Conversion of steam-exploded cedar into ethanol using simultaneous saccharification, fermentation and detoxification process

Two-Stage Pretreatment of Jerusalem Artichoke Stalks with Wastewater Recycling and Lignin Recovery for the Biorefinery of Lignocellulosic Biomass

Jerusalem artichoke (Helianthus tuberosus L.) is emerging as one of the energy plants considered for biofuel production. Alkali and alkali-involved pretreatment methods have been widely used for the bioconversion of cellulosic materials due to their high sugar yield and low inhibitor release. However, the recovery and treatment of wastewater (black liquor) have been poorly studied. Here, we present a novel two-stage pretreatment process design for recycling black liquor. Jerusalem artichoke stalk (JAS) was first treated with 2% (w/v) NaOH, after which lignin was recovered by H2SO4 at pH 2.0 from the black liquor. The recycled solutions were subsequently used to treat the NaOH-pretreated JAS for the second time to dissolve hemicellulose. CO-pretreated JAS, hydrolysates, and acid-insoluble lignin were obtained after the above-mentioned two-stage pretreatment. A reducing sugar yield of 809.98 mg/g Co-pretreated JAS was achieved after 48 h at 5% substrate concentration using a cellulase dosage of 25 FPU/g substrate. In addition, hydrolysates containing xylose and acid-insoluble lignin were obtained as byproducts. The pretreatment strategy described here using alkali and acid combined with wastewater recycling provides an alternative approach for cellulosic biorefinery.

Fate of antibiotic resistance genes in cultivation substrate and its association with bacterial communities throughout commercial production of Agaricus bisporus

Animal manure is an important raw material for Agaricus bisporus production; however, it is also a reservoir for antibiotic residues, antibiotic resistance genes (ARGs), and antibiotic-resistant bacteria. Little is known about the influence of the commercial cultivation of A. bisporus on the dynamics of ARGs and the underlying mechanisms that cause their variations. In this study, we investigated the fate of 285 ARGs, 10 mobile genetic elements, and seven major categories of antibiotic residues in substrate and mushroom samples at different production phases. The results showed that commercial substrate preparation, particularly the pasteurization phase, was highly efficient in removing ARGs from the substrate. We further found that mycelium proliferation of A. bisporus contributed significantly to the removal of ARGs from the substrate and casing soil. The bacterial community is the key driver of changes in ARGs during the commercial cultivation of A. bisporus, which explained 46.67% of the variation in ARGs. Our results indicate that, despite the addition of animal manure, the risk of ARG dissemination to fruiting bodies and the environment is low. We propose that bioremediation by specific edible fungi might be a novel and promising method for scavenging antimicrobial resistance contamination from soil environment.

Biopolymers modulate microbial communities in municipal organic waste digestion

The development of biopolymers has raised issues about their recalcitrance in the environment. Their disposal is mainly carried out with the organic fraction of municipal solid waste (OFMSW) through thermophilic anaerobic digestion and aerobic composting, bioprocesses aimed at turning organic matter into biogas and compost. However, the effects of biopolymers on OFMSW treatment, on the final compost and on the microbial communities involved are partly unexplored. In this study, the OFMSW treatment was reproduced on a laboratory-scale respecting real plant conditions and testing the impacts of mixing polylactic acid (PLA) and starch-based bioplastic (SBB) separately. The dynamics of bacterial, archaeal and fungal communities during the process was screened by high-throughput sequencing (HTS) of phylogenetic amplicons. Starch-based bioplastic showed a minor and heterogeneous microbial diversity between the anaerobic and aerobic phases. Contrariwise, PLA treatment resulted in wider and more diverse bacterial and fungal communities for the compost and the aerobic biofilm. Since the biodiversity in compost may play a crucial role in its stability and safety, the modulation of environmental microbial communities induced by higher concentrations of PLA in OFMSW treatment can pose relevant issues.

Optimisation of glucose and levulinic acid production from the cellulose fraction of giant reed (Arundo donax L.) performed in the presence of ferric chloride under microwave heating

A two-step exploitation of the giant reed cellulose to glucose and levulinic acid, after the complete removal of the hemicellulose fraction, was investigated using FeCl₃ as catalyst. In the first step, the microwave-assisted hydrolysis of cellulose to glucose was optimised by response surface methodology analysis, considering the effect of temperature, reaction time and catalyst amount. Under the optimised reaction conditions, the glucose yield was 39.9 mol%. The cellulose-rich residue was also converted by enzymatic hydrolysis, achieving the glucose yield of 39.8 mol%. The exhausted residue deriving from the chemical hydrolysis was further converted to levulinic acid by microwave treatment at harsher reaction conditions. The maximum levulinic acid yield was 64.3 mol%. On the whole, this cascade approach ensured an extensive and sustainable exploitation of the C6 carbohydrates to glucose and levulinic acid, corresponding to about 70 mol% of glucan converted to these valuable bioproducts in the two steps.

Development of sequential and simultaneous bacterial cultures to hydrolyse and detoxify wood pre-hydrolysate for enhanced acetone-butanol-ethanol (ABE) production

The use of microorganisms is a promising option for an eco-efficient and successful conversion of hardwood hemicelluloses to biofuels. The focus of this work is the treatment of hemicellulosic pre-hydrolysate by flocculation, followed by simultaneous or separate detoxification with Ureibacillus thermosphaericus and Cupriavidus taiwanensis co-culture, and hydrolysis with Paenibacillus campinasensis. A reduction of phenolic compounds was achieved mainly after flocculation, applied as a first detoxification step, but no increase in sugars concentration was observed. The ABE fermentation of the hydrolysate obtained from the simultaneous hydrolysis and detoxification produced 6.8 g L^-1 of butanol after 116 h, which was higher than that generated with xylose synthetic medium. The higher biofuel concentration in the hydrolysate is attributed to the existence of carbon sources, other than xylose.

Microwave-assisted cascade exploitation of giant reed (Arundo donax L.) to xylose and levulinic acid catalysed by ferric chloride

The present work aimed to investigate and optimize the selective exploitation of hemicellulose and cellulose fractions of the energy crop Arundo donax L. (giant reed), to give xylose and levulinic acid, respectively. In order to improve the sustainability of this process, a microwave-assisted hydrolysis in the presence of FeCl₃ was implemented using as substrate the raw biomass without any pretreatment process. The effects of the hydrolysis reaction conditions, such as temperature, reaction time, salt amount and biomass loading, on giant reed exploitation were investigated. In the first step, under the optimized conditions (150 °C, 2.5 min and 1.6 wt% FeCl₃), the xylose yield reached 98.2 mol%. In the second step, under the best conditions (190 °C, 30 min and 2.4 wt% FeCl₃), the levulinic acid yield was 57.6 mol%. This novel cascade approach ensured an extensive exploitation of giant reed polysaccharides working in the respect of Green Chemistry principles.

Complete Genome Sequence of Ureibacillus thermosphaericus A1, a Thermophilic Bacillus Isolated from Compost

Ureibacillus thermosphaericus A1 was isolated from compost collected in Munakata City, Fukuoka Prefecture, Japan. Here, we report the first complete genome sequence of U. thermosphaericus. The complete genome of this strain consists of 3,488,104 bp with a GC content of 36.3% and comprises 3,362 predicted coding sequences.

Optimization of Bioethanol Production Using Whole Plant of Water Hyacinth as Substrate in Simultaneous Saccharification and Fermentation Process

Water hyacinth was used as substrate for bioethanol production in the present study. Combination of acid pretreatment and enzymatic hydrolysis was the most effective process for sugar production that resulted in the production of 402.93 mg reducing sugar at optimal condition. A regression model was built to optimize the fermentation factors according to response surface method in saccharification and fermentation (SSF) process. The optimized condition for ethanol production by SSF process was fermented at 38.87°C in 81.87 h when inoculated with 6.11 ml yeast, where 1.291 g/L bioethanol was produced. Meanwhile, 1.289 g/L ethanol was produced during experimentation, which showed reliability of presented regression model in this research. The optimization method discussed in the present study leading to relatively high bioethanol production could provide a promising way for Alien Invasive Species with high cellulose content.

Enzymatic saccharification and bioethanol production from Cynara cardunculus pretreated by steam explosion

The correct choice of the specific lignocellulosic biomass pretreatment allows obtaining high biomass conversions for biorefinery implementations and cellulosic bioethanol production from renewable resources. Cynara cardunculus (cardoon) pretreated by steam explosion (SE) was involved in second-generation bioethanol production using separate hydrolysis and fermentation (SHF) or simultaneous saccharification and fermentation (SSF) processes. Steam explosion pretreatment led to partial solubilisation of hemicelluloses and increased the accessibility of residual polysaccharides towards enzymatic hydrolysis revealing 64% of sugars yield against 11% from untreated plant material. Alkaline extraction after SE pretreatment of cardoon (CSEOH) promoted partial removal of degraded lignin, tannins, extractives and hemicelluloses thus allowing to double glucose concentration upon saccharification step. Bioethanol fermentation in SSF mode was faster than SHF process providing the best results: ethanol concentration 18.7 g L(-1), fermentation efficiency of 66.6% and a yield of 26.6g ethanol/100 g CSEOH or 10.1 g ethanol/100 g untreated cardoon.