Hydrothermal alkali pretreatment contributes to fermentative methane production of a typical lipid from food waste through co-production of hydrogen with methane

A sustainable synthesis of polyhydroxyalkanoate from stubble waste as a carbon source using Pseudomonas putida MTCC 2475

Polyhydroxyalkanoates (PHAs) are biodegradable polymers that can be produced from lignocellulosic biomass by microorganisms. Cheap and readily available raw material, such as corn stover waste, has the potential to lessen the cost of PHA synthesis. In this research study, corn stover is pretreated with NaOH under conditions optimized for high cellulose and low lignin with central composite design (CCD) followed by characterization using Fourier-transform infrared spectroscopy (FTIR), thermal gravimetric analysis (TGA), and scanning electron microscopy (SEM). Design expert software performed further optimization of alkali pretreated corn stover for high total reducing sugar (TRS) enhancement using CCD using response surface methodology (RSM). The optimized condition by RSM produced a TRS yield of 707.19 mg/g. Fermentation using corn stover hydrolysate by Pseudomonas putida MTCC 2475 gave mcl-PHA detected through gas c hromatography - t andem m ass s pectrometry (GC-MS/MS) and characterization of the PHA film by differential scanning calorimetry (DSC), FTIR, and nuclear magnetic resonance (NMR). Thus, this research paper focuses on using agriculture (stubble) waste as an alternative feedstock for PHA production.

Sustainable management of food waste; pre-treatment strategies, techno-economic assessment, bibliometric analysis, and potential utilizations: A systematic review

Food waste (FW) contains many nutritional components such as proteins, lipids, fats, polysaccharides, carbohydrates, and metal ions, which can be reused in some processes to produce value-added products. Furthermore, FW can be converted into biogas, biohydrogen, and biodiesel, and this type of green energy can be used as an alternative to nonrenewable fuel and reduce reliance on fossil fuel sources. It has been demonstrated in many reports that at the laboratory scale production of biochemicals using FW is as good as pure carbon sources. The goal of this paper is to review approaches used globally to promote turning FW into useable products and green energy. In this context, the present review article highlights deeply in a transdisciplinary manner the sources, types, impacts, characteristics, pre-treatment strategies, and potential management of FW into value-added products. We find that FW could be upcycled into different valuable products such as eco-friendly green fuels, organic acids, bioplastics, enzymes, fertilizers, char, and single-cell protein, after the suitable pre-treatment method. The results confirmed the technical feasibility of all the reviewed transformation processes of FW. Furthermore, life cycle and techno-economic assessment studies regarding the socio-economic, environmental, and engineering aspects of FW management are discussed. The reviewed articles showed that energy recovery from FW in various forms is economically feasible.

Increasing the organic loading rate of household food waste anaerobic digestion by landfill leachate addition: Performance and mechanism

A high amount of easily degradable organics and the absence of trace metals (TMs) in household food waste (HFW) lowered the stability and efficiency of anaerobic digestion (AD) of HFW. Leachate addition to the AD of HFW can provide ammonia nitrogen and TMs to address the accumulation of volatile fatty acids and the lack of TMs. To study the effect of leachate addition on increasing organic loading rate (OLR), both mono-digestion of HFW and AD of HFW with leachate addition were evaluated using two continuously stirred tank reactors. The OLR of the mono-digestion reactor only reached 2.5 g COD/L/d. However, with the addition of ammonia nitrogen and TMs, the OLR of the failed mono-digestion reactor increased by 2 and 3.5 g COD/L/d, respectively. The specific methanogenic activity increased by 94.4% and the hydrolysis efficiency increased by 135%. Finally, the OLR of mono-digestion of HFW reached 8 g COD/L/d, with a hydraulic retention time (HRT) of 8 days and methane production rate of 2.4 L/L/d. In the leachate addition reactor, the OLR reached 15 g COD/L/d, while the HRT and methane production were 7 days and 3.4 L/L/d, respectively. This study demonstrates that leachate addition substantially improves the AD efficiency of HFW. The two main mechanisms of increasing the OLR of an AD reactor are the buffer capacity of ammonia nitrogen and the stimulation of methanogen by TMs from leachate.

Role of hydrothermal pretreatment towards sustainable biorefinery

Recently, the world is experiencing a shift from petroleum refineries to biorefineries due to fossil fuel depletion and environmental concerns. To achieve sustainable development of biorefineries and other components of the biofuel production process, eco-friendly and cost-effective approaches are necessary. Therefore, lignocellulosic biomass (LCB) must be exploited in biorefineries for the generation of a broad spectrum of products. The complex structure of LCB prevents its direct saccharification by enzymatic means, so pretreatment is necessary. There are several pretreatment technologies for disrupting the lignocellulosic structure, but hydrothermal pretreatment is the leading pretreatment technology for recovering hemicellulose fraction with a low number of inhibitors and an increased amount of cellulose. The severity of hydrothermal pretreatment plays a principal role in affecting cellulose, hemicellulose, and lignin structure. A detailed account of microwave-assisted hydrothermal pretreatment technologies and the cost-effectiveness, eco-friendliness, and upcoming challenges of this technology for commercialization with the probable solution is presented.

Comprehensive Review of Hydrothermal Pretreatment Parameters Affecting Fermentation and Anaerobic Digestion of Municipal Sludge

Municipal solid waste treatment and disposal have become one of the major concerns in waste management due to the excessive production of waste and higher levels of pollution. To address these challenges and protect the environment in sustainable ways, the hydrothermal pretreatment (HTP) technique coupled with anaerobic digestion (AD) becomes a preferred alternative technology that can be used for municipal solid waste stabilization and the production of renewable energy. However, the impact of HTP parameters such as temperature, retention time, pH, and solid content on the fermentation of TWAS is yet to be well studied and analyzed. Hence this study was conducted to review the effect of hydrothermal pretreatment of thickened waste-activated sludge (TWAS) on fermentation and anaerobic digestion processes. Many studies reported that fermentation of TWAS at pretreatment temperature ranges from 160 °C to 180 °C resulted in a 50% increase in volatile fatty acid (VFA) yields compared to no pretreatment. However, for the AD process, HTP in the range of 175 °C to 200 °C with a 30–60 min retention time was considered the optimal condition for higher biogas production, with 30% increase in biodegradability and greater than 55% increase in biogas production. Even though there is a direct relationship between increased HTP temperature and the hydrolysis of TWAS, a pretreatment temperature range beyond 200 °C alters the biogas production. The solid content (SC) of sludge plays a crucial role in HTP, where in practice up to 16% SC has been utilized for HTP. Further, a combined alkaline-HTP enhances the process performance.

Microbial electrochemical degradation of lipids for promoting methane production in anaerobic digestion

In order to solve problems of low methane production from lipids in anaerobic digestion, microbial electrochemical degradation was proposed to promote methane yield of glycerol trioleate (a typical lipid component of food waste). The beta-oxidation of lipids was strengthened with an applied voltage to promote electron transfer and anaerobic digestion. SEM images showed that a lot of spherical and rod-shaped microbes adhered to electrode surfaces. Cyclic voltammetry showed that electron transfer rate constant at 0.8 V was 14.4-fold that at 0 V. Three-dimensional fluorescence spectroscopy showed that small organic degraded molecules were used more efficiently in anaerobic digestion. The methane yield of glycerol trioleate increased to 791.6 mL/g-TVS (at 0.8 V), while methane production peak rate increased to 26.8 mL/g-TVS/d with a shortened peak time to 24th day. The overall energy conversion efficiency in methane production increased from 53.6 to 60.1% due to microbial electrochemical degradation of lipids.

The effect of aqueous phase recirculation on hydrothermal liquefaction/carbonization of biomass: A review

Aqueous phase (AP) recirculation is attracting increasing interest in hydrothermal process field as it has the potential to increase the yield of bio-crude and/or hydrochar and decrease the cost of hydrothermal wastewater disposal. This work summarizes the effect of AP recirculation on hydrothermal processing biomass, including the discussions on the mechanisms account for the increased yield and the changing properties of the hydrochar and bio-crude. However, the application of AP recirculation in hydrothermal process is limited by the enrichment of nitrogen in bio-crude and the applicability of only specific biomass type. To alleviate these limitations, the feasibility of combining AP recirculation with other strategies (e.g., co-solvent and co-feed) has been discussed. The possibility of using AP as a resource (e.g., nutrient source, and material mediator) can be increased by AP recirculation due to the accumulation of substances.