Skimmed-milk blocking improves silver post-intensification of peroxidase-diaminobenzidine staining on nitrocellulose membrane in immunoblotting

Comparison of blocking reagents for antibody microarray-based immunoassays on glass and paper membrane substrates

Background noise due to nonspecific binding of biomolecules on the assay substrates is one of the most common challenges that limits the sensitivity of microarray-based immunoassays. Background signal intensity usually increases when complex biological fluids are used because they have a combination of molecules and vesicles that can adsorb onto substrate surfaces. Blocking strategies coupled with surface chemistries can reduce such nonspecific binding and improve assay sensitivity. In this paper, we conducted a systematic optimization of blocking strategies on a variety of commonly used substrates for protein measurement in complex biofluids. Four blocking strategies (BSA, non-fat milk, PEG, and a protein-free solution) coupled with four surface chemistries (3-glycidoxypropyltrimethoxysilane (GPS), poly-L-lysine (PLL), aminoalkylsilane (AAS), and nitrocellulose (NC)) were studied for their effect on background, microspot, and net signal intensities. We have also explored the effect that these blocking strategies have when proteins in complex samples (plasma, serum, cell culture media, and EV lysate) are measured. Irregular spot morphology could affect signal extraction using automated software. We found that the microspots with the best morphology were the ones printed on GPS glass surfaces for all immunoassays. On NC membrane, the protein-based blocking strategies yielded the highest net fluorescent intensity with the antigen contained in PBS, plasma, serum, and serum-free cell culture media. Differently, with EV lysate samples, Pierce™ protein-free blocker yielded the best net signal intensity on both GPS and NC surfaces. The choice of blocking strategies highly depends on the substrate. Moreover, the findings discovered in this study are not limited to microarray-based immunoassays but can provide insights for other assay formats.

Physicochemical mechanisms of histological silver staining and their utilization for rendering individual silver methods selective and reliable

Staining morphological or chemical constituents of biological tissues, cells and microorganisms with silver proceeds via different reaction routes. In this paper, I put their physicochemical mechanisms into a coherent system and discuss how these can be controlled and separated from each other, thereby permitting selective, sensitive and reliable demonstration of individual tissue constituents.

Substance P released from sensory nerve endings influences tear secretion and goblet cell function in the rat

The aim of this study was to present morphological and functional evidence to evaluate whether tear secretion is influenced by neuropeptides released from sensory nerve endings of the conjunctiva. Following unilateral electrical stimulation of the trigeminal ganglion, tears were collected at both sides and assessed for volume and protein concentration; as well as gel electrophoresis and luminol chemiluminescence with immunostaining to immunoglobulin A and lysozyme measurements. Goblet cell density (goblet cells/100 basal cells) was recorded during histopathological examination of removed lids. Rats were pretreated with atropine to block parasympathetic; guanethidine to block sympathetic neuronal pathways; or hexamethonium to block synaptic transmission in ganglia. Capsaicin was used to deplete neurotransmitters from sensory nerve endings or SR140333 to block substance P tachykinin NK1 receptor mediated responses. Effects of inadequate electrode position or incidental lesion of trigeminal ganglion were examined by placing the electrode in false position, or no stimulation at a correct position. Electrical stimulation resulted in 380% increase of tear secretion (p < 0.001) and 30% decrease of goblet cell density (p < 0.001) on the the stimulated side compared to the unstimulated side. Atropine, guanethidine and hexamethonium pretreatments had no effect (p > 0.05), but capsaicin and SR140333 inhibited the effect of stimulation (by 96% and 72%, respectively, p < 0.001). Inadequate stimulation did not increase the tear secretion (p < 0.05). Protein concentration decreased, whilst tear volume and total secreted protein increased (p < 0.005) after stimulation. Electrophoresis showed no difference in protein pattern between stimulated and control side and analysis of equivalent amount of tear protein with luminol chemiluminescence indicated no difference in immunoglobulin A and lysozyme ratio following stimulation (p>0.05). We conclude that antidromic electrical activation of conjunctival sensory nerve endings significantly increases water, mucus and protein phases of tear. It is suggested that the sensory neuropeptide substance P plays a pivotal role in this neurogenic regulatory mechanism.

A New End‐Point for ELISA Titrations

This report describes a new ELISA procedure based on end-point titrations. This end-point ELISA takes advantage of the change of color intensity that occurs when peroxidase-containing wells of an ELISA plate are revealed with diaminobenzidine-nickel and further intensification with silver: as antibody concentration and, therefore, peroxidase concentration, decreased, the color became stronger in some wells and, afterwards (i.e., at lower antibody and peroxidase concentrations), the color faded toward clear background. It is proposed that the reciprocal of the sample dilution at which the color intensifies can be used as a measure of the sample antibody content. This report verifies the validity and precision of that procedure.

Improvements to the enzyme-developed radial immunodiffusion technique

An enzyme-developed radial immunodiffusion technique, previously known as the diffusion-in-gel enzyme-linked immunosorbent assay (DIG-ELISA), has been improved in two ways: (a) antibody-containing spots have been made larger and more distinct by revealing them with a mixture of hydrogen peroxide, 3,3'-diaminobenzidine and nickel, and further intensification of the ensuing spots with silver; (b) the reliability of the method has been enhanced by chemically coupling the antigen to a layer of a polyamino acid (poly(lysine, phenylalanine)) adsorbed to the bottom of the polystyrene petri dish. The usefulness of the improved technique is illustrated by reference to the measurement of serum concentrations of IgM and IgG, and in the assessment of antibody levels against a particulate antigen (erythrocytes).

Silver development in microscopy and bioanalysis: past and present

With the experience accumulated from more than a century of silver applications in biology and medicine, physical development has become a powerful bioanalytical tool for marker amplification in blotting procedures, in situ hybridization, immunocytochemistry, histochemistry, and cytochemistry. Early, empirical techniques of silver impregnation followed by development in a reducing solution (chemical developer), or a solution which contained both silver reducers and silver salts (physical developer) were often capricious and suffered from unwanted silver precipitation caused by light and self-nucleation. To accommodate the modern demand for accurate physical development, various strategies have been devised to counter these problems. One approach has been to introduce organic colloids into the developer to keep the silver ions and reducer molecules apart, whilst excluding light by using a dark-room or by covering the solution. Albumen, gelatin, and complex polysaccharides have all been tested, but gum arabic is preferred. In addition, further control can be achieved by slowing down the rate of development with low pH and by changing from silver nitrate to silver lactate, which dissociates more slowly. Effective colloid protection in a physical developer is also provided by the inclusion of tungsten salts which can delay light-catalysed silver reduction and keep the developer clear for many minutes. The same result has been achieved by complexing the silver salt in the physical developer with very large organic molecules, restricting ionization. 'Light insensitive' commercial designer products have resulted. Probably no single formulation can satisfy all conditions of use, but with increased understanding of the mechanisms of physical developers a more flexible, user-friendly approach is anticipated.