Interaction forces between κ-casein adsorbed on mica

Atomic Force Microscopy Study of the Topography and Nanomechanics of Casein Micelles Captured by an Antibody

Casein micelles (CMs) are colloidal phospho-protein-mineral complexes naturally present in milk. This study used atomic force microscopy (AFM) in a liquid environment to evaluate the topography and nanomechanics of single native CMs immobilized by a novel capture method. The proposed immobilization method involves weak interactions with the antiphospho-Ser/Thr/Tyr monoclonal antibody covalently bound to a carboxylic acid self-assembled monolayer (SAM) on a gold surface. This capture strategy was compared to the commonly used covalent immobilization method of CMs via carbodiimide chemistry. With this conventional method, CMs remained mainly mobile during AFM measurements in liquid, disturbing the evaluation of their average size and elastic properties. Conversely, when captured by the specific antibody, they were successfully immobilized and their integrity was preserved during the AFM measurement. The characterization of both CM topography and elastic properties was carried out in a liquid ionic environment at native pH 6.6. The CMs' capture efficiency via antibody was concurrently proved by surface plasmon resonance. The calculation of casein micelles' width, height, and contact angle was carried out from the recorded 2D AFM images. CMs were characterized by a mean width of 148 ± 8 nm and a mean height of 42 ± 1 nm. Weak forces were applied to single captured CMs. The obtained force versus indentation curves were fitted using the Hertz model in order to evaluate their elastic properties. The elasticity distribution of native CMs exhibited a unimodal trend with a peak centered at 269 ± 14 kPa.

Friction force spectroscopy of β- and κ-casein monolayers

Friction force spectroscopy (FFS) has been applied to study the tribological properties of β- and κ-casein layers on hydrophobic substrates in aqueous solutions. Nanometer-sized imaging tips were employed. This allowed exerting and determining the high pressures needed to remove the layers and registering the topographic evolution during this process. Both β- and κ-casein layers showed similar and not particularly high initial frictional responses (friction coefficient of ∼1 when measured with a silicon nitride tip). The pressures needed to remove the layers were of the same order of magnitude for both proteins, ∼10(8) Pa, but slightly higher for those composed of β-casein. The technique has also shown to be useful in studying the two-dimensional lateral diffusion of the proteins and the wear on the layers they form.

Hierarchical networks of casein proteins: an elasticity study based on atomic force microscopy

2D- and 3D-atomic force microscopy (AFM) experiments were performed on single casein micelles (CM) in native state, submerged in liquid, using a home-built AFM instrument. The micelles were immobilized via carbodiimide chemistry to a self-assembled monolayer supported on gold-coated slides. Off-line data analysis allowed the extraction of both surface topography and elastic properties. Relative Young moduli (E*) were derived from force-vs-indentation curves, using the Hertz theory. The obtained E* values were found to increase with CM diameter, following a straight line dependence. The data showed that temperature, via its influence on both the protein-protein interactions and the composition of the micelle, has a clear effect on the mechanical properties of the CMs: higher temperatures and lower serum casein concentrations result in stiffer micelles. For pH < or = 5.6, effecting calcium phosphate release from the micelles by decreasing the pH does not have a large effect on CM stiffness. On decrease of the pH below 5.0, particulate gels and multilayers were obtained. Their measured elasticity (expressed by an equivalent G'AFM) agrees remarkably well with the storage moduli as measured with a conventional rheometer. Compared to single micelles, gels from nonheated CM suspensions are about 3 orders of magnitude softer. The "softness" of these gels (measured under compression or shear) therefore must come from the microscopic and/or mesoscopic links rather than the micelles themselves.

Detection and characterization of individual intermolecular bonds using optical tweezers

The development of scanning probe techniques has made it possible to examine protein-protein interactions at the level of individual molecular pairs. A calibrated optical tweezers, along with immunoglobulin G (IgG)-coated polystyrene microspheres, has been used to detect individual surface-linked Staphylococcus protein A (SpA) molecules and to characterize the strength of the noncovalent IgG-SpA bond. Microspheres containing, on average, less than one IgG per contact area were held in the optical trap while an SpA-coated substrate was scanned beneath them at a distance of approximately 50 nm. This geometry allows the trapped bead to make contact with the surface, from bond formation to rupture, and results in an enhancement of the force applied to a bond due to leverage supplied by the bead itself. Experiments yielded median single-bond rupture forces from 25 to 44 pN for IgG from four mammalian species, in general agreement with predictions based on free energies of association obtained from solution equilibrium constants.