A new approach to prepare well-dispersed CaF(2) nanoparticles by spray drying technique

Evaluation of novel nanoscaled metal fluorides on their ability to remineralize enamel caries lesions

The aim of this in vitro study was to evaluate the ability of two nanoscaled metal fluorides (NMF) to remineralize shallow (SL) and deep (DL) artificial enamel caries lesions. NMF are synthesized via a non-aqueous fluorolytic sol-gel-synthesis and dissolve low fluoride concentration in aqueous solutions (n-CaF₂: 7 ppm, n-MgF₂: 70 ppm), whilst containing a nominal fluoride concentration of 3,400 ppm. For comparison, an aqueous sodium fluoride solution (NaF: 3,400 ppm), a sodium fluoride containing varnish (Duraphat: 22,600 ppm) and a fluoride-free negative control were investigated. Bovine enamel specimens with SL (n = 86, 4649–4795 vol%xμm) or DL (n = 145, 9091–9304 vol%xμm) were prepared and allocated to five groups each. In each group the respective agent was applied and pH-cycling was performed for 14 days (SL) and 90 days (DL), respectively. Mineral loss and lesion depth were assessed by transversal microradiography. For SL, all fluoride agents significantly remineralized the specimens compared to baseline (p > 0.05; Mann-Whitney test) to a similar extent. For DL, both NMF showed significantly higher mineral gain compared to the other fluoride agents (p < 0.05). In conclusion, the novel NMF- showing relatively low free fluoride concentrations- bear at least the similar potential for remineralization of early caries lesions as highly fluoridated agents being commonly used.

Preparation and optimization of calcium fluoride particles for dental applications

Fluorides are used in dental care due to their beneficial effect in tooth enamel de-/remineralization cycles. To achieve a desired constant supply of soluble fluorides in the oral cavity, different approaches have been followed. Here we present results on the preparation of CaF2 particles and their characterization with respect to a potential application as enamel associated fluoride releasing reservoirs. CaF2 particles were synthesized by precipitation from soluble NaF and CaCl2 salt solutions of defined concentrations and their morphology analyzed by scanning electron microscopy. CaF2 particles with defined sizes and shapes could be synthesized by adjusting the concentrations of the precursor salt solutions. Such particles interacted with enamel surfaces when applied at fluoride concentrations correlating to typical dental care products. Fluoride release from the synthesized CaF2 particles was observed to be largely influenced by the concentration of phosphate in the solution. Physiological solutions with phosphate concentration similar to saliva (3.5 mM) reduced the fluoride release from pure CaF2 particles by a factor of 10-20 × as compared to phosphate free buffer solutions. Fluoride release was even lower in human saliva. The fluoride release could be increased by the addition of phosphate in substoichiometric amounts during CaF2 particle synthesis. The presented results demonstrate that the morphology and fluoride release characteristics of CaF2 particles can be tuned and provide evidence of the suitability of synthetic CaF2 particles as enamel associated fluoride reservoirs.