Single-Shell Carbon Nanotubes Covered with Iron Nanoparticles for Ion-Lithium Batteries: Thermodynamic Stability and Charge Transfer

Graphene/Fe3O4 Nanocomposite as a Promising Material for Chemical Current Sources: A Theoretical Study

The outstanding mechanical and conductive properties of graphene and high theoretical capacity of magnetite make a composite based on these two structures a prospective material for application in flexible energy storage devices. In this study using quantum chemical methods, the influence of magnetite concentration on energetic and electronic parameters of graphene/Fe₃O₄ composites is estimated. It is found that the addition of magnetite to pure graphene significantly changes its zone structure and capacitive properties. By varying the concentration of Fe₃O₄ particles, it is possible to tune the capacity of the composite for application in hybrid and symmetric supercapacitors.

The UV Effect on the Chemiresistive Response of ZnO Nanostructures to Isopropanol and Benzene at PPM Concentrations in Mixture with Dry and Wet Air

Towards the development of low-power miniature gas detectors, there is a high interest in the research of light-activated metal oxide gas sensors capable to operate at room temperature (RT). Herein, we study ZnO nanostructures grown by the electrochemical deposition method over Si/SiO2 substrates equipped by multiple Pt electrodes to serve as on-chip gas monitors and thoroughly estimate its chemiresistive performance upon exposing to two model VOCs, isopropanol and benzene, in a wide operating temperature range, from RT to 350 °C, and LED-powered UV illumination, 380 nm wavelength; the dry air and humid-enriched, 50 rel. %, air are employed as a background. We show that the UV activation allows one to get a distinctive chemiresistive signal of the ZnO sensor to isopropanol at RT regardless of the interfering presence of H2O vapors. On the contrary, the benzene vapors do not react with UV-illuminated ZnO at RT under dry air while the humidity’s appearance gives an opportunity to detect this gas. Still, both VOCs are well detected by the ZnO sensor under heating at a 200–350 °C range independently on additional UV exciting. We employ quantum chemical calculations to explain the differences between these two VOCs’ interactions with ZnO surface by a remarkable distinction of the binding energies characterizing single molecules, which is −0.44 eV in the case of isopropanol and −3.67 eV in the case of benzene. The full covering of a ZnO supercell by H2O molecules taken for the effect’s estimation shifts the binding energies to −0.50 eV and −0.72 eV, respectively. This theory insight supports the experimental observation that benzene could not react with ZnO surface at RT under employed LED UV without humidity’s presence, indifference to isopropanol.

SCC-DFTB Parameters for Fe-C Interactions

We present an optimized density-functional tight-binding (DFTB) parameterization for iron-based complexes based on the popular trans3d set of parameters. The transferability of the original and optimized parameterizations is assessed using a set of 50 iron complexes, which include carbonyl, cyanide, polypyridine, and cyclometalated ligands. DFTB-optimized structures predicted using the trans3d parameters show a good agreement with both experimental crystal geometries and density functional theory (DFT)-optimized structures for Fe-N bond lengths. Conversely, Fe-C bond lengths are systematically overestimated. We improve the accuracy of Fe-C interactions by truncating the Fe-O repulsive potential and reparameterizing the Fe-C repulsive potential using a training set of six isolated iron complexes. The new trans3d*-LANLFeC parameter set can produce accurate Fe-C bond lengths in both geometry optimizations and molecular dynamics (MD) simulations, without significantly affecting the accuracy of Fe-N bond lengths. Moreover, the potential energy curves of Fe-C interactions are considerably improved. This improved parameterization may open the door to accurate MD simulations at the DFTB level of theory for large systems containing iron complexes, such as sensitizer-semiconductor assemblies in dye-sensitized solar cells, that are not easily accessible with DFT approaches because of the large number of atoms.