Corrected solid-state 13 C nuclear magnetic resonance peak assignment and side-group quantification of hydroxypropyl methylcellulose acetyl succinate pharmaceutical excipients

Vinyl and methyl-ester groups in the insoluble polymer drug patiromer identified and quantified by solid-state NMR

Patiromer (Veltassa®) is a crosslinked, insoluble co-polymer drug used as a nonabsorbent potassium binder, approved for treatment of hyperkalemia. Quantitative solid-state 13C nuclear magnetic resonance (NMR) analysis with comprehensive peak assignment, component quantification, and calculation of mole and weight fractions of monomer units was performed on three doses of patiromer. The workflow is documented in detail. Spectrally edited solid-state 13C NMR spectra of patiromer show =CHn peaks of matching intensity at 116 and 141 ppm, characteristic of -CH=CH2 vinyl groups. Similar spectral features can be observed in earlier studies but were previously ignored. In this study, the vinyl signals are well-resolved in a 2-s direct polarization (DP) spectrum without and with dipolar dephasing, which confirms that these sp2-hybridized carbons are bonded to hydrogen and partially mobile, consistent with vinyl side groups from incompletely reacted divinyl crosslinkers. The vinyl groups account for 1.6% of all carbon, 3% of the monomer units, and nearly 1/3 of the crosslinkers. Furthermore, an unexpected OCH3 moiety accounting for ∼1.2% of all carbons was identified by spectral editing; its chemical shift of 54 ppm is more consistent with a methyl ester than with a methyl ether. It can originate from incomplete hydrolysis of ∼6% of methyl-2-fluoroacrylate, the main monomer of patiromer. Characteristic cross peaks in two-dimensional 1H-13C heteronuclear correlation NMR confirm the presence of the vinyl and OCH3 groups. Trace amounts of xanthan gum are also detected. The quantitative 13C NMR spectrum of patiromer has been matched in a simulation using a model with five monomer units.

Threading the needle: Achieving simplicity and performance in cellulose alkanoate ω-carboxyalkanoates for amorphous solid dispersion

Most active pharmaceutical ingredients (APIs) suffer from poor water solubility, often keeping them from reaching patients. To overcome the issues of poor drug solubility and subsequent low bioavailability, amorphous solid dispersions (ASDs) have garnered much attention. Cellulose ester derivatives are of interest for ASD applications as they are benign, sustainable-based, and successful in commercial drug delivery systems, e.g. in osmotic pump systems and as commercial ASD polymers. Synthesis of carboxy-pendant cellulose esters is a challenge, due in part to competing reactions between carboxyls and hydroxyls, forming ester crosslinks. Herein we demonstrate proof-of-concept for a scalable synthetic route to simple, yet highly promising ASD polymers by esterifying cellulose polymers through ring-opening of cyclic succinic or glutaric anhydride. We describe the complexity of such ring-opening reactions, not previously well-described, and report ways to avoid gelation. We report synthesis, characterization, and preliminary in vitro ASD evaluations of fifteen such derivatives. Synthetic routes were designed to accommodate these criteria: no protecting groups, no metal catalysts, mild conditions with standard reagents, simple purification, and one-pot synthesis. Finally, these designed ASD polymers included members that maintained fast-crystallizing felodipine in solution and release it from an ASD at rather high 20 % drug loading (DL).