Effect on sludge disintegration by EDTA-enhanced thermal-alkaline treatment

Advanced application of tea residue extracts rich in polyphenols for enhancing sludge dewaterability: Unraveling the role of pH regulation

Tea polyphenols (TPs), as a kind of derivatives from tea waste, were employed as a novel environmentally friendly bio-based sludge conditioner in this study. The findings showed that when TPs were applied at a dosage of 300 mg g-1 DS, the sludge CST0/CST ratio significantly increased to 1.90. pH regulation was found to markedly affect the dewatering efficiency of sludge. At pH 4, the CST0/CST rose to 2.86, coupled with a reduction in the specific resistance to filtration (SRF) from 6.69 × 1013 m kg-1 to 1.43 × 1013 m kg-1 and a decrease in the moisture content (MC) from 90.57% to 68.75%. TPs formed complexes and precipitated sludge proteins, as demonstrated by changes in the extracellular polymeric substances (EPS), viscosity, zeta potential, and particles size distribution. The optimization significance of acidification treatment on sludge structure disintegration, the interaction of TPs with EPS, and the removal of sludge proteins were elucidated. The research provided an ideal approach for the integrated utilization of biomass resources from tea waste and highlighted the potential application of TPs as an environmentally friendly conditioner in sludge dewatering.

Novel multiplexed alkali enzyme lysis coupled with EDTA pretreatment for RNA virus extraction from wastewater sludge: Optimization, recovery, and detection

RNA viruses are readily enriched in wastewater sludge owing to adsorption by extracellular polymeric substances (EPS) during wastewater treatment, causing pathogenicity. However, conventional wastewater extraction methods often fail to fully extract these viruses from sludge. In this study, three methods: enzymatic (ENP), alkaline (ALP), and ethylenediaminetetraacetic acid (EDTA) pretreatments were applied to sludges and promote the RNA virus extraction from sludge. Our results show that the total recovery rate of RNA viruses increased by 87.73% after ENP pretreatment, whereas ALP pretreatment inhibited virus extraction. The highest recovery rate of viruses from sludge, reaching 296.80%, was achieved with EDTA pretreatment (EDP) coupled with ENP. Notably, the most significant increase was observed in the abundance of Astroviruses, which increased from 7.60 × 107 to 7.86 × 108 copies/g TSS after EDP + ENP treatment. Our investigations revealed that virus extraction was affected by a class of short-wavelength protein substances, as opposed to tryptophan or tyrosine, which were eluted by proteins with beef paste buffer by substitution after EDP + ENP treatment. The results of this study provide essential insights for sludge-based epidemiology with the required sensitivity for managing the extraction of RNA epidemic viruses to control viral transmission.

Alkaline-thermal hydrolysate of waste activated sludge as a co-metabolic substrate enhances biodegradation of refractory dye reactive black 5

Aromatic azo dyes possess inherent resistance and are known to be carcinogenic, posing a significant threat to human and ecosystems. Enhancing the biodegradation of azo dyes usually requires the presence of co-metabolic substrates to optimize the process. In addressing the issue of excessive waste activated sludge (WAS) generation, this study explored the potential of utilizing alkaline-thermal hydrolysate of WAS as a co-metabolic substrate to boost the degradation of reactive black 5 (RB5) dyes. The acclimated microbial consortium, when supplemented with the WAS hydrolysate obtained at a hydrolysis temperature of 30 °C, achieved an impressive RB5 decolorization efficiency of 90.3% (pH = 7, 35 °C) with a corresponding COD removal efficiency of 45.0%. The addition of WAS hydrolysate as a co-substrate conferred the consortium with a remarkable tolerance to high dye concentration (1500 mg/L RB5) and salinity levels (4-5%), surpassing the performance of conventional co-metabolic sugars in RB5 degradation. 3D-EEM analysis revealed that protein-like substances rich in tyrosine and tryptophan, present in the WAS hydrolysate, played a crucial role in promoting RB5 biodegradation. Furthermore, the microbial consortium community exhibited an enrichment of dye-degrading species, including Acidovorax, Bordetella, Kerstersia, and Brevundimonas, which dominated the community. Notably, functional genes associated with dye degradation and intermediates were also enriched during the RB5 decolorization and biodegradation process. These findings present a practical strategy for the simultaneous treatment of dye-containing wastewater and recycling of WAS.

Sludge disintegration and phosphorus migration in anaerobic fermentation of waste activated sludge by the addition of EDTA-2Na

The effects of the addition of EDTA-2Na on sludge disintegration and phosphorus (P) migration during anaerobic fermentation (AF) of waste activated sludge (WAS) are investigated. The efficiency of sludge disintegration was positively correlated with the dose of EDTA-2Na from 0.5-2.0 g/g SS, and an enormous quantity of P was liberated into the aqueous phase, accompanied by sludge disintegration. The proper dose of EDTA-2Na for P release from WAS was 1.5 g/g SS, with an orthophosphate concentration of 394.72 mg/L. P release was more consistent with the pseudo second-order kinetic model. The migration of P species during AF with EDTA-2Na addition was also studied. Orthophosphate was the main species in both of the liquid phase and the loosely bound extracellular polymeric substances (EPS), but organic P (OP) was much more abundant in tightly bound EPS. Inorganic P (IP) was the dominant P speciation in the solid and was mainly distributed in the fraction of non-apatite IP, which accounted for more than 62.8% of IP in the presence of EDTA-2Na. In addition, both IP and OP in the solid contributed to the accumulation of P and the former was outperformed. Furthermore, the increased total dissolved P mainly came from cells. However, the fermented sludge tended to be smaller and to have low compressibility, which is detrimental to its further treatment.

Effects of low- and high-temperature thermal-alkaline pretreatments on anaerobic digestion of waste activated sludge

To compare the effects of low- and high-temperature thermal-alkaline pretreatments (LTTAP, 60 ± 1 °C, pH 12.0 ± 0.1, 30 min and HTTAP, 160 ± 1 °C, pH 12.0 ± 0.1, 30 min, respectively) on anaerobic digestion (AD) of waste activated sludge, long-term and semi-continuous experiments were conducted in three laboratory continuous stirred tank reactors. The experimental results showed that the two pretreatments increased the methane yield of sludge from 89.20 ± 2.41 mL/g added volatile solids (VS) to 117.50 ± 5.27 mL/g added VS (LTTAP) and 156.40 ± 2.99 mL/g added VS (HTTAP). After AD, the reduction of sludge (volatile solid) increased from 32.91 ± 0.27% to 44.17 ± 1.53% (LTTAP), and 50.86 ± 1.18% (HTTAP), and the abundance of pathogenic bacteria decreased from 6.53% to 0.38% (LTTAP) and 0.14% (HTTAP). LTTAP enhanced both hydrogentrophic and acetoclastic methanogenis and HTTAP only enhanced acetoclastic methanogenis. Additionally, the energy efficiency of HTTAP and its subsequent AD was lower than that of LTTAP and its subsequent AD.

The Effect of Static Magnetic Field on Methanogenesis in the Anaerobic Digestion of Municipal Sewage Sludge

The present study aimed to determine the effect of a 17.6 mT static magnetic field (SMF) on the efficiency of anaerobic digestion (AD) of municipal sewage sludge (MSS). The SMF had a significant impact on methane (CH4) production efficiency, the levels of fermentation rate (ηFMSS) vs. removal rate (ηVS), and the structure of the anaerobic bacteria consortium, but it did not affect cumulative biogas production. The highest CH4 yield (431 ± 22 dm3CH4/kgVS) and the highest methane content in the biogas (66.1% ± 1.9%) were found in the variant in which the SMF exposure time was 144 min/day. This variant also produced the highest ηFMSS and ηVS values, reaching 73.8% ± 2.3% and ηVS 36.9% ± 1.6%, respectively. Longer anaerobic sludge retention time in the SMF area significantly decreased AD efficiency and caused a significant reduction in the number of methanogens in the anaerobic bacteria community. The lowest values were observed for SMF exposure time of 432 min/day, which produced only 54.8 ± 1.9% CH4 in the biogas. A pronounced reduction was recorded in the Archaea (ARC915) and Methanosaeta (MX825) populations in the anaerobic sludge, i.e., to 20% ± 11% and 6% ± 2%, respectively.

Effect of Low-Temperature Conditioning of Excess Dairy Sewage Sludge with the Use of Solidified Carbon Dioxide on the Efficiency of Methane Fermentation

This study aimed to determine the effect of the low-temperature conditioning of excess dairy sewage sludge using solidified carbon dioxide on the efficiency of methane fermentation. An increase in the solidified carbon dioxide to excess dairy sewage sludge volumetric ratio above 0.3 had no significant effect on chemical oxygen demand concentration in the dissolved phase. The highest chemical oxygen demand values, ranging from 490.6 ± 12.9 to 510.5 ± 28.5 mg·dm−3, were determined at solidified carbon dioxide to excess dairy sewage sludge ratio ranging from 0.3 to 0.5. The low-temperature conditioning caused ammonia nitrogen concentration to increase from 155.2 ± 10.2 to 185.9 ± 11.1 mg·dm−3 and orthophosphates concentration to increase from 198.5 ± 23.1 to 300.6 ± 35.9 mg·dm−3 in the dissolved phase. The highest unitary amount of biogas, reaching 630.2 ± 45.5 cm3·g o.d.m.−1, was produced in the variant with the solidified carbon dioxide to excess dairy sewage sludge volumetric ratio of 0.3. Methane content of the biogas produced was at 68.7 ± 1.5%. Increased solidified carbon dioxide dose did not lead to any significant changes in biogas and methane production. The efficiency of biogas production from unconditioned excess dairy sewage sludge was lower by 43.0 ± 3.2%. The analysis demonstrated that the low-temperature conditioning is an energetic viable technology aiding the methane fermentation process.

Protein extraction from excess sludge by alkali-thermal hydrolysis

The protein in excess sludge can be extracted effectively by the alkali-thermal method, and the extracted protein can be used as a foaming agent and in other industrial raw materials to realize its resource utilization. In this paper, the factors influencing sludge protein extraction by the alkali-thermal method were optimized based on the protein extraction rate and the polypeptide content, which determine the foaming performance of the extracted protein. The results showed that the optimal conditions were a pH of 12, a temperature of 120 °C, a reaction time of 4 h, and a sludge moisture content of 92%. Under these optimized conditions, the extraction rate of protein and the concentration of polypeptides were 88.3% and 6599 mg/L, respectively. Additionally, the foaming performance of the extracted protein solution was tested, and the foamability and foam stability were close to 450% and 88.8%, respectively. Therefore, the sludge protein extracted by the alkali-thermal method can meet the relevant standards of foam extinguishing agents and concrete foaming agents in China. In addition, the dewatering performance of the hydrolyzed sludge was improved by 93.1%, which provided favorable conditions for the subsequent separation of the protein solution.