Closing the loop in a constructed wetland for the improvement of metal removal: the use of Phragmites australis biomass harvested from the system as biosorbent

Submerged zone and vegetation drive distribution of heavy metal fractions and microbial community structure: Insights into stormwater biofiltration system

Biofiltration system is a widely used stormwater treatment option that is effective in removing heavy metals. The concentration and distribution of heavy metal fractions in biofiltration filter media, as well as the microbiota composition affected by the design parameters, are relatively novel concepts that require further research. A laboratory-scale column study was conducted to investigate the microbial community and the fractionation of heavy metals (Pb, Cu, Cr, and Cd) extracted from filter media samples, subjected to the presence of vegetation, submerged zone (SZ), and major environmental parameters (pH, water content). Sequential extractions revealed that, compared to the three other fractions (exchangeable fraction, reducible fraction, and oxidizable fraction), the residual fraction was the most represented for each metal (41 - 82 %). As a result, vegetation was found to reduce pH value, and significantly decrease the concentration of the exchangeable fraction of Pb in the middle layer, and the oxidizable fraction of Pb, Cu, Cd, and Cr in the middle and bottom layers (p < 0.05). The formation of an anoxic environment by submerged zone settlements resulted in a significant decrease in the concentration of reducible fractions and a significant increase in the concentration of oxidizable fractions for four heavy metals (p < 0.05). In addition, the analysis of the microbiota showed that the diversity and richness of microorganisms increased in the presence of SZ and plants. The dominant phylum in biofiltration was Proteobacteria, followed by Firmicutes, Bacteroidetes, Acidobacteria, and Actinobacteria as major phyla. Heavy metal fractions could regulate the structure of microbial communities in biofiltration. The findings of this study would enrich our understanding of the improvement of multi-metal-contaminated runoff treatment and highlight the impact of design parameters and heavy metal fractionation on microbial community structure in the biofiltration system.

Effect of Wastewater on the Composition of Bacterial Microbiota of Phragmites australis Used in Constructed Wetlands for Phytodepuration

Phytodepuration occurs in the plant-mediated remediation processes exploited to remove pollutants from wastewater, and Phragmites australis is one of the most used plants. This goal is achieved using constructed wetlands (CW), which are engineered systems designed to mimic the natural processes of pollutants removal. The aim of this work was to characterize the bacterial communities associated to P. australis, soils, and permeates of the CW of Calice (Prato, Italy), to evaluate the possible effect of wastewaters on the CW bacterial communities, through a next-generation sequencing-based approach. A total of 122 samples were collected from different tissues of P. australis (i.e., roots, aerial parts, and stem), soil (i.e., rhizospheric and bulk soil), and permeates, and analyzed. All samples were collected during five sampling campaigns, with the first one performed before the activation of the plant. Obtained results highlighted a specific microbiota of P. australis, conserved among the different plant tissues and during time, showing a lower alpha diversity than the other samples and not influenced by the more complex and variable environmental (soils and permeates) bacterial communities. These data suggest that P. australis is able to select and maintain a defined microbiota, a capacity that could allow the plant to survive in hostile environments, such as that of CW.

Two constructed wetlands within a Mediterranean natural park immersed in an agrolandscape reduce most heavy metal water concentrations and dampen the majority of pesticide presence

The water concentrations of 12 heavy and other metals/metalloids were analyzed seasonally along two horizontal-flow constructed wetlands (CWs) (Tancat Mília-TM and Tancat l'Illa-TLI) located within the Mediterranean Albufera de València Natural Park during 2020-2021. A wide-scope screening of pesticides present in waters was also performed. The two CWs were created to improve water quality and increase biodiversity. They currently receive effluent waters from two different tertiary-treatment wastewater plants, and the water flows along the CWs before being discharged into the main lagoon and a smaller lagoon in TM and TLI, respectively. TLI manages to reduce (Mn) or maintain the concentration of most of the studied elements (Zn, Ni, Hg, Cr, Fe Cd, Cu) at the same level as outside (67%). Only Al, Pb, B, and As remain at a higher concentration. TM also reduces Zn and Cu and keeps the concentration of Cr, Cd, and Hg (representing 42%). Al, Pb, B, and As remain at higher concentrations, as in TLI, but Ni, Fe, and Mn are also at higher concentrations. Although both CWs vary in their ability to remove elements, no risks to human health or the environment have been detected due to the low metal concentration in their outlets, all of them (except Hg) below the legal limits for environmental quality in the European Union. With the detection of 71 compounds in water in each CW area (26 herbicides, 26 insecticides, and 19 fungicides in TLI, and 29 herbicides, 23 insecticides, and 19 fungicides in TM), we also provide evidence of the impact of pesticides, which depends on the application method (helicopter, tractor), originated from areas with high agricultural pressure (chiefly rice crops) on systems (mainly TM) created to preserve biodiversity. Nevertheless, both systems provide crucial environmental services in water quality in this agrolandscape.

New insights into the pollutant composition of stormwater treating wetlands

With intensified climate change and urbanisation, constructed wetland (CW) serves as an alternative to conventional wastewater treatment plants. In Australia, the primary function of CW is to reduce sediments, nutrients from runoffs and attenuate floods. However, water quality analysis after construction is limited, hence, pollutant composition in established CWs and target pollutants in many guidelines remain outdated. To refresh the understanding of pollutants in urban discharges, this study reviewed two CWs in industrialised regions of Victoria, Australia. A total number of 26 pollutants were analysed in the collected water and sediment samples from both CW. The findings highlighted excessive concentrations of Zinc, Aluminium, Iron and Copper in one wetland and less commonly found pollutants like Barium, Titanium and Strontium are also detected. While Arsenic, Zinc, Copper, Nickel and hydrocarbons' accumulations are particularly significant in the other wetland. This study also reviews the pollutants discovered in 136 stormwater wetlands and covers the sources and impacts of various metal pollutants in stormwater runoffs. Overall, it is found that the concentrations of Zinc, Aluminium and Iron are particularly high in the CWs reviewed. This study brings attention to the pollutants profile of established CWs and the impact of heavy metals on the aquatic environment. The findings from this research revealed that the existing design and management guidelines for constructed wetlands in urban catchments are lacking in reduction targets for metal pollutants, thus improvements are essential to safeguard the water quality and performance of CWs.

Potential Use of Constructed Wetland Systems for Rural Sanitation and Wastewater Reuse in Agriculture in the Moroccan Context

Located in a semi-arid to arid region, Morocco is confronting increasing water scarcity challenges. In the circular economy paradigm, the reuse of treated wastewater in agriculture is currently considered a possible solution to mitigate water shortage and pollution problems. In recent years, Morocco has made significative progress in urban wastewater treatment under the National Wastewater Program (PNA). However, rural sanitation has undergone significant delays. Therefore, an alternative technology for wastewater treatment and reuse in rural areas is investigated in this review, considering the region’s economic, social, and regulatory characteristics. Constructed wetlands (CWs) are a simple, sustainable, and cost-effective technology that has yet to be fully explored in Morocco. CWs, indeed, appear to be suitable for the treatment and reuse of wastewater in remote rural areas if they can produce effluent that meets the standards of agricultural irrigation. In this review, 29 studies covering 16 countries and different types of wastewater were collected and studied to assess the treatment efficiency of different types of CWs under different design and operational parameters, as well as their potential application in agricultural reuse. The results demonstrated that the removal efficiency of conventional contamination such as organic matter and suspended solids is generally high. CWs also demonstrated a remarkable capacity to remove heavy metals and emerging contaminants such as pharmaceuticals, care products, etc. The removal of microbial contamination, on the other hand, is challenging, and does not satisfy the standards all the time. However, it can be improved using hybrid constructed wetlands or by adding polishing treatment. In addition, several studies reported that CWs managed to produce effluent that met the requirements of wastewater reuse in agriculture of different countries or organisations including Morocco.

Mechanistic understanding of the pollutant removal and transformation processes in the constructed wetland system

Constructed wetland systems (CWs) are biologically and physically engineered systems to mimic the natural wetlands which can potentially treat the wastewater from the various point and nonpoint sources of pollution. The present study aims to review the various mechanisms involved in the different types of CWs for wastewater treatment and to elucidate their role in the effective functioning of the CWs. Several physical, chemical, and biological processes substantially influence the pollutant removal efficiency of CWs. Plants species Phragmites australis, Typha latifolia, and Typha angustifolia are most widely used in CWs. The rate of nitrogen (N) removal is significantly affected by emergent vegetation cover and type of CWs. Hybrid CWs (HCWS) removal efficiency for nutrients, metals, pesticides, and other pollutants is higher than a single constructed wetland. The contaminant removal efficiency of the vertical subsurface flow constructed wetlands (VSSFCW) commonly used for the treatment of domestic and municipal wastewater ranges between 31% and 99%. Biochar/zeolite addition as substrate material further enhances the wastewater treatment of CWs. Innovative components (substrate materials, plant species) and factors (design parameters, climatic conditions) sustaining the long-term sink of the pollutants, such as nutrients and heavy metals in the CWs should be further investigated in the future. PRACTITIONER POINTS: Constructed wetland systems (CWs) are efficient natural treatment system for on-site contaminants removal from wastewater. Denitrification, nitrification, microbial and plant uptake, sedimentation and adsorption are crucial pollutant removal mechanisms. Phragmites australis, Typha latifolia, and Typha angustifolia are widely used emergent plants in constructed wetlands. Hydraulic retention time (HRT), water flow regimes, substrate, plant, and microbial biomass substantially affect CWs treatment performance.