Enhancing Microalgal Biomass Productivity in Floating Photobioreactors with Semi-Permeable Membranes Grafted with 4-Hydroxyphenethyl Bromide

Integrating wind-driven agitating blade into a floating photobioreactor to enhance fluid mixing and microalgae growth

Aiming at optimizing the poor fluid mixing state in the traditional horizontal floating photobioreactors and reducing the high energy consumption and operational cost induced by electric-driven mixing, a novel floating photobioreactor with an embedded wind-driven agitating blade (WDAB-FPBR) was proposed in this study, which can effectively utilize both wind and wave energy for fluid mixing. The results show that the selected wind-driven agitating blade contributed to a decrement of 75.3% in mixing time and an increment of 87.5% in mass transfer coefficient, and meanwhile strengthened the fluid velocity along the light gradient. Owing to the enhanced fluid flow and mixing properties, an even distribution of algae cells was achieved in the WDAB floating photobioreactor, which resulted in an improvement of 140% in the photosynthesis efficiency of microalgae. From this, the biomass yield and carbon removal ratio showed an increment of 88.9% and 73.9%, respectively.

Seawater supplemented with bicarbonate for efficient marine microalgae production in floating photobioreactor on ocean: A case study of Chlorella sp

Cultivation of microalgae on ocean provides a promising way to produce massive biomass without utilizing limited land space, and using seawater as culture medium can avoid consumption of valuable fresh water. Bicarbonate is proved as a better approach for carbon supply in microalgae cultivation, but Ca²⁺ and Mg²⁺ in seawater is subjected to precipitate with carbonate derived from it. In this study, cultivation with this medium for a marine Chlorella sp. resulted in productivity of 0.470 g L^-1 day^-1, despite of continual precipitation caused by increased pH due to bicarbonate consumption. Actually, this precipitation is favorable, since it can work as a flocculation harvesting method for microalgae. The highest flocculation efficiency of 98.9 ± 0.0% was observed in cultures with 7.0 g L^-1 NaHCO₃, which was higher than that of cultures without bicarbonate (44.1 ± 0.2%). Additionally, the spent medium after flocculation supported better growth (1.60 ± 0.0 g L^-1) than the fresh medium (1.26 ± 0.0 g L^-1). Outdoor cultivation with floating photobioreactor on ocean resulted in the productivity of 0.190 g L^-1 day^-1, which was higher than that in land-based culture systems. The floating system also benefited from better temperature control with range from 20.6 to 37.2 °C, due to solar heating and surrounding water cooling. These results showed feasibility of efficient microalgae biomass production with fully utilizing of ocean resources, including culture medium preparation and temperature control with seawater, as well as wave energy for mixing, holding great potential to produce massive biomass to support sustainable development of human society.