Carbonaceous materials for removal and recovery of phosphate species: Limitations, successes and future improvement

Sustainable adsorbent frameworks based on bio-resourced materials and biodegradable polymers in selective phosphate removal for waste-water remediation

Phosphorus to an optimum extent is an essential nutrient for all living organisms and its scarcity may cause food security, and environmental preservation issues vis-à-vis agroeconomic hurdles. Undesirably excess phosphorus intensifies the eutrophication problem in non-marine water bodies and disrupts the natural nutrient balance of the ecosystem. To overcome such dichotomy, biodegradable polymer-based adsorbents have emerged as a cost-effective and implementable approach in striking a "desired optimum-undesired excess" balance pertaining to phosphate in a sustainable manner. So far, the reports on adopting such adsorbent-approach for wastewater remediation remained largely scattered, unstructured, and poorly correlated. In this background, the contextual review comprehensively discusses the current state-of-the-art in utilizing biodegradable polymeric frameworks as an adsorbent system for phosphate removal and its efficient recovery from the aquatic ecosystem, while highlighting their characteristics-specific functional efficiency vis-à-vis easiness of synthetic and commercial viability. The overview further delves into the sources and environmental ramifications of excessive phosphorus in water bodies and associated mechanistic pathways of phosphorus removal via adsorption, precipitation, and membrane filtration enabled by biodegradable (natural and synthetic) polymeric substrates. Finally, functionality optimization, degradability tuning, and adsorption selectivity of biodegradable polymers are highlighted, while aiming to strike a balance in "removal-recovery-reuse" dynamics of phosphate. Thus, the current review not only paves the way for future exploration of biodegradable polymers in sustainable cost-effective adsorbents for phosphorus removal but also can serve as a guide for researchers dealing with this critical issue.

Advances in lignin-based biosorbents for sustainable wastewater treatment

The heavy metals, pesticides and dyes in agriculture and industry caused serious water pollution have increased the urgency for the advancement of biomass-based adsorbents due to their merits of low cost, high efficiency, and environmental sustainability. Thus, this review systematically examines the recent progress of lignin-based adsorbents dedicated to wastewater purification. Commencing with a succinct exposition on the intricate structure and prevalent forms of lignin, the review proceeds to expound rational design strategies tailored for lignin-based adsorbents coupled with adsorption mechanisms and regeneration methods. Emphasis is placed on the potential industrial applications of lignin-based adsorbents, accentuating their capacity for recovery and direct utilization post-use. The future challenges and outlooks associated with lignin-based adsorbents are discussed to provide novel perspectives for the development of high-performance and sustainable biosorbents, facilitating the effective removal of pollutants and the value-added utilization of resources in a sustainable manner.

Phosphorus removal from water by the metal-organic frameworks (MOFs)-based adsorbents: A review for structure, mechanism, and current progress

Efficacious phosphate removal is essential for mitigating eutrophication in aquatic ecosystems and complying with increasingly stringent phosphate emission regulations. Chemical adsorption, characterized by simplicity, prominent treatment efficiency, and convenient recovery, is extensively employed for profound phosphorus removal. Metal-organic frameworks (MOFs)-derived metal/carbon composites, surpassing the limitations of separate components, exhibit synergistic effects, rendering them tremendously promising for environmental remediation. This comprehensive review systematically summarizes MOFs-based materials' properties and their structure-property relationships tailored for phosphate adsorption, thereby enhancing specificity towards phosphate. Furthermore, it elucidates the primary mechanisms influencing phosphate adsorption by MOFs-based composites. Additionally, the review introduces strategies for designing and synthesizing efficacious phosphorus capture and regeneration materials. Lastly, it discusses and illuminates future research challenges and prospects in this field. This summary provides novel insights for future research on superlative MOFs-based adsorbents for phosphate removal.

Towards engineering mitigation of leaching of Cd and Pb in co-contaminated soils using metal oxide-based aerogel composites and biochar

Applications of metal-based nanomaterials for the remediation of heavy metal (HM) contaminated environments are of great importance. The ability of metal oxide-based carbon aerogel composite to immobilize HMs in multi-metal contaminated soils has not yet been investigated, particularly under acidic conditions. Herein, we investigate the performance of metal oxides (Sr0.7 Mn0.3 Co0.5 Fe0.5O3-δ)-based carbon aerogel composite (MO-CAg) compared with coconut coil fiber biochar (CCFB) and carbon aerogel (CAg) for Cd and Pb immobilization in contaminated soil. The MO-CAg, applied at 2% (w/w), significantly decreased Pb leaching by 67-75% and Cd by 60-65%, CAg decreased Cd by 54% and Pb by 46%, while biochar decreased Cd by 40-44% and Pb by 43%. The addition of MO-CAg altered Cd and Pb geochemical fractions by increasing their residual fraction, i.e., stabilized both metals compared to the control. This presents a comprehensive elaboration on the probable reaction interactions between the MO-Cag and heavy metals, including a combination of (co)precipitation, and reduction-oxidation as the predominant mechanisms of metal stabilization with MO-CAg. Moreover, MO-CAg increased Pb and Cd stabilization in soils by strengthening the bonding between metal oxides and Cd/Pb. By imbedding MO into the CAg, in MO-CAg, the immobilization of Cd(II) and Pb(II) occurred through inner-sphere complexation, while with CCFB and CAg metals, immobilization occurred through outer-sphere complexation. MO-CAg is a promising and highly efficient material that could be recommended for the remediation of Cd- and Pb-contaminated soils in subsequent studies.

Feasibility of electrodeionization for phosphate removal

In this study, electrodeionization (EDI) in bath mode was tested regarding its capability to remove phosphate (PO4 3- ) ions from aqueous solutions. Various parameters affecting the phosphate removal rate via EDI were determined. The results showed that the phosphate removal rate depends on the applied voltage and that the optimum potential was 15 V, corresponding to a phosphate removal rate of 97%. Changing the stream rate of the phosphate-containing solution also affected the phosphate removal rate. Changing the pH of the phosphate-containing solution from 2 to 6 enhanced the phosphate removal rate from 80% to 97%. The presence of Cl- , NO3 - , and SO4 2- ions did not affect the phosphate removal rate. The highest mass transfer coefficient (k) of phosphate was calculated to be 7.85 × 10-4  m/s, and the flux was calculated to be 3.72 × 10-4  mol/m2  s1 at a flow velocity of 3 L/h. Thus, the study results showed the feasibility of EDI as an alternative membrane process for removing phosphate from aqueous solutions. PRACTITIONER POINTS: Electrodeionization was employed for the removal of phosphate. The removal of phosphate exhibited dependence on applied potential. EDI demonstrated a remarkable 97% efficiency in phosphate removal. The pH of the solution was found to influence the removal rate.

Bamboo-derived adsorbents for environmental remediation: A review of recent progress

The bamboo family of plants is one of the fastest-growing species in the world. As such, there is an abundance of bamboo residues available for exploitation, especially in southeast Asian, central African and south American regions. The preparation of efficient adsorbents from bamboo residues is an emerging exploitation pathway. Biochars, activated carbons or raw bamboo fibers embedded with nanoparticles, each class of materials has been shown to be highly efficient in adsorption processes. This review aims to summarize recent findings in the application of bamboo-based adsorbents in the removal of organic, inorganic, or gaseous pollutants. Therefore, this review first discusses the preparation methods and surface modification methodologies and their effects on the adsorbent elemental content and other basic properties. The following sections assess the recent progress in the adsorption of heavy metals, organics, and gaseous substances by bamboo-based adsorbents, focusing on the optimum adsorption capacities, adsorption mechanisms and the optimum-fitting kinetic models and isotherms. Finally, research gaps were identified and directions for future research are proposed.

Photo-Fenton self-cleaning carbon fibers membrane supported with Zr-MOF@Fe2O3 for effective phosphate removal from algae-rich water

Adsorbents featuring abundant binding sites and high affinity to phosphate have been used to resolve water eutrophication. However, most of the developed adsorbents were focused on improving the adsorption ability of phosphate but ignored the effect of biofouling on the adsorption process especially used in the eutrophic water body. Herein, a novel MOF-supported carbon fibers (CFs) membrane with high regeneration and antifouling capability, was prepared by in-situ synthesis of well-dispersed MOF on CFs membrane, to remove phosphate from algae-rich water. The hybrid UiO-66-(OH)₂@Fe₂O₃@CFs membrane exhibits a maximum adsorption capacity of 333.3 mg g^-1 (pH 7.0) and excellent selectivity for phosphate sorption over coexisting ions. Moreover, the Fe₂O₃ nanoparticles anchored on the surface of UiO-66-(OH)₂ through 'phenol-Fe(III)' reaction can endow the membrane with the robust photo-Fenton catalytic activity, which improves long-term reusability even under algae-rich condition. After 4 times photo-Fenton regenerations, the regeneration efficiency of the membrane could remain 92.2%, higher than that of hydraulic cleaning (52.6%). Moreover, the growth of C. pyrenoidosa was significantly reduced by 45.8% within 20 days via metabolism inhibition due to membrane-induced P-deficient conditions. Hence, the developed UiO-66-(OH)₂@Fe₂O₃@CFs membrane holds significant prospects for large-scale application in phosphate sequestration of eutrophic water bodies.

NiFe2O4/g-C3N4 heterostructure with an enhanced ability for photocatalytic degradation of tetracycline hydrochloride and antibacterial performance

In this work, NiFe₂O₄/g-C₃N₄ heterostructure was prepared and used for the photocatalytic decomposition of tetracycline hydrochloride antibiotic and for inactivation of E. coli bacteria. The fabricated NiFe₂O₄/g-C₃N₄ composite displayed enhanced ability for photodegradation of organic pollutants and disinfection activities compared to the bare samples, because of the enhancement of visible light absorbance, heterojunction formation and photo-Fenton process. The optimized sample 10%-NiFe₂O₄/g-C₃N₄ has photodegraded 94.5% of tetracycline hydrochloride in 80 min. The active species trapping experiments revels that ·O₂^-, h⁺ and •OH are key decomposing species participated in the antibiotic degradation. It is hoped that the present study will provide a better understanding to fabricate efficient photocatalysts for the decomposition of organic pollutants and disinfection of bacteria.

Synthesis of MgAl-LDH@ZIF-8 composites by in situ growth method for highly efficient phosphate removal

Removal of phosphate from wastewater by adsorption has become one of the effective ways to mitigate the negative effects of eutrophication in water bodies, and efficient adsorbent is the key....