properties and cytotoxic potential. To complete biocompatibility data, ASCs viability and proliferation potential were also assessed. Our studies revealed that Coll-SS hydrogels improved with 10% HA and 5% CS displayed the best biological performances in terms of cell viability, proliferation, morphology, and distribution. Thus, further work will address a novel 3D system including both HA 10% and CS 5% glycoproteins, which will probably be exposed to prochondrogenic conditions in order to assess its potential use in CTE applications.

Sericin enhances the bioperformance of collagen-based matrices preseeded with human-adipose derived stem cells (hADSCs)

Current clinical strategies for adipose tissue engineering (ATE), including autologous fat implants or the use of synthetic surrogates, not only are failing in the long term, but also can't face the latest requirements regarding the aesthetic restoration of the resulted imperfections. In this context, modern strategies in current ATE applications are based on the implantation of 3D cell-scaffold bioconstructs, designed for prospective achievement of in situ functional de novo tissue. Thus, in this paper, we reported for the first time the evaluation of a spongious 60% collagen and 40% sericin scaffold preseeded with human adipose-derived stem cells (hADSCs) in terms of biocompatibility and adipogenic potential in vitro. We showed that the addition of the sticky protein sericin in the composition of a classical collagen sponge enhanced the adhesion and also the proliferation rate of the seeded cells, thus improving the biocompatibility of the novel scaffold. In addition, sericin stimulated PPARγ2 overexpression, triggering a subsequent upregulated expression profile of FAS, aP2 and perilipin adipogenic markers. These features, together with the already known sericin stimulatory potential on cellular collagen production, promote collagen-sericin biomatrix as a good candidate for soft tissue reconstruction and wound healing applications.