Enantioselective fungal biotransformation of risperidone in liquid culture medium by capillary electrophoresis and hollow fiber liquid-phase microextraction

Bioanalysis of drugs and their metabolites by chiral electromigration techniques (2010-2020)

The further development and application of capillary electromigration techniques for the enantioselective determination of drugs and their metabolites in body fluids, tissues, and in vitro preparations during the 2010 to 2020 time period continued to proof their usefulness and attractiveness in bioanalysis. This review discusses the principles and important aspects of capillary electrophoresis- based chiral drug bioassays, provides a survey of the assays reported during the past 10 years and presents an overview of the key achievements encountered in that time period. For systems with charged chiral selectors, special attention is paid on assays that feature field-amplified sample injection to enable the determination of ppb levels of analytes and optimized online incubation procedures for the rapid assessment of a metabolic pathway. Applications discussed encompass the pharmacokinetics of drug enantiomers in vivo and in vitro, the impact of inhibitors on metabolic steps, the elucidation of the stereoselectivity of drug metabolism in vivo and in vitro, and drug enantiomers in toxicological, forensic, and doping analysis.

Field-amplified sample injection in capillary zone electrophoresis for the pharmacokinetic research of trace risperidone and its major metabolite 9-hydroxyrisperidone in beagle dogs

This article describes a method for the simultaneous quantitation of risperidone and its major metabolite, 9-hydroxyrisperidone, in beagle dog plasma by field-amplified sample injection in capillary zone electrophoresis. The separation was carried out at 25°C in a 48 cm × 75 µm fused-silica capillary with an applied voltage of 20 kV using 60 mM NaH₂ PO₄ buffer (pH 3.6). The detection wavelength was 280 nm. Clean-up and preconcentration of plasma samples were conducted by 96-well formatted liquid-liquid extraction. In this study, this stacking technique provided a sensitivity enhancement of approximately 158 to 188 fold compared with the same sample without stacking. The method was suitably validated with respect to stability, specificity, linearity, lower limit of quantitation, accuracy, precision, and extraction recovery. Calibration curves exhibited good linearity (r²  > 0.995) over a wide concentration range of 2.5 to 200 ng/mL for both risperidone and 9-hydroxyrisperidone. The intra- and interday precisions at the three quality control levels were less than 11.40%. The intra- and interday accuracies ranged from 87.90 to 107.17% for risperidone and from 88.43 to 105.92% for 9-hydroxyrisperidone. All validation data were within the required limits. In conclusion, the method developed was successfully applied to pharmacokinetic studies of risperidone and 9-hydroxyrisperidone in beagle dogs.

Forced degradation studies, and effect of surfactants and titanium dioxide on the photostability of paliperidone by HPLC

Forced degradation study of paliperidone under hydrolytic, oxidative, thermal and photolytic stress conditions was conducted using HPLC. The drug was found to be labile under hydrolytic, oxidative and photolytic stress conditions; whereas, it was stable under dry heat stress conditions. Effect of anionic, cationic and non-ionic surfactants applied to the concentration exceeding critical micellar concentration on the photostability of paliperidone was also studied by exposing the samples to sunlight for 72h. Major degradation of the drug was found in presence of cationic and non-ionic surfactants. Effect of titanium dioxide on the photo-degradation of paliperidone in solution state was also studied and it was found that 53% of the drug was degraded after 72h of exposure to sunlight. A common degradation peak was observed in oxidative and TiO2 photocatalysed samples. This peak may be due to the generation of N-oxide of paliperidone. The same degradation peak was also observed in all other photostability samples. Chromatographic separation of drug and its degradation products was achieved on an Alltima C8 (250mm×4.6mm, 5μm) analytical column, using a mobile phase consisting of acetonitrile-ammonium acetate buffer with 0.2% triethylamine (pH 3.5; 20mM) (60:40, v/v) at a flow rate of 1mL/min. Quantification was performed with UV detection at 280nm. The method was validated as per ICH guidelines.

Application of 2,3-naphthalenediamine in labeling natural carbohydrates for capillary electrophoresis

Neutral and acidic monosaccharide components in Ganoderma lucidum polysaccharide are readily labeled with 2,3-naphthalenediamine, and the resulting saccharide-naphthimidazole (NAIM) derivatives are quantified by capillary electrophoresis (CE) in borate buffer. Using sulfated-α-cyclodextrin as the chiral selector, enantiomers of monosaccharide-NAIMs are resolved on CE in phosphate buffer, allowing a simultaneous determination of the absolute configuration and sugar composition in the mucilage polysaccharide of a medicinal herb Dendrobiumhuoshanense. Together with the specific enzymatic reactions of various glycoside hydrolases on the NAIM derivatives of glycans, the structures of natural glycans can be deduced from the digestion products identified by CE analysis. Though heparin dissachrides could be successfully derived with the NAIM-labeling method, the heparin derivatives with the same degree of sulfation could not be separated by CE.