Generation of neutral pH high‐strength plasma‐activated water from a pin to water discharge and its bactericidal activity on multidrug‐resistant pathogens

Inactivation effects of plasma-activated saline prepared by the mixed gases of discharged air and different gases

Plasma-activated water can efficiently inactivate pathogenic microorganisms and is considered to be a potent disinfectant in the medical, food, and agricultural industries. In this study, the air discharged by the gliding arc was mixed with different gases including O2, ambient air, synthetic air, and N2 at different flow rates to produce the activated gases, which were then activated gases were inducted into saline to prepare plasma-activated saline (PAS). The gaseous reactive species in the activated gases were composed of NO, NO2, and N2O5 and the aqueous reactive species in the PAS included H2O2, NO2 −, NO3 –, ⋅ OH , and 1O2 with different intensities, while the inactivation effects of the PAS also varied with the type and the flow rates of the mixed gases in the activated gases. The inactivation effects of the PAS treated by the discharged air mixed with O2, ambient air, and synthetic air started to become weak after 3 h placement. Scavenger analysis demonstrated that the 1O2 played a critical role in the inactivation process. This study indicated that air discharged by the gliding arc mixed with different gases could regulate the reactive species and the biological effects of PAS, providing insight into the preparation of PAS applied for disinfection.

Study of a Conical Plasma Jet with a Cloth-Covered Nozzle for Polymer Treatment

Although atmospheric pressure plasma jets (APPJs) have been widely employed for materials modification, they have some drawbacks, such as the small treatment area (couple of cm2). To overcome this limitation, a funnel-like APPJ with a wide exit has been proposed. In this work, a gas-permeable cotton cloth covered the nozzle of the device to improve the gas flow dynamics and increase its range of operation. The funnel jet was flushed with Ar, and the plasma was ignited in a wide range of gas flow rates and the gap distances between the exit nozzle and the sample holder. The device characterization included electric measurements and optical emission spectroscopy (OES). To evaluate the size of the treatment and the degree of surface modification, large samples of high-density polyethylene (PE) were exposed to plasma for 5 min. Afterward, the samples were analyzed via water contact angle WCA measurements, scanning electron microscopy (SEM), and X-ray photoelectron spectroscopy (XPS). It was found that surface modification occurs simultaneously on the top and bottom faces of the samples. However, the treatment incorporated different functional groups on each side.