Rapid and sensitive analytical method for the determination of amoxicillin and related compounds in water meeting the requirements of the European union watch list

Modeling approach for Ti3C2 MXene-based fluorescent aptasensor for amoxicillin biosensing in water matrices

Amoxicillin, a member of the penicillin family, is primarily utilized for the treatment of various bacterial infections affecting ears, nose, throat, urinary tract, and skin. Given its widespread application in medicine, agriculture, environment, and food industry, the precise and sensitive detection of amoxicillin is important. This study introduces a novel approach to developing a sensitive and selective fluorescent aptasensor relying on fluorescence resonance energy transfer (FRET) for the specific detection of amoxicillin. The carboxyfluorescein-labeled aptamer serves as a energy donor, while MXene functions as an energy acceptor, and acting as a quencher. To achieve optimal detection efficiency, a dual optimization strategy utilizing RSM-CCD and ANN-GA was used to fine-tune experimental conditions. The fluorescence measurements revealed an expansive linear range extending from 100 to 2400 ng mL-1, accompanied by an exceptionally low detection limit of 1.53 ng mL-1. Additionally, it shows an excellent selectivity towards amoxicillin over other antibiotics commonly found in water matrices. The aptasensor demonstrates good stability and reproducibility; effectiveness of the aptasensor was validated by testing in real water samples. This remarkable sensitivity and broad dynamic range affirm the efficacy aptasensor in accurately detecting varying concentrations of amoxicillin in wastewater bodies.

Detection of Pharmaceutically Active Compounds in Tap Water Samples by Direct Injection HPLC/MS-MS: A Danger Signal in Deficiency in Residue Management

To date, there is an increased risk to public health and the environment due to the presence of pharmaceutically active compounds within drinking water supply and distribution networks. Owing to this, a direct injection-HPLC/MS-MS method was developed for the simultaneous determination of 16 active pharmaceutical compounds in tap water samples: amoxicillin, ampicillin, cephalexin, cefotaxime, cefuroxime, ciprofloxacin, clarithromycin, clindamycin, chloramphenicol, cyproterone, erythromycin, flutamide, spironolactone, sulfamethoxazole, tamoxifen, and trimethoprim. Limits of detection (LOD) ranged from 0.2 to 6.0 µg/L while quantification limits (LOQ) from 0.3 to 20 µg/L. Recovery percentages were between 70 and 125%. Total analysis time was short, with all compounds being resolved in less than 2.1 min. Of the 22 tap water samples collected and analyzed, the highest concentrations corresponded to amoxicillin (147 µg/L) and ciprofloxacin (44 µg/L). The findings could set a precedent for establishing safe levels of these compounds and increasing standards for tap water quality in this region.

Summary recommendations on "Analytical methods for substances in the Watch List under the Water Framework Directive"

The Watch List (WL) is a monitoring program under the European Water Framework Directive (WFD) to obtain high-quality Union-wide monitoring data on potential water pollutants for which scarce monitoring data or data of insufficient quality are available. The main purpose of the WL data collection is to determine if the substances pose a risk to the aquatic environment at EU level and subsequently to decide whether a threshold, the Environmental Quality Standards (EQS) should be set for them and, potentially to be listed as priority substance in the WFD. The first WL was established in 2015 and contained 10 individual or groups of substances while the 4th WL was launched in 2022. The results of monitoring the substances of the first WL showed that some countries had difficulties to reach an analytical Limit of Quantification (LOQ) below or equal to the Predicted No-Effect Concentrations (PNEC) or EQS. The Joint Research Centre (JRC) of the European Commission (EC) organised a series of workshops to support the EU Member States (MS) and their activities under the WFD. Sharing the knowledge among the Member States on the analytical methods is important to deliver good data quality. The outcome and the discussion engaged with the experts are described in this paper, and in addition a literature review of the most important publications on the analysis of 17-alpha-ethinylestradiol (EE2), amoxicillin, ciprofloxacin, metaflumizone, fipronil, metformin, and guanylurea from the last years is presented.

Assessment of Molecularly Imprinted Polymers as Selective Solid-Phase Extraction Sorbents for the Detection of Cloxacillin in Drinking and River Water

This paper describes a new methodology for carrying out quantitative extraction of cloxacillin from drinking and river water samples using a molecularly imprinted polymer (MIP) as a selective sorbent for solid-phase extraction (MISPE). Several polymers were synthesized via thermal polymerization using cloxacillin as a template, methacrylic acid (MAA) as a functional monomer, ethyleneglycoldimethacrylate (EGDMA) as a cross-linker and different solvents as porogens. Binding characteristics of the adequate molecularly imprinted and non-imprinted (NIP) polymers were evaluated via batch adsorption assays following the Langmuir and Freundlich isotherms and Scatchard assays. The parameters related to the extraction approach were studied to select the most appropriate polymer for cloxacillin determination. Using the optimized MIP as the SPE sorbent, a simple sample treatment methodology was combined with high-performance liquid chromatography (HPLC) to analyze cloxacillin residues in drinking and river water. Under the optimum experimental conditions, the MISPE methodology was validated using spiked samples. The linearity for cloxacillin was assessed within the limits of 0.05-1.5 µg L-1 and the recovery percentage was higher than 98% (RSD < 4%). The limits of detection and limits of quantification were 0.29 and 0.37 µg L-1 and 0.8 and 0.98 µg L-1 for drinking and river water, respectively. The selectivity of MIP against other ß-lactam antibiotics with similar structures (oxacillin, cefazoline, amoxicillin and penicillin V) was studied, obtaining a good recovery higher than 85% for all except cefazoline. The proposed MISPE-HPLC methodology was successfully applied for the detection of cloxacillin in drinking water from Canal de Isabel II (Madrid) and river water from the Manzanares River (Madrid).

Antibiotic resistance genes and the association with bacterial community in biofilms occurring during the drinking water granular activated carbon (GAC) sandwich biofiltration

The granular activated carbon (GAC) sandwich modification to slow sand filtration could be considered as a promising technology for improved drinking water quality. Biofilms developed on sand and GAC surfaces are expected to show a functional diversity during the biofiltration. Bench-scale GAC sandwich biofilters were set-up and run continuously with and without antibiotic exposure. Surface sand (the schmutzdecke) and GAC biofilms were sampled and subject to high-throughput qPCR for antibiotic resistance gene (ARG) analysis and 16 S rRNA amplicon sequencing. Similar diversity of ARG profile was found in both types of biofilms, suggesting that all ARG categories decreased in richness along the filter bed. In general, surface sand biofilm remained the most active layer with regards to the richness and abundance of ARGs, where GAC biofilms showed slightly lower ARG risks. Network analysis suggested that 10 taxonomic genera were implicated as possible ARG hosts, among which Nitrospira, Methyloversatilis and Methylotenera showed the highest correlation. Overall, this study was the first attempt to consider the whole structure of the GAC sandwich biofilter and results from this study could help to further understand the persistence of ARGs and their association with the microbial community in drinking water biofiltration system.

Mobile phase and column chemistry selection for high sensitivity non-targeted LC/ESI/HRMS screening of water

Systematic selection of mobile phase and column chemistry type can be critical for achieving optimal chromatographic separation, high sensitivity, and low detection limits in liquid chromatography electrospray high resolution mass spectrometry (LC/MS). However, the selection process is challenging for non-targeted screening where the compounds of interest are not preselected nor available for method optimization. To provide general guidance, twenty different mobile phase compositions and four columns were compared for the analysis of 78 compounds with a wide range of physicochemical properties (logP range from -1.46 to 5.48), and analyte sensitivity was compared between methods. The pH, additive type, column, and organic modifier had significant effects on the analyte response factors, and acidic mobile phases (e.g. 0.1% formic acid) yielded highest sensitivity. In some cases, the effect was attributable to the difference in organic modifier content at the time of elution, depending on the mobile phase and column chemistry. Based on these findings, 0.1% formic acid, 0.1% ammonia and 5.0 mM ammonium fluoride were further evaluated for their performance in non-targeted LC/ESI/HRMS analysis of wastewater treatment plan influent and effluent, using a data dependent MS² acquisition and two different data processing workflows (MS-DIAL, patRoon 2.1) to compare number of detected features and sensitivity. Both data-processing workflows indicated that 0.1% formic acid yielded the highest number of features in full scan spectrum (MS¹)^, as well as the highest number of features that triggered fragmentation spectra (MS²) when dynamic exclusion was used.

Efficient Validation Strategies in Environmental Analytical Chemistry: A Focus on Organic Micropollutants in Water Samples

This article critically reviews analytical method validation and quality control applied to the environmental chemistry field. The review focuses on the determination of organic micropollutants (OMPs), specifically emerging contaminants and pesticides, in the aquatic environment. The analytical technique considered is (gas and liquid) chromatography coupled to mass spectrometry (MS), including high-resolution MS for wide-scope screening purposes. An analysis of current research practices outlined in the literature has been performed, and key issues and analytical challenges are identified and critically discussed. It is worth emphasizing the lack of specific guidelines applied to environmental analytical chemistry and the minimal regulation of OMPs in waters, which greatly affect method development and performance, requirements for method validation, and the subsequent application to samples. Finally, a proposal is made for method validation and data reporting, which can be understood as starting points for further discussion with specialists in environmental analytical chemistry.

Analytical key issues and challenges in the LC-MS/MS determination of antibiotics in wastewater

The research on antibiotics occurrence in the aquatic environment has become a hot topic in the last years due to their potential negative effects, associated to possible bacterial antibiotic-resistance, after continuous exposure to these compounds. Most of antibiotic residues are not completely removed in the wastewater treatment plants (WWTPs) and end up in the aquatic environment through treated wastewater (WW). The development of reliable analytical methodologies for the determination of antibiotics in influent (IWW) and effluent wastewater (EWW) is needed with different purposes, among others: monitoring their occurrence in the aquatic environment, performing environmental risk assessment, estimating removal efficiencies of WWTPs, or estimating the consumption of these compounds. In this paper, we perform an in-depth investigation on analytical key issues that pose difficulties in the determination of antibiotics in complex matrices, such as WW, and we identify challenges to be properly addressed for successful analysis. The analytical technique selected was liquid chromatography coupled to tandem mass spectrometry (LC-MS/MS), as it is the most powerful and widely applied at present for antibiotic residues determination. The mass spectrometric behavior of 18 selected antibiotics, the chromatographic performance, ion ratio variations associated to the sample matrix when using different precursor ions or protomers, and the macrolides adsorption to glass vial, were some of the issues studied in this work. On the basis of the detailed study performed, an analytical LC-MS/MS method based on sample direct injection has been developed for quantification of 18 antibiotics in IWW and EWW, allowing their determination at low ng L^-1 levels.

Analytical research of pesticide biomarkers in wastewater with application to study spatial differences in human exposure

Wastewater-based epidemiology (WBE) relies on the assessment and interpretation of levels of biomarkers in wastewater originating from a well-defined community. It has provided unique information on spatial and temporal trends of licit and illicit drug consumption, and has also the potential to give complementary information on human exposure to chemicals. Here, we focus on the accurate quantification of pesticide biomarkers (i.e., predominantly urinary metabolites) in influent wastewater at the ng L^-1 level to be used for WBE. In the present study, an advanced analytical methodology has been developed based on ultra-high-pressure liquid chromatography coupled to tandem mass spectrometry (UHPLC-MS/MS), for the simultaneous determination of 11 specific human biomarkers of triazines, urea herbicides, pyrethroids and organophosphates in urban wastewater. The sample treatment consisted of solid-phase extraction using Oasis HLB cartridges. Direct injection of the samples was also tested for all compounds, as a simple and rapid way to determine these compounds without sample manipulation (i.e., minimizing potential analytical errors). However, if extraction recoveries are satisfactory, SPE is the preferred approach that allow reaching lower concertation levels. Six isotopically labelled internal standards were evaluated and used to correct for matrix effects. Due to the difficulties associated with this type of analysis, special emphasis has been placed on the analytical challenges encountered. The satisfactory validated methodology was applied to urban wastewater samples collected from different locations across Europe revealing the presence of 2,6-EA, 3,4-DCA, 3-PBA and 4-HSA i.e, metabolites of metolachlor-s, urea herbicides, pyrethroids and chlorpropham, respectively. Preliminary data reported in this paper illustrate the applicability of this analytical approach for assessing human exposure to pesticides through WBE.