Determination of Antimony Speciation in Cow Milk Using Dispersive Micro-solid Phase Extraction Based on Fibrous TiO2@g-C3N4 Nanocomposites and ICP-MS After Sample Pretreatment by Artificial Gastric Juice

Ultrasound assisted dispersive solid phase microextraction using polystyrene-polyoleic acid graft copolymer for determination of Sb(III) in various bottled beverages by HGAAS

A new polyoleic acid-polystyrene (PoleS) block/graft copolymer was synthesized and applied as adsorbent for ultrasound assisted dispersive solid phase microextraction (UA-DSPME) of Sb(III) in different bottled beverages and analysis using hydride generation atomic absorption spectrometry (HGAAS). Adsorption capacity of the PoleS was 150 mg g^-1. Several sample preparation parameters such as sorbent amount, solvent type, pH, sample volume and shaking time were optimized (based on central composite design (CCD) approach) and evaluated in respect to the recovery of Sb(III). The method revealed a high tolerance limit of matrix ions presence. Under optimized conditions, linearity range, the limit of detection, the limit of quantitation, extraction recovery, enhancement factor, preconcentration factor were 5-800 ng L^-1, 1.5 ng L^-1, 5.0 ng L^-1, 96%, 82, 90, respectively. Accuracy of the UA-DSPME method was confirmed based on different certified reference materials and standard addition method. Factorial design was utilized to estimate the influences of variables of recovery of Sb(III).

Detection of trace antimony by vanadium (IV) ion assisted photochemical vapor generation with inductively coupled plasma mass spectrometry measurement

In this work, a method for sensitive detection of trace antimony (Sb) was developed by inductively coupled plasma mass spectrometry (ICP MS) coupled with photochemical vapor generation (PVG). V(IV) ions were used as new "sensitizers" for improving the PVG efficiency of Sb. Factors influenced the PVG and the detection of Sb by ICP MS were investigated, including the type and concentration of low molecular weight organic acids, the UV irradiation time, the concentration of V(IV) ions, the air-liquid interface, the flow rate of Ar carrier gas, and interferences from co-existing ions. It was found that efficient reduction of Sb was obtained in the medium of 10% (v/v) formic acid (FA), 10% (v/v) acetic acid (AA), and 80 mg L^-1 of V(IV) with 100 s UV irradiation. Under the selected conditions, there was no significant difference in analytical sensitivity between Sb(III) and Sb(V). The limit of detection (LOD, 3σ) was 4.7 ng L^-1 for Sb with ICP MS measurement. Compared to traditional direct solution nebulization, the analytical sensitivity obtained in this work was enhanced about 19-fold. Relative standard deviations (RSDs, n = 7) were 1.9% and 2.3% for replicate measurement of 0.5 μg L^-1 Sb(III) and Sb(V) standard solutions, respectively. The proposed method was applied for the determination of trace Sb in water samples and two certified reference materials (CRMs) of sediments with satisfactory results. Moreover, the generated volatile species of Sb in this work was found to be (CH₃)₃Sb.

In-syringe solid phase extraction and in-syringe vortex-assisted solidified floating organic drop microextraction of Sb(III) and Sb(V) in rice wines with determination by graphite furnace atomic absorption spectrometry

The current non-chromatographic speciation methods generally involve the conversion of different species by oxidation/reduction reactions, which may cause inherent problems such as contamination risk, time consumption and complex operations. In this work, in-syringe solid phase extraction (IS-SPE) was combined with in-syringe vortex-assisted solidified floating organic drop microextraction (IS-VA-SFODME) for the detection of Sb(V) and Sb(III) in rice wines by graphite furnace atomic absorption spectrometry. Firstly, IS-SPE involved the use of ZnFe₂O₄ nanotubes as the sorbent for the isolation and enrichment of Sb(V) and removal of the matrix components such as ethanol, pigment, sugars and carbohydrates. Then, IS-VA-SFODME was used for enriching Sb(III) in the original sample solution after IS-SPE. This technique exhibited good anti-interference ability and high enrichment efficiency without tedious pre-oxidation/pre-reduction and centrifugation/filtration operations, which may cause the contamination of samples. Under the selected conditions, the detection limits were 4.5 ng L^-1 and 3.2 ng L^-1 for Sb(III) and Sb(V) with relative standard deviations of 7.3% and 5.1%, respectively. This procedure was used with satisfactory results for the detection of Sb(III) and Sb(V) in rice wine samples and a certified reference material of water sample. Recoveries of spiked experiments ranged from 91.0 to 107%.

Magnetic dispersive micro-solid phase extraction coupled with dispersive liquid-liquid microextraction followed by graphite furnace atomic absorption spectrometry for quantification of Se(IV) and Se(VI) in food samples

In this work, magnetic dispersive micro-solid phase extraction (MDMSPE) coupled with dispersive liquid-liquid microextraction (DLLME) was developed for Se(IV) and Se(VI) followed by graphite furnace atomic absorption spectrometry. MDMSPE involved the use of magnetic ZnFe₂O₄ nanotubes for adsorbing Se(VI). The sorbent was isolated from aqueous phase by using an external magnetic field instead of tedious centrifugation or filtration. In the following step, Se(IV) in the upper aqueous phase of MDMSPE was enriched by DLLME. Samples were prepared with artificial gastric juice to avoid the inter-conversion of target species. The main factors affecting the determination of the analytes were studied in detail. the detection limits of this method were 1.0 and 1.3 pg mL^-1 for Se(IV) and Se(VI) with relative standard deviations of 4.6% and 5.1% (c = 1.0 ng mL^-1, n = 9), respectively. An enrichment factor of 200 was obtained. This method was used for the detection of Se(IV) and Se(VI) in food samples without any pre-oxidation or pre-reduction operation. A certified reference material of milk powder was analysed by this method, and the determined values were in good agreement with the certified values. Recoveries of spike experiments were in the range of 91.0-107%.

Application of Metallic Nanoparticles and Their Hybrids as Innovative Sorbents for Separation and Pre-concentration of Trace Elements by Dispersive Micro-Solid Phase Extraction: A Minireview

It is indisputable that separation techniques have found their rightful place in current analytical chemistry, considering the growing complexity of analyzed samples and (ultra)trace concentration levels of many studied analytes. Among separation techniques, extraction is one of the most popular ones due to its efficiency, simplicity, low cost and short processing times. Nonetheless, research interests are directed toward the enhancement of performance of these procedures in terms of selectivity. Dispersive solid phase extraction (DSPE) represents a novel alternative to conventional solid phase extraction (SPE) which not only delivers environment-friendly extraction with less solvent consumption, but also significantly improves analytical figures of merit. A miniaturized modification of DSPE, known as dispersive micro-solid phase extraction (DMSPE), is one of the most recent trends and can be applied for the extraction of wide variety of analytes from various liquid matrices. While DSPE procedures generally use sorbents of different origin and sizes, in DMSPE predominantly nanostructured materials are required. The aim of this paper is to provide an overview of recently published original papers on DMSPE procedures in which metallic nanoparticles and hybrid materials containing metallic particles along with other (often carbon-based) constituent(s) at the nanometer level have been utilized for separation and pre-concentration of (ultra)trace elements in liquid samples. The studies included in this review emphasize the great analytical potential of procedures producing reliable results in the analysis of complex liquid matrices, where the detection of target analyte is often complicated by the presence of interfering substances.