Hypoxia enhances osteogenic differentiation in retinoic acid-treated murine-induced pluripotent stem cells

Effect of Octacalcium Phosphate on Osteogenic Differentiation of Induced Pluripotent Stem Cells in a 3D Hybrid Spheroid Culture

Octacalcium phosphate (OCP) has been shown to exhibit an osteogenic property and, therefore, has been utilized recently as a bone substitute, clinically. However, the stimulatory capacity for induced pluripotent stem (iPS) cells is not known. This study investigated whether OCP enhances osteoblastic differentiation of three-dimensionally cultured spheroids of iPS cells compared to hydroxyapatite (HA) and β-tricalcium phosphate (β-TCP). Mouse iPS cells were mixed with smaller (less than 53 μm) or larger (300-500 μm) sizes of calcium phosphate (CaP) granules and cultured in a laboratory-developed oxygen-permeable culture chip under minimizing hypoxia for up to 21 days. Osteoblastic differentiation was estimated by the cellular alkaline phosphatase (ALP) activities. The degree of supersaturation (DS) with respect to CaP phases was determined from the media chemical compositions. Incubated CaP materials were characterized by Fourier transform infrared spectroscopy (FTIR) and X-ray diffraction (XRD). The culture promoted well the formation of hybrid spheroids of CaP materials and iPS cells regardless of the type of materials and their granule sizes. The ALP activity of OCP was about 1.5 times higher than that of β-TCP and HA in smaller granule sizes. FTIR, XRD, and DS analyses showed that larger OCP granules tended to hydrolyze to HA slightly faster than smaller granules with time while HA and β-TCP materials tended to remain unchanged. In conclusion, the results suggest that OCP enhances the osteogenic differentiation of iPS cells more than HA and β-TCP through a mechanism of hydrolyzing to HA. This inherent material property of OCP is essential for enhancing the osteoblastic differentiation of iPS cells.

Recent advances in layer-by-layer assembly scaffolds for co-delivery of bioactive molecules for bone regeneration: an updated review

Orthopedic implants have faced challenges in treating bone defects due to various factors, including inadequate osseointegration, oxidative stress, bacterial infection, immunological rejection, and poor individualized treatment. These challenges profoundly affect both the results of treatment and patients' daily lives. There is great promise for the layer-by-layer (LbL) assembly method in tissue engineering. The method primarily relies on electrostatic attraction and entails the consecutive deposition of electrolyte complexes with opposite charges onto a substrate, leading to the formation of homogeneous single layers that can be quickly deposited to produce nanolayer films. LbL has attracted considerable interest as a coating technology because of its ease of production, cost-effectiveness, and capability to apply diverse biomaterial coatings without compromising the primary bio-functional properties of the substrate materials. This review will look into the fundamentals and evolution of LbL in orthopedics, provide an analysis of the chemical strategy used to prepare bone implants with LbL and introduce the application of LbL bone implants in orthopedics over recent years. Among the many potential uses of LbL, such as the implementation of sustained-release and programmed drug delivery, which in turn promotes the osseointegration and the development of new blood vessels, as well as antibacterial, antioxidant, and other similar applications. In addition, we offer a thorough examination of cell behavior and biomaterial interaction to facilitate the advancement of next-generation LbL films for tissue engineering.

Intermittent compressive force induces cell cycling and reduces apoptosis in embryoid bodies of mouse induced pluripotent stem cells

In vitro manipulation of induced pluripotent stem cells (iPSCs) by environmental factors is of great interest for three-dimensional (3D) tissue/organ induction. The effects of mechanical force depend on many factors, including force and cell type. However, information on such effects in iPSCs is lacking. The aim of this study was to identify a molecular mechanism in iPSCs responding to intermittent compressive force (ICF) by analyzing the global gene expression profile. Embryoid bodies of mouse iPSCs, attached on a tissue culture plate in 3D form, were subjected to ICF in serum-free culture medium for 24 h. Gene ontology analyses for RNA sequencing data demonstrated that genes differentially regulated by ICF were mainly associated with metabolic processes, membrane and protein binding. Topology-based analysis demonstrated that ICF induced genes in cell cycle categories and downregulated genes associated with metabolic processes. The Kyoto Encyclopedia of Genes and Genomes database revealed differentially regulated genes related to the p53 signaling pathway and cell cycle. qPCR analysis demonstrated significant upregulation of Ccnd1, Cdk6 and Ccng1. Flow cytometry showed that ICF induced cell cycle and proliferation, while reducing the number of apoptotic cells. ICF also upregulated transforming growth factor β1 (Tgfb1) at both mRNA and protein levels, and pretreatment with a TGF-β inhibitor (SB431542) prior to ICF abolished ICF-induced Ccnd1 and Cdk6 expression. Taken together, these findings show that TGF-β signaling in iPSCs enhances proliferation and decreases apoptosis in response to ICF, that could give rise to an efficient protocol to manipulate iPSCs for organoid fabrication.

Cobalt chloride, a chemical hypoxia-mimicking agent, suppresses myoblast differentiation by downregulating myogenin expression

Cobalt chloride can create hypoxia-like state in vitro (referred to as chemical hypoxia). Several studies have suggested that chemical hypoxia may cause deleterious effects on myogenesis. The intrinsic underlying mechanisms of myoblast differentiation, however, are not fully understood. Here, we show that cobalt chloride strongly suppresses myoblast differentiation in a dose-dependent manner. The impaired myoblast differentiation is accompanied by downregulation of myogenic regulatory factor myogenin. Under chemical hypoxia, myogenin stability is decreased at mRNA and protein levels. A muscle-specific E3 ubiquitin ligase MAFbx, which can target myogenin protein for proteasomal degradation, is upregulated along with changes in Akt/Foxo and AMPK/Foxo signaling pathways. A proteasome inhibitor completely prevents cobalt chloride-mediated decrease in myogenin protein. These results suggest that cobalt chloride might modulate myogenin expression at post-transcriptional and post-translational levels, resulting in the failure of the myoblasts to differentiate into myotubes.

Determining Osteogenic Differentiation Efficacy of Pluripotent Stem Cells by Telomerase Activity

Background

Bone tissue engineering based on pluripotent stem cells (PSCs) is a new approach to deal with bone defects. Protocols have been developed to generate osteoblasts from PSCs. However, the low efficiency of this process is still an important issue that needs to be resolved. Many studies have aimed to improve efficiency, but developing accurate methods to determine efficacy is also critical. Studies using pluripotency to estimate efficacy are rare. Telomerase is highly associated with pluripotency.

Methods

We have described a quantitative method to measure telomerase activity, telomeric repeat elongation assay based on quartz crystal microbalance (QCM). To investigate whether this method could be used to determine the efficiency of in vitro osteogenic differentiation based on pluripotency, we measured the pluripotency pattern of cultures through stemness gene expression, proliferation ability and telomerase activity, measured by QCM.

Results

We showed that the pluripotency pattern determined by QCM was similar to the patterns of proliferation ability and gene expression, which showed a slight upregulation at the late stages, within the context of the general downregulation tendency during differentiation. Additionally, a comprehensive gene expression pattern covering nearly every stage of differentiation was identified.

Conclusion

Therefore, this assay may be powerful tools for determining the efficiency of differentiation systems based on pluripotency. In this study, we not only introduce a new method for determining efficiency based on pluripotency, but also provide more information about the characteristics of osteogenic differentiation which help facilitate future development of more efficient protocols.

Deferoxamine loaded titania nanotubes substrates regulate osteogenic and angiogenic differentiation of MSCs via activation of HIF-1α signaling

To develop biomaterials for inducing osteogenic and angiogenic differentiation of mesenchymal stem cells (MSCs) is crucial for bone repair. In this study, we employed titania nanotubes (TNT) as drug nanoreservoirs to load deferoxamine (DFO), and then deposited chitosan (Chi) and gelatin (Gel) multilayer as coverage structure via layer-by-layer (LBL) assembly technique, resulting in TNT-DFO-LBL substrates. Scanning electron microscopy (SEM), atomic force microscopy (AFM), X-ray photoelectron spectroscopy (XPS) and contact angle measurements were employed to characterize the physical and chemical properties of the substrates. The results proved the successful fabrication of multilayer coating on TNT array. DFO released from the TNT arrays in a sustained manner. The drug-device combination titanium (Ti) substrates positively improved the adhesion, proliferation, osteogenic/angiogenic differentiation of MSCs and mediated the growth behavior of human umbilical vein endothelial cells (HUVECs). Moreover, the TNT-DFO-LBL substrates up-regulated osteogenic and angiogenic differentiation related genes expression of MSCs by activating HIF-1α signaling pathway. The approach presents here has a potential impact on the development of high quality Ti-based orthopedic implants.