Three-dimensional force model of the low-back for simple computer programming

Biomechanical analysis of reducing sacroiliac joint shear load by optimization of pelvic muscle and ligament forces

Effective stabilization of the sacroiliac joints (SIJ) is essential, since spinal loading is transferred via the SIJ to the coxal bones, and further to the legs. We performed a biomechanical analysis of SIJ stability in terms of reduced SIJ shear force in standing posture using a validated static 3-D simulation model. This model contained 100 muscle elements, 8 ligaments, and 8 joints in trunk, pelvis, and upper legs. Initially, the model was set up to minimize the maximum muscle stress. In this situation, the trunk load was mainly balanced between the coxal bones by vertical SIJ shear force. An imposed reduction of the vertical SIJ shear by 20% resulted in 70% increase of SIJ compression force due to activation of hip flexors and counteracting hip extensors. Another 20% reduction of the vertical SIJ shear force resulted in further increase of SIJ compression force by 400%, due to activation of the transversely oriented M. transversus abdominis and pelvic floor muscles. The M. transversus abdominis crosses the SIJ and clamps the sacrum between the coxal bones. Moreover, the pelvic floor muscles oppose lateral movement of the coxal bones, which stabilizes the position of the sacrum between the coxal bones (the pelvic arc). Our results suggest that training of the M. transversus abdominis and the pelvic floor muscles could help to relieve SI-joint related pelvic pain.

A biomechanical model on muscle forces in the transfer of spinal load to the pelvis and legs

Based on musculoskeletal anatomy of the lower back, abdominal wall, pelvis and upper legs, a biomechanical model has been developed on forces in the load transfer through the pelvis. The aim of this model is to obtain a tool for analyzing the relations between forces in muscles, ligaments and joints in the transfer of gravitational and external load from the upper body via the sacroiliac joints to the legs in normal situations and pathology. The study of the relation between muscle coordination patterns and forces in pelvic structures, in particular the sacroiliac joints, is relevant for a better understanding of the aetiology of low back pain and pelvic pain. The model comprises 94 muscle parts, 6 ligaments and 6 joints. It enables the calculation of forces in pelvic structures in various postures. The calculations are based on a linear/non-linear optimization scheme. To gain a better understanding of the function of individual muscles and ligaments, deviant properties of these structures can be preset. The model is validated by comparing calculations with EMG data from the literature. For agonistic muscles, good agreement is found between model calculations and EMG data. Antagonistic muscle activity is underestimated by the model. Imposed activity of modelled antagonistic muscles has a minor effect on the mutual proportions of agonistic muscle activities. Simulation of asymmetric muscle weakness shows higher activity of especially abdominal muscles.

Loads on the body during static tasks: software incorporating the posture targetting method

The biomechanical evaluation of loads on the body is one of the tools that facilitate the assessment of manual handling tasks. A computer program has been developed to determine moments about joints during static tasks. It differentiates between flexion/ extension, rotation and adduction/abduction requirements so that the major efforts can be identified and compared with population strength data. It also evaluates loads on the spine and within low-back muscles for purposes of comparison with many manual handling studies. Posture and a variety of external forces are input to the system with a choice of two interchangeable methods: one uses a 'CODA' scanner for on-line posture recording in the laboratory, the other is 'posture targetting', a pen-and-paper method adapted for the computer.