Controllable synthesis of cellulose/methylene bisacrylamide aerogels for enhanced adsorption performance

Natural microfibrils/regenerated cellulose-based carbon aerogel for highly efficient oil/water separation

Cellulose-based carbon aerogels as biodegradable and renewable biomass materials have presented potential applications in oil/water separation. Herein, a novel carbon aerogel composed of natural microfibrils/regenerated cellulose (NM/RCA) was directly prepared by economical hardwood pulp as raw material using a novel co-solvent composed of deep eutectic solvent (DES) and N-methyl morpholine-N-oxide monohydrate (NMMO·H₂O). In addition, the morphology and structure of the filiform natural microfibers could be remained after carbonized at 400 ℃, which resulted in a low density (8-10 mg cm^-3), high specific surface area (768.89 m² g^-1) and high sorption capability. In addition, the aerogel exhibited high compressibility, outstanding elasticity, excellent fatigue resistance, and recyclability (80.5% height recovery after repeating 100 cycles at the strain of 80%). Due to the morphology and composition of the carbonized microfiber surface, the superhydrophobic materials with a water contact angle of 151.5°, could sorb various oils and organic solvents with 65-133 times its own weight and maintain 91.9% sorption capacity after 25 cycles. In addition, the aerogels could achieve the continuous separation of carbon tetrachloride (CCl₄) from water with a high flux rate of 11,718.8 L m^-2 h^-1. Therefore, our prepared NM/RCA aerogels are anticipated to have broad potential applications in oil purification and contaminant remediation.

A facile approach to cellulose/multi-walled carbon nanotube gels-Structure, formation process and adsorption to methylene blue

In view of the deficiencies in the preparation of cellulose gels, such as, cumbersome process, harsh conditions, high consumption of chemicals, secondary pollution caused by side reactions, this work reports a facile approach to make cellulose/multi-walled carbon nanotube (MWCNTs) hydrogels and aerogels via mixing cellulose with N,N'-methylene bisacrylamide (MBA) and MWCNTs in NaOH/urea/H₂O aqueous solution. The gels were revealed to be formed by an addition reaction between the double bonds of MBA and the hydroxyl groups of cellulose and the intermolecular interactions between cellulose and MWCNTs. The preparation process can be realized at room temperature and atmospheric pressure without the intervention of ultrasonic dispersion, catalyst and initiator. The gelation time, puncture strength and water retention ability of the hydrogels were investigated. Results showed that, compared with pure cellulose hydrogel, cellulose/MWNCTs hydrogels have obviously shorter sol-gel transition time (124-129.2 min), higher puncture strength (29.6022-34.2854 KPa) and water retention ability (274.2619-301.7291 g/g). Cellulose/MWCNTs aerogels possessed three dimensional network with macroporous structure (about 500 μm), low density (0.00546-0.00557 g/cm³), high porosity (99.6360-99.6426 %), good thermal stability (242 °C) and certain absorbency to methylene blue (233.2901-242.1122 mg/g).