Bi-functionalized mesostructured silicas as reversed-phase/strong anion-exchange sorbents. Application to extraction of polyphenols prior to their quantitation by UHPLC with ion-trap mass spectrometry detection

Fractionating the Flavonoids in Lonicerae japonicae Flos and Lonicerae flos via Solvent Extraction Coupled with Automated Solid-Phase Extraction

Due to the structural diversity of flavonoids in functional plant foods and the inherent limitations of existing techniques, it is important to develop a simple and green (environmentally friendly) method of extracting flavonoids from plant foods. In this study, a method involving solvent extraction followed by automated solid-phase extraction was developed for extracting flavonoids from Lonicerae japonicae flos (JYH) and Lonicerae flos (SYH), both of which are widely used functional plant-based foods in Asian countries. For the optimisation of the solvent extraction method, solvent concentration (0.0, 20.0, 40.0, 60.0, 80.0 and 100.0% (v/v) of ethanol-water solution), extraction temperature (40, 60 and 80 °C) and extraction time (15.0, 30.0, 60.0, 90.0 and 120.0 min) were evaluated via design of experiment after screening. For solid-phase extraction, five cartridges (Strata-X, InertSep RP-2, InertSep RP-C18, Bond Elut-ENV, Oasis Prime HLB) were evaluated and different elution steps were optimised to obtain high recoveries (79.69-140.67%) for eight target flavonoids, including rutin, isoquercetin and luteolin. Antioxidant capacity assays revealed that JYH samples demonstrated superior antioxidant potential compared to SYH. The optimised extraction method provides a valuable tool for industrial-scale flavonoid production.

Dendrimer Coated Silica as a Sorbent for Dispersive Solid-Phase Extraction of Select Non-Steroidal Anti-Inflammatory Drugs from Water

Non-steroidal anti-inflammatory drugs (NSAIDs) have been recognized as a potentially serious threat to the natural environment. NSAIDs are popular painkillers, and the main pathway for them to reach natural water is via discharge from wastewater and sewage treatment plants. In order to monitor contamination caused by these drugs, as well as their impact on the environment, a new material based on Silica Gel 60, functionalized with a dendrimeric copolymer of methylamine and 1,4-butanediol diglycidyl ether (named MA-BDDE), was prepared. Initial physicochemical characterization of the MA-BDDE material was carried out using ATR FT-IR spectroscopy as well as solid-state carbon-13 NMR spectroscopy. Its effectiveness at NSAID extraction was evaluated by the application of five select drugs in dispersive solid-phase extraction (dSPE): aspirin, ketoprofen, naproxen, diclofenac and ibuprofen. This was followed by their simultaneous determination using the HPLC-UV/Vis system demonstrating good sensitivity, with limits of detection values within the 63-265 ng mL-1 range. A comparison of the sorption capacity of each pharmaceutical with unmodified base silica showed an at least tenfold increase in capacity after modification. Initial MA-BDDE application in a quick, low-waste extraction procedure of those select NSAIDs from spiked surface water samples yielded promising results for its use as a sorbent, as recovery values of analytes adsorbed from various samples were found to exceed 72%.

Recent advances of ordered mesoporous silica materials for solid-phase extraction

This review mainly focuses on the development and application of ordered mesoporous silica materials for solid-phase extraction in recent years. It overviews not only bare mesoporous silica but also the functionalized mesoporous silica with organic groups, molecularly imprinted polymers, and magnetic materials. These mesoporous silica materials were used as the extraction adsorbents in cartridge solid-phase extraction, dispersive solid-phase extraction, magnetic solid-phase extraction, micro-solid-phase extraction and matrix solid phase dispersion. Coupled with atomic emission spectrometry, chromatography or other detection methods, these techniques efficiently extracted and sensitively determined various targets, such as metal ions, perfluorocarboxylic acids, pesticides, drugs, endocrine disruptors, phenols, flavanones, polycyclic aromatic hydrocarbons, parabens and so on. Based on unique advantages of mesoporous silica materials, the developed analytical method successfully analyzed different matrix samples, like environmental water samples, soil samples, food samples, biological samples and cosmetics. In addition, the prospects of these materials in solid-phase extraction are presented, which can offer an outlook for the further development and applications.

Single enrichment systems possibly underestimate both exposures and biological effects of organic pollutants from drinking water

Comprehensive enrichment of contaminants in drinking water is an essential step for accurately determining exposure levels of contaminants and testing their biological effects. Traditional methods using a single absorbent for enriching contaminants in water might not be adequate for complicated matrices with different physical-chemical profiles. To examine this hypothesis, we used an integrated enrichment system that had three sequential stages-XAD-2 resin, poly (styrene-divinylbenzene) and activated charcoal to capture organic pollutants and disinfection by-products (DBPs) from drinking water in Shanghai. Un-adsorbed Organic Compounds in Eluates (UOCEs) named UOCEs-A, -B, and-C following each adsorption stage were determined by gas chromatography-mass spectrometry to evaluate adsorption efficiency of the enrichment system. Meanwhile, biological effects such as cytotoxicity, effects on reactive oxygen species (ROS) generation and glutathione (GSH) depletion were determined in human LO2 cells to identify potential adverse effects on exposure to low dose contaminants. We found that poly-styrene-divinylbenzene (PS-DVB) and activated charcoal (AC) could still partly collect UOCEs-A and-B that the upper adsorption column incompletely captured, and that potential carcinogens like 2-naphthamine were present in all eluates. UOCEs-A at (1-4000), UOCEs-B at (1000-4000), and UOCEs-C at (2400-4000) folds of the actual concentrations had significant cytotoxicity to LO2 cells. Additionally, ROS and GSH change in cells treated with UOCEs indicated the potential for long-term effects of exposure to some mixtures of contaminants such as DBPs at low doses. These results suggested that an enriching system with a single adsorbent would underestimate the exposure level of pollutants and the biological effects of organic pollutants from drinking water. Effective methods for pollutants' enrichment and capture of drinking water should be given priority in future studies on accurate evaluation of biological effects exposed to mixed pollutants via drinking water.

Hypercrosslinked polymer microspheres decorated with anion- and cation-exchange groups for the simultaneous solid-phase extraction of acidic and basic analytes from environmental waters

Mixed-mode ion-exchange sorbents were introduced to improve the selectivity and retention of solid-phase extraction (SPE) sorbents. Mixed-mode ion-exchange sorbents integrate reversed-phase chemistry with ion-exchange groups to promote favourable interactions with ionic species. Nevertheless, a need to extract analytes with acidic and basic properties simultaneously within the same SPE cartridge led to the introduction of novel amphoteric/zwitterionic sorbents, which incorporate cation- and anion-exchange moieties within the same functional group attached to the polymeric network. In the present study, the development, preparation and SPE evaluation of two novel hypercrosslinked zwitterionic polymeric sorbents, functionalised with either strong anion-exchange (SAX) and weak cation-exchange (WCX) or weak anion-exchange (WAX) and strong cation-exchange (SCX) groups (namely HXLPP-SAX/WCX and the HXLPP-WAX/SCX), is presented for the simultaneous retention of acidic and basic compounds. The sorbents were prepared by a precipitation polymerisation route which yielded poly(divinylbenzene-co-vinylbenzylchloride) as a precursor polymer; subsequently, the precursor polymer was hypercrosslinked, to increase the specific surface areas and capacities of the sorbents, and then functionalised to impart the zwitterionic character. The HXLPP-SAX/WCX sorbent was decorated with quaternised sarcosine groups and the HXLPP-WAX/SCX sorbent was decorated with taurine moieties. The SPE parameters were optimised to exploit the ionic interactions between compounds and the functional groups. The optimal conditions involve a washing step to remove the compounds retained by hydrophobic interactions, thus increasing the selectivity. The optimised SPE protocol used the quaternised sarcosine-based sorbent followed by liquid chromatography and tandem mass spectrometry, and was applied to determine compounds with acidic and basic properties from environmental samples, such as river water and effluent wastewater samples, with excellent selectivity and matrix effect values below -30% and apparent recovery results ranging from 52% to 105% for most of the compounds. The analytical method was validated for environmental water samples and used in the analysis of samples in which some of the target compounds were found at ng L^-1 concentration levels.

Sulfonic Acid-Functionalized SBA-15 as Strong Cation-Exchange Sorbent for Solid-Phase Extraction of Atropine and Scopolamine in Gluten-Free Grains and Flours

A novel method was developed and applied to the determination of the most representative tropane alkaloids (TAs), atropine and scopolamine, in gluten-free (GF) grains and flours by HPLC-MS/MS. Accordingly a suitable sample treatment procedure based on solid-liquid extraction (SLE) and followed by strong cation-exchange solid-phase extraction (SCX-SPE) was optimized. SBA-15 mesostructured silica functionalized with sulfonic acids was evaluated as sorbent. The proposed method was fully validated in sorghum flour showing good accuracy with recoveries in the range of 93–105%, good linearity (R² > 0.999) and adequate precision (RSD < 20%). Low method quantification limits (MQL) were obtained (1.5 and 2.4 µg/kg for atropine and scopolamine, respectively) and no matrix effect was observed thanks to the extraction and clean-up protocol applied. The method was applied to 15 types of GF samples of pseudocereals (buckwheat, quinoa and amaranth), cereals (teff, corn and blue corn, sorghum and millet) and legumes (red and green lentil, chickpea and pea). Atropine was found above the MQL in eight of them, with values between 7 and 78 µg/kg, while scopolamine was only found in teff flour, its concentration being 28 µg/kg. The method developed is an interesting tool for determining TAs in a variety of samples of GF grains and flours.

Recent Materials Developed for Dispersive Solid Phase Extraction

Solid phase extraction (SPE) is an analytical procedure developed with the purpose of separating a target analyte from a complex sample matrix prior to quantitative or qualitative determination. The purpose of such treatment is twofold: elimination of matrix constituents that could interfere with the detection process or even damage analytical equipment as well as enriching the analyte in the sample so that it is readily available for detection. Dispersive solid phase extraction (dSPE) is a recent development of the standard SPE technique that is attracting growing attention due to its remarkable simplicity, short extraction time and low requirement for solvent expenditure, accompanied by high effectiveness and wide applicability. This review aims to thoroughly survey recently conducted analytical studies focusing on methods utilizing novel, interesting nanomaterials as dSPE sorbents, as well as known materials that have been only recently successfully applied in dSPE techniques, and evaluate their performance and suitability based on comparison with previously reported analytical procedures.

Synthesis and chromatographic evaluation of a new stationary phase based on mild thiol-Michael addition reaction

Click chemistry has attracted increasing attention for the synthesis of novel stationary phases. Considering the advantage of click chemistry, a strategy based on thiol-Michael addition was developed for the preparation of a new stationary phase herein, and a phenyl vinyl sulfone stationary phase (M-PVS) was prepared. The resulting M-PVS bonded silica was characterized by elemental analysis, solid-state ¹³C cross-polarization/magic-angle spinning NMR and infrared spectroscopy, confirming the successful immobilization of phenyl vinyl sulfone on the silica support. The retention properties of M-PVS were investigated and exhibited unambiguous reversed phase retention characteristics. Moreover, shape selectivity and silanol activity were studied to reveal the diverse interactions of M-PVS, including hydrophobic, π-π, hydrogen bonding, and ion-exchange interactions. In addition, de-wetting tolerance and hydrophilic properties were evaluated and a pronounced "U" retention curves were obtained, indicating enhanced retention for polar analytes and transitions of different interaction modes. Selectivity differences between M-PVS column, phenyl column and conventional C₁₈ column were examined using series natural standards. The diverse interactions of M-PVS demonstrated its improved selectivity for the compounds with similar hydrophobic skeleton but different polar substituents.

Determination of Kanamycin by High Performance Liquid Chromatography

Kanamycin is an aminoglycoside antibiotic widely used in treating animal diseases caused by Gram-negative and Gram-positive infections. Kanamycin has a relatively narrow therapeutic index, and can accumulate in the human body through the food chain. The abuse of kanamycin can have serious side-effects. Therefore, it was necessary to develop a sensitive and selective analysis method to detect kanamycin residue in food to ensure public health. There are many analytical methods to determine kanamycin concentration, among which high performance liquid chromatography (HPLC) is a common and practical tool. This paper presents a review of the application of HPLC analysis of kanamycin in different sample matrices. The different detectors coupled with HPLC, including Ultraviolet (UV)/Fluorescence, Evaporative Light Scattering Detector (ELSD)/Pulsed Electrochemical Detection (PED), and Mass Spectrometry, are discussed. Meanwhile, the strengths and weaknesses of each method are compared. The pre-treatment methods of food samples, including protein precipitation, liquid-liquid extraction (LLE), and solid-phase extraction (SPE) are also summarized in this paper.