Honeycombed-like nanosheet array composite NiCo2O4/rGO for efficient methanol electrooxidation and supercapacitors

Impact of Diverse Nanostructure Forms of NiCo2O4 Bulk Ceramics on Electrical Properties

Spinel NiCo2O4 is a promising material for electronic applications due to its tunable nanostructures and electrical properties. This study systematically investigates the effect of varying urea concentrations in the hydrothermal solution on the nanostructural evolution of NiCo2O4 (NCO) and its impact on electrical and dielectric properties. By varying urea content, distinct morphologies-including nanosheets, nanoleaves, and nanofibers-were obtained and characterized via XRD, XPS, and FE-SEM analysis. To evaluate the electrical characteristics, capacitance and conductance measurements were performed using an LCR Meter at room temperature over a frequency range of 100 Hz to 1 MHz. The results revealed negative capacitance at low frequencies, linked to polarization changes and minority charge carriers. Also, dielectric parameters were calculated from measured values, showing that nanoform variations influence conductivity trends. This study provides new insights into how nanoform variations in NiCo2O4, controlled by synthesis parameters, influence its dielectric behavior. The findings significantly contribute to the understanding of negative capacitance and the tunability of electrical properties in NCO, highlighting their potential for future electronic and dielectric applications.

Facile Synthesis of 3D NC-rGO@Ni-Foam Nanonetwork as a Binder-Free Hybrid Electrode Material for Ultrahigh Capacitance Applications

In this study, a three-dimensional (3D) structured nanomaterial has been developed to enhance the electrochemical properties of supercapacitors. The nanomaterial's structure was engineered by incorporating divalent metal ions (M2+: Ni2+ and Co2+) into reduced graphene oxide (rGO) layers supported on nickel foam (3D NC-rGO@Ni-foam), forming a binder-free hybrid electrode. This was accomplished through a combination of in situ wet-chemistry and hydrothermal techniques. This binder-free electrode material has stacked layers of rGO, which improve conductivity, while the M2+ ions intercalated between these layers function as redox couples, thereby significantly improving the specific capacitance. Furthermore, the Ni-foam substrate offers a porous configuration and works as the current collector. In contrast to traditional slurry coating methods, the in situ growth of nanostructures on Ni-foam is expected to enhance strong adhesion, high conductivity, and effective ion transport. The structural morphology, chemical composition, and electrochemical behavior of the 3D NC-rGO@Ni-foam electrode were comprehensively investigated using techniques such as scanning electron microscope (SEM), energy-dispersive X-ray spectroscopy (EDS), cyclic voltammetry (CV), galvanostatic charge-discharge (GCD), electrochemical impedance spectroscopy (EIS), and other analytical methods. This binder-free 3D hybrid electrode material demonstrated a specific capacitance (C s) of 2612 F/g at 1 A/g. The symmetric device fabricated also demonstrated a substantial energy density (E) of 55 W·h/kg and a power density (P) of 155 W/kg across a wide potential window of 2.5 V. The electrochemical characteristics and mechanical stability of 3D NC-rGO@Ni-foam indicate its potential as a high-performance electrode material for scalable energy storage systems.

High electrochemical performance of nickel cobaltite@biomass carbon composite (NiCoO@BC) derived from the bark of Anacardium occidentale for supercapacitor application

Biomass carbon-based materials are highly promising for supercapacitor (SC) electrodes due to their availability, environment-friendliness, and low cost. Herein, an easy energy-saving hydrothermal process was used to produce NiCo2O4/NiOOH (NiCoO) composites with biomass carbon (BC) derived from the bark of Anacardium occidentale (AO) at different synthesis time durations (2 h, 4 h, 8 h, 16 h). The structural and morphological properties of the samples were analysed using XRD, Raman spectroscopy, XPS, SEM, TEM and BET, and the results exhibit the presence of carbon inserted into the nickel-cobalt hydroxide matrix. The NiCoO@BC composite synthesized in 4 h (NiCoO@BC(4 h)) displays a good specific capacitance of 475 F g-1 at 0.5 A g-1 and a low equivalent series resistance (ESR) value of 0.36 Ω. It shows a good coulombic efficiency of 98% and retains 86% of the capacitance after 4000 cycles. The asymmetric supercapacitor (ASC) device (NiCoO@BC(4 h)//AC) assembled using activated carbon (AC) as a negative electrode displays 20 W h kg-1 energy density and 900 W kg-1 power density at 1 A g-1. The stability test shows a good coulombic efficiency of 99% and 78% capacitance retention after 15 000 cycles. These findings imply that NiCoO@BC composites have outstanding electrochemical properties, making them suitable as SC electrode materials.

MnCo2O4/NiCo2O4/rGO as a Catalyst Based on Binary Transition Metal Oxide for the Methanol Oxidation Reaction

The demands for alternative energy have led researchers to find effective electrocatalysts in fuel cells and increase the efficiency of existing materials. This study presents new nanocatalysts based on two binary transition metal oxides (BTMOs) and their hybrid with reduced graphene oxide for methanol oxidation. Characterization of the introduced three-component composite, including cobalt manganese oxide (MnCo₂O₄), nickel cobalt oxide (NiCo₂O₄), and reduced graphene oxide (rGO) in the form of MnCo₂O₄/NiCo₂O₄/rGO (MNR), was investigated by X-ray diffraction (XRD), scanning electron microscope (SEM), and energy-dispersive X-ray (EDX) analyses. The alcohol oxidation capability of MnCo₂O₄/NiCo₂O₄ (MN) and MNR was evaluated in the methanol oxidation reaction (MOR) process. The crucial role of rGO in improving the electrocatalytic properties of catalysts stems from its large active surface area and high electrical conductivity. The alcohol oxidation tests of MN and MNR showed an adequate ability to oxidize methanol. The better performance of MNR was due to the synergistic effect of MnCo₂O₄/NiCo₂O₄ and rGO. MN and MNR nanocatalysts, with a maximum current density of 14.58 and 24.76 mA/cm² and overvoltage of 0.6 and 0.58 V, as well as cyclic stability of 98.3% and 99.7% (at optimal methanol concentration/scan rate of 20 mV/S), respectively, can be promising and inexpensive options in the field of efficient nanocatalysts for use in methanol fuel cell anodes.

Recent Research of NiCo2O4/Carbon Composites for Supercapacitors

Supercapacitors have played an important role in electrochemical energy storage. Recently, researchers have found many effective methods to improve electrode materials with more robust performances through the increasing volume of scientific publications in this field. Though nickel cobaltite (NiCo2O4), as a promising electrode material, has substantially demonstrated potential properties for supercapacitors, its composites usually show much better performances than the pristine NiCo2O4. The combination of carbon-based materials and NiCo2O4 has been implemented recently due to the dual mechanisms for energy storage and the unique advantages of carbon materials. In this paper, we review the recent research on the hybrids of NiCo2O4 and carbon nanomaterials for supercapacitors. Typically, we focused on the reports related to the composites containing graphene (or reduced graphene oxide), carbon nanotubes, and amorphous carbon, as well as the major synthesis routes and electrochemical performances. Finally, the prospect for the future work is also discussed.

Hexadecyl trimethyl ammonium bromide assisted growth of NiCo2O4@reduced graphene oxide/ nickel foam nanoneedle arrays with enhanced performance for supercapacitor electrodes

NiCo₂O₄@reduced graphene oxide (rGO)/nickel foam (NF) composites were prepared via a hydrothermal method followed by annealing assisted by hexadecyl trimethyl ammonium bromide (CTAB). NiCo₂O₄@rGO/NF nanoneedle arrays grew directly on Ni foam (NF) without using a binder. The effect of graphene oxide (GO) concentration on the electrochemical properties of the composite was studied. When the GO concentration was 5 mg L⁻¹, the as-prepared NiCo₂O₄@rGO/NF reaches the highest specific capacitance of 1644 F g⁻¹ at a current density of 1 A g⁻¹. Even at 15 A g⁻¹, the specific capacitance is still 1167 F g⁻¹ and the capacitance retention rate is 89% after 10 000 cycles at 10 A g⁻¹. Furthermore, a NiCo₂O₄@rGO/NF//graphene hydrogel (GH) asymmetric supercapacitor cell (ASC) device was assembled and exhibits a high specific capacitance of 84.13 F g⁻¹ at 1 A g⁻¹ and excellent cycle stability (113% capacitance retention) after 10 000 charge/discharge cycles at 10 A g⁻¹. This provides potential for application in the field of supercapacitors due to the outstanding specific capacitance, rate performance and cycle stability of NiCo₂O₄@rGO/NF.

Anisotropic NiCo₂O₄ nanoneedle arrays grew directly on Ni foam in the presence of rGO via the hydrothermal method followed by annealing assisted by hexadecyl trimethyl ammonium bromide (CTAB).

Multifunctionality exploration of NiCo2O4-rGO nanocomposites: photochemical water oxidation, methanol electro-oxidation and asymmetric supercapacitor applications

Different weight percentages of NiCo₂O₄-rGO nanocomposites were prepared via a facile hydrothermal method. The prepared nanocomposites were structurally and morphologically characterized by X-ray diffraction, Raman spectroscopy, and electron microscopy. The structural studies show the formation of rGO-NiCo₂O₄ nanocomposites by embedment of porous NiCo₂O₄ rods on rGO sheets. The effect of the NiCo₂O₄ content on photochemical water oxidation was investigated. It revealed that the catalysts NiCo₂O₄-rGO with 1 : 26 ratio (NCO26) and 1 : 13 ratio (NCO13) are efficient in generating oxygen under light illumination. It proves that NCO26 works far more effectively as a photocatalyst compared to NCO13. Methanol electro-oxidation of the NCO26 nanocomposite shows a current density of 24 mA cm^-2 at a potential of 0.45 V in cyclic voltammetry and maintains the current for 3600 s at 0.45 V in chronoamperometry. An onset potential of 0.344 V was observed for 0.5 M methanol oxidation. The specific capacitance values were found to be 354.75 F g^-1 and 375.32 F g^-1 at 1 mV s^-1 and 1 A g^-1, respectively, for NCO26 in supercapacitor studies. The charge stored via capacitive and diffusion-controlled processes was determined using Power's law and Trasatti plot. An asymmetric supercapacitor device shows a specific capacitance of 122.2 F g^-1 at a current density of 1 A g^-1 and exhibits a retention of 74.3% after 5000 cycles. An energy density of 67.89 W h kg^-1 and a power density of 1 kW kg^-1 at a current density of 1 A g^-1 are observed.

Engineering triangular bimetallic metal-organic-frameworks derived hierarchical zinc-nickel-cobalt oxide nanosheet arrays@reduced graphene oxide-Ni foam as a binder-free electrode for ultra-high rate performance supercapacitors and methanol electro-oxidation

The rigorous fabrication of electrode materials using upper-ranked porous precursor especially metal organic frameworks (MOFs) are challenging but appealing task to procure electrochemical energy storage and conversion system with altitudinous performance. Herein, we replenish the rational construction of atypical electrode of hollow Zn-Ni-Co-oxide (ZNCO) nanosheet arrays onto rGO garnished Ni foam (rGO/NF) via two step solution based method. Firstly, 2D Zn-Co-MOFs derived nanoleave arrays are prepared by co-precipitation method. Next, hollow and porous ZNCO nanostructure from 2D solid nanoleave arrays are achieved by ion-exchange and etching process conjoined with post annealing treatment. The as-fabricated hierarchical ZNCO nanosheet arrays offer large numbers of electroactive sites with short ion-diffusion pathways, reflecting the outstanding electrochemical performance in-terms of excellent specific capacity (267 mAh g^-1) ultra-high rate capability (83.82% at 50 A/g) and long-term cycling life (~90.16%) in three electrode configuration for supercapacitor (SCs). Moreover, the hollow and porous ZNCO nanostructure responds as immensely active and substantial electrocatalyst for methanol oxidation with lowest onset potential of 0.27 V. To demonstrate the practicability, hybrid supercapacitor (HSC) device is constructed using ZNCO@rGO-NF nanostructure as positive and rGO decorated MOF derived porous carbon (rGO-MDPC) as negative electrode. The as-assembled ZNCO//rGO-MDPC ASC device delivers higher energy density of 61.25 Wh kg^-1 at the power density of 750 W kg^-1 with long-term cyclic stability (<6% to its initial specific capacity value) after 6000 cycles.

Enhanced electrochemical performance of MnNi2O4/rGO nanocomposite as pseudocapacitor electrode material and methanol electro-oxidation catalyst

Binary transition metal oxides with encouraging electrocatalyst properties have been suggested as electrode materials for supercapacitors and methanol oxidation. Hence, in this work, a binary mixed metal oxide based on nickel and manganese (MnNi₂O₄) and its hybrid with reduced graphene oxide were synthesized by a one-step hydrothermal method. After physical and morphological characterization, the potential of these nanostructures was investigated for use as supercapacitor electrodes and methanol electro-oxidation. The results of the electrochemical analysis showed a substantial effect of adding rGO to the MnNi₂O₄. The MnNi₂O₄/rGO hybrid electrode supercapacitor exhibited good stability of 93% after 2000 consecutive CV cycles and a specific capacitance of 575 F g^-1at the current density of 0.5 A g^-1. Furthermore, the application of this hybrid nanomaterial in the methanol electro-oxidation reaction (MOR) indicated its appropriate electrochemical efficiency and stability in methanol oxidation. Our results show that MnNi₂O₄/rGO can be considered as a promising electrode material for energy applications.