On the relationship between local voltage maxima and efficiency changes during galvanostatic Ti anodising

The Effect of Potential on Surface Characteristic and Corrosion Resistance of Anodic Oxide Film Formed on Commercial Pure Titanium at the Potentiodynamic-Aging Mode

Anodic oxidation treatment of commercially pure titanium was carried out at the voltages of 10, 30, 50 V in 0.5 M H₂SO₄ solution at the potentiodynamic-aging mode so as to obtain the effects of the anodic potential on the surface characteristic and corrosion resistance of the anodic oxide film. The influences of potential on the surface morphology, the roughness, the crystalline behavior, the chemical composition and the corrosion resistance of the anodic oxide films were investigated by using scanning electron microscopy (SEM), atomic force microscope (AFM), Raman spectrum, X-ray diffractometry (XRD), X-ray photoelectron spectroscopy (XPS), potentiodynamic polarization curves and electrode impedance spectroscopy (EIS). The results show that increasing anodic potential at the potentiodynamic-aging mode can significantly enhance thickness, flatness, crystallization, chemical stability, and corrosion resistance of anodic oxide film.

Electronic properties of anodized TiO2 electrodes and the effect on in vitro response

For dental implants, improved osseointegration is obtained by modifying the surface roughness as well as oxide morphology and composition. A combination of different effects contributes to enhanced performance, but with surface roughness as the dominant factor. To single out the effect of oxide conductivity on biological response, oxide films with similar thickness and surface roughness but different electronic properties were formed using galvanostatic anodization. Three different current densities were used, 2.4, 4.8, and 11.9 mA cm(-2) , which resulted in growth rates ranging from 0.2 to 2.5 V s(-1) . The electronic properties were evaluated using cyclic voltammetry and impedance spectroscopy, while the biological response was studied by cell activity and apatite formation. The number of charge carrier in the oxide film close to the oxide/solution interface decreased from 5.8 × 10(-19) to 3.2 × 10(-19) cm(-2) with increasing growth rate, that is, the conductivity decreased correspondingly. Cell response of the different surfaces was tested in vitro using human osteoblast-like cells (MG-63). The results clearly show decreased osteoblast proliferation and adhesion but higher mineralization activity for the oxide with lower conductivity at the oxide/solution interface. The apatite-forming ability was examined by immersion in simulated body fluid. At short times the apatite coverage was ∼26% for the anodized surfaces, significantly larger than for the reference with only 3% coverage. After 1 week of immersion the apatite coverage ranged from 73 to 56% and a slight differentiation between the anodized surfaces was obtained with less apatite formation on the surface with lower conductivity, in line with the cell culture results.