Structure and dynamics of nitrifier populations in a full-scale submerged membrane bioreactor during start-up

Characteristics of compounds with strong or weak nitrification inhibition in sewage

To clarify the characteristics of compounds with strong or weak nitrification inhibition in sewage, 64 organic compounds including compounds registered in Pollutant Release and Transfer Register (PRTR) were evaluated in terms of their chemical structures and molecular weights. Nineteen compounds showed strong nitrification inhibition by testing with Nitrosomonas europaea. Compounds with thioamide structures had the lowest median value of EC50 (0.017 mg/L), followed by those with alkyne structures (0.121 mg/L), chlorophenol structures (0.300 mg/L), and then azole structures (0.365 mg/L). In contrast, 33 of the 64 compounds showed weak nitrification inhibition at a concentration of 10 mg/L, 27 of which were categorized into three main groups: long-chain alcohol structures, alkyne structures with a phenyl group, and aromatic structures. Most compounds with strong nitrification inhibition had a low molecular weight (MW) from 50 to 200. Meanwhile, the proportion of compounds with weak nitrification inhibition tended to be greater with increasing MW and such compounds were predominant at higher molecular weights above 300. The correlations of results derived from tests of nitrification inhibition based on ISO 9509 and N. europaea showed that 24 out of 30 compounds provided results that were highly correlated between these tests (R = 0.85), while 4 compounds with chlorophenol structures and 2 compounds with alkyne structures showed weaker inhibition rates in the ISO 9509 test than in the N. europaea test. Our results indicate that the magnitude of nitrification inhibition depends on MW in addition to the chemical structure, which is helpful in the search for the cause of nitrification inhibition in wastewater treatment plants.

Enhanced treatment of sludge drying condensate by A/O-MBR process: Microbial activity and community structure

With the rapid increase of sludge production from sewage treatment plants, the treatment of sludge drying condensate rich in a large amount of pollutants urgently needs to be addressed. Due to the unique characteristics of sludge drying condensate (high ammonia nitrogen and COD concentration), there are almost no reports on biological treatment methods specifically targeting sludge drying condensate. In this study, A/O-MBR process was proposed for sludge drying condensate treatment and the effects of ammonia nitrogen loads, alkalinity and aeration intensity were explored. Experimental results show that under the ammonia nitrogen load of 0.35 kg NH4+-N/(m3·d) and the aeration intensity of 0.5 m3/(m2·min), the removal rate of COD and NH4+-N could reach 94% and 99.86% with the addition of alkalinity (m(NaHCO3): m(NH4+-N) = 7:1), respectively. The distribution of living and dead microbial cells in the activated sludge of three reactors also proved that the supplement of alkalinity in the influent can ensure the feasible living conditions for microorganisms. In addition to traditional nitrifying bacteria, through the supplementation of alkalinity and the reduction of aeration intensity, the system had also domesticated high abundance heterogeneous nitrification aerobic denitrification (HN-AD) and aerobic denitrification bacteria (both more than 10% of the total bacterial count). The denitrification process of sludge drying condensate was simplified and the denitrification efficiency was greatly improved. The findings of this study could provide important theoretical guidance for the biological treatment process of sludge drying condensate.

Nitrification performance and bacterial community dynamics in a membrane bioreactor with elevated ammonia concentration: The combined inhibition effect of salinity, free ammonia and free nitrous acid on nitrification at high ammonia loading rates

The responses of the operational performance and bacterial community structure of a nitrification membrane bioreactor (MBR) to elevated ammonia loading rate (ALR) were investigated. Effective nitrification performance was achieved at high ALR up to 3.43 kg NH₄⁺-N/m³·d, corresponding to influent NH₄⁺-N concentration of 2000 mg/L. Further increasing influent NH₄⁺-N concentration to 3000 mg/L, the MBR system finally became completely inefficient due to the combined inhibition effect of salinity, free ammonia and free nitrous acid on nitrification. Ammonia-oxidizing bacteria (AOB) Nitrosomonas were enriched with the increase of ALR. The relative abundance of Nitrosomonas in the sludge with ALR of 2.57 kg NH₄⁺-N/m³·d was up to 14.82%, which were 9-fold and 53-fold higher than that in seed sludge and the sludge with ALR of 0.10 kg NH₄⁺-N/m³·d, respectively. The phylogenetic analysis of AOB amoA genes showed that Nitrosomonas europaea/mobilis lineage are chiefly responsible for catalyzing ammonia oxidation at high ALRs.

Response of performance and ammonia oxidizing bacteria community to high salinity stress in membrane bioreactor with elevated ammonia loading

Effect of elevated ammonia loading rate (ALR) and increasing salinity on the operation of membrane bioreactor (MBR) and the response of microbial community were investigated. Results showed that MBR started up with 1% NaCl stress achieved amazing nitrification performance at high salinity up to 4% when treating wastewater containing 1000mg/L NH(+)4-N. Further increasing salinity to 7% led to failure of MBR unrecoverably. Steep decline of sludge activity contributed to the extremely worse performance. High-throughput sequencing analysis showed that both ALR and salinity had selective effects on the microbial community structure. In genus level, Methyloversatilis and Maribacter were enriched during the operation. Survival of salt-resistant microbes contributed to the rising of richness and diversity at 2% and 4% NaCl stress. Analysis of amoA-gene-based cloning revealed Nitrosomonas marina are chiefly responsible for catalyzing ammonia oxidation in high ALR at high salinity stress.

Microbial community characteristics during simultaneous nitrification-denitrification process: effect of COD/TP ratio

To evaluate the impact of chemical oxygen demand (COD)/total phosphorus (TP) ratio on microbial community characteristics during low-oxygen simultaneous nitrification and denitrification process, three anaerobic-aeration (low-oxygen) sequencing batch reactors, namely R1, R2, and R3, were performed under three different COD/TP ratios of 91.6, 40.8, and 27.6. The community structures of each reactor were analyzed via molecular biological technique. The results showed that the composition of ammonia-oxidizing bacteria (AOB) was affected, indicated by Shannon indexes of the samples from R1, R2, and R3. Nitrosomonas was identified to be the dominant AOB in all SBRs. Moreover, the copy numbers of nitrifiers were more than those of denitrifiers, and the phosphorus-accumulating organisms to glycogen-accumulating organisms ratio increased with the decrease of COD/TP ratio.

Changes in bacterial community structure in a full-scale membrane bioreactor for municipal wastewater treatment

This study investigated changes in the structure and metabolic capabilities of the bacterial community in a full-scale membrane bioreactor (MBR) treating municipal wastewater. Microbial monitoring was also conducted for a parallel-running conventional activated sludge (CAS) process treating the same influent. The mixed-liquor suspended solid concentration in the MBR reached a steady-state on day 73 after the start-up. Then the MBR maintained higher rates of removal of organic compounds and nitrogen than the CAS process did. Terminal restriction fragment length polymorphism analysis revealed that the bacterial community structure in the MBR was similar to that in the CAS process at the start-up, but it became very different from that in the CAS process in the steady state. The bacterial community structure of the MBR continued to change dynamically even after 20 months of the steady-state operation, while that of the CAS process was maintained in a stable condition. By contrast, Biolog assay revealed that the carbon source utilization potential of the MBR resembled that of the CAS process as a whole, although it declined transiently. Overall, the results indicate that the bacterial community of the MBR has flexibility in terms of its phylogenetic structure and metabolic activity to maintain the high wastewater treatment capability.

Changes in wastewater treatment performance and activated sludge properties of a membrane bioreactor at low temperature operation

The membrane bioreactor (MBR) activated sludge process is being applied more and more for wastewater treatment due to its high treatment efficiency and low space requirement. However, the usefulness of the MBR process in low-temperature zones is less studied than that under normal conditions. This study determined the effect of low temperature (∼13 °C) operation on MBR performance and activated sludge characteristics. When the wastewater temperature decreased from 22 °C to 13 °C, the average effluent COD concentration increased from (10 ± 5) to (25 ± 4) mg L(-1) and the nitrogen removal efficiency appeared not to be affected. The abundance and diversity of nitrifying bacteria such as Nitrosospira (ammonia-oxidizing bacteria) and Nitrospira (nitrite-oxidizing bacteria) in the activated sludge were reduced under low temperature exposure. The total biomass concentration decreased from about 10 000 mg COD L(-1) at room temperature to 8200 mg COD L(-1) at 13 °C at the same solid retention time. Furthermore, the sludge became bulking at 13 °C with a significant increase in the sludge volume index. The resultant sludge bulking was accompanied by accelerated membrane fouling resulting in a two-fold increase in the frequency of membrane cleaning. The results suggest that the performance of the MBR activated sludge process deteriorated at low wastewater temperatures even though the effluent water quality was still good enough for its applications in low temperature zones.

Archaeal diversity in biofilm technologies applied to treat urban and industrial wastewater: recent advances and future prospects

Biological wastewater treatment (WWT) frequently relies on biofilms for the removal of anthropogenic contaminants. The use of inert carrier materials to support biofilm development is often required, although under certain operating conditions microorganisms yield structures called granules, dense aggregates of self-immobilized cells with the characteristics of biofilms maintained in suspension. Molecular techniques have been successfully applied in recent years to identify the prokaryotic communities inhabiting biofilms in WWT plants. Although methanogenic Archaea are widely acknowledged as key players for the degradation of organic matter in anaerobic bioreactors, other biotechnological functions fulfilled by Archaea are less explored, and research on their significance and potential for WWT is largely needed. In addition, the occurrence of biofilms in WWT plants can sometimes be a source of operational problems. This is the case for membrane bioreactors (MBR), an advanced technology that combines conventional biological treatment with membrane filtration, which is strongly limited by biofouling, defined as the undesirable accumulation of microbial biofilms and other materials on membrane surfaces. The prevalence and spatial distribution of archaeal communities in biofilm-based WWT as well as their role in biofouling are reviewed here, in order to illustrate the significance of this prokaryotic cellular lineage in engineered environments devoted to WWT.

Impact of food to microorganism (F/M) ratio and colloidal chemical oxygen demand on nitrification performance of a full-scale membrane bioreactor treating thin film transistor liquid crystal display wastewater

This study investigated impact of food to microorganism (F/M) ratio and colloidal chemical oxygen demand (COD) on nitrification performance in one full-scale membrane bioreactor (MBR) treating monoethanolamine (MEA)/dimethyl sulfoxide (DMSO)-containing thin film transistor liquid crystal display (TFT-LCD) wastewater. Poor nitrification was observed under high organic loading and high colloidal COD conditions, suggesting that high F/M ratio and colloidal COD situations should be avoided to minimize their negative impacts on nitrification. According to the nonmetric multidimensional scaling (NMS) statistical analyses on terminal restriction fragment length polymorphism (T-RFLP) results of ammonia monooxygenase (amoA) gene, the occurrence of Nitrosomonas oligotropha-like ammonia oxidizing bacteria (AOB) was positively related to successful nitrification in the MBR systems, while Nitrosomonas europaea-like AOB was positively linked to nitrification rate, which can be attributed to the high influent total nitrogen condition. Furthermore, Nitrobacter- and Nitrospira-like nitrite oxidizing bacteria (NOB) were both abundant in the MBR systems, but the continuously low nitrite environment is likely to promote the growth of Nitrospira-like NOB.

Nitrification performance and microbial ecology of nitrifying bacteria in a full-scale membrane bioreactor treating TFT-LCD wastewater

This study investigated nitrification performance and nitrifying community in one full-scale membrane bioreactor (MBR) treating TFT-LCD wastewater. For the A/O MBR system treating monoethanolamine (MEA) and dimethyl sulfoxide (DMSO), no nitrification was observed, due presumably to high organic loading, high colloidal COD, low DO, and low hydraulic retention time (HRT) conditions. By including additional A/O or O/A tanks, the A/O/A/O MBR and the O/A/O MBR were able to perform successful nitrification. The real-time PCR results for quantification of nitrifying populations showed a high correlation to nitrification performance, and can be a good indicator of stable nitrification. Terminal restriction fragment length polymorphism (T-RFLP) results of functional gene, amoA, suggest that Nitrosomonas oligotropha-like AOB seemed to be important to a good nitrification in the MBR system. In the MBR system, Nitrobacter- and Nitrospira-like NOB were both abundant, but the low nitrite environment is likely to promote the growth of Nitrospira-like NOB.

Prevalence of Nitrosomonas cluster 7 populations in the ammonia-oxidizing community of a submerged membrane bioreactor treating urban wastewater under different operation conditions

A pilot-scale ultrafiltration membrane bioreactor (MBR) was used for the aerobic treatment of urban wastewater in four experimental stages influenced by seasonal temperature and different sets of operation conditions. The structure of the ammonia-oxidizing bacteria (AOB) community was profiled by temperature gradient gel electrophoresis (TGGE), based on the amplification and separation of partial ammonia-monoxygenase subunit A (amoA) genes. Canonical correspondence analysis revealed that temperature, hydraulic retention time and percentage of ammonia removal had a significant effect on the fingerprints of AOB communities. Phylogenetic analysis conducted on amoA/AmoA sequences of reamplified TGGE bands showed, however, that closely related ammonia-oxidizing populations inhabited the sludge of the MBR in all experimental stages. Nitrosomonas cluster 7 populations (N. europaea-N. eutropha cluster) prevailed under all conditions tested, even when the MBR was operated under complete biomass retention or at low temperatures, suggesting that the high ammonia concentrations in the system were determinant to select r-strategist AOB.