Improving the onset potential and Tafel slope determination of earth-abundant water oxidation electrocatalysts

Factorial Design and Optimization of Trimetallic CoNiFe-LDH/Graphene Composites for Enhanced Oxygen Evolution Reaction

Layered double hydroxides (LDH) have exhibited promising applications as electrocatalysts in oxygen evolution reactions (OER). In this work, trimetallic LDHs (CoNiFe-LDH) were designed and grown on graphene (G) through a one-step hydrothermal approach to obtain a structure that promotes efficient charge transfer. A 2-level full-factorial design was utilized to evaluate the effects of varying the concentrations of Co (1.5, 3, and 4.5 mmol) and graphene (10, 30, and 50 mg) on the OER activity. The potential needed to deliver 10 mA cm-2 was chosen as the response parameter. The independent and dependent parameters were fitted to a linear model equation through ANOVA analysis. The computed p-values were below 0.05 signifying the statistical significance of the concentrations of cobalt and graphene and their interaction, suggesting a correlation with the OER activity. The OER experiments were conducted in triplicate using the Co[3]Ni[3]Fe[3]-LDH/G[30] (central point) to estimate variability (0.58%). Comparative analysis showed that Co[1.5]Ni[3]Fe[3]-LDH/G[10] achieved the lowest onset potential (1.54 V), potential at 10 mA cm-2 (1.58 V), and Tafel slope (58.4 mV dec-1), indicating that a low concentration of cobalt and graphene make an efficient electrocatalyst for OER. Furthermore, the optimized composite demonstrated favorable electronic properties, with a charge transfer resistance (RCT) of 188.1 Ω, and exhibited good stability, maintaining its catalytic activity with no significant loss over a 24-h period.

Fe,Ce Co-Doped Ni3S2/NiS Polymorphism Nanosheets With Improved Electrocatalytic Activity and Stability for Water Oxidation

Balancing the relationship between electrocatalytic activity and stability of sulfide catalysts during oxygen evolution reaction (OER) has been attracting extensive research interest. Here, a simple electrodeposition-vulcanization two-step route was designed to successfully construct nickel foam supported sheet-like Fe,Ce-codoped Ni3S2/NiS polymorphism catalyst (labeled as Fe,Ce-Ni3S2/NiS/NF). Electrochemical measurements showed that the as-obtained Fe,Ce-Ni3S2/NiS/NF electrode presented excellent OER electrocatalytic performances. In 1 M KOH solution, merely 173 and 234 mV of overpotentials were required to deliver the current densities of 10 and 100 mA cm-2, respectively. Further investigations revealed that the Fe,Ce co-doping regulated the electron density around Ni, which promoted the conversion of Ni towards the higher valence state and simultaneously, avoided the stability decrease of the catalyst caused by excessive oxidation corrosion. Moreover, the defects generated during vulcanization also contributed to promoting water oxidation. The present work provides a facile and feasible approach to balance the relationship between the stability and the activity of sulfide catalysts for OER.

Single Atom Catalysts Based on Earth-Abundant Metals for Energy-Related Applications

Anthropogenic activities related to population growth, economic development, technological advances, and changes in lifestyle and climate patterns result in a continuous increase in energy consumption. At the same time, the rare metal elements frequently deployed as catalysts in energy related processes are not only costly in view of their low natural abundance, but their availability is often further limited due to geopolitical reasons. Thus, electrochemical energy storage and conversion with earth-abundant metals, mainly in the form of single-atom catalysts (SACs), are highly relevant and timely technologies. In this review the application of earth-abundant SACs in electrochemical energy storage and electrocatalytic conversion of chemicals to fuels or products with high energy content is discussed. The oxygen reduction reaction is also appraised, which is primarily harnessed in fuel cell technologies and metal-air batteries. The coordination, active sites, and mechanistic aspects of transition metal SACs are analyzed for two-electron and four-electron reaction pathways. Further, the electrochemical water splitting with SACs toward green hydrogen fuel is discussed in terms of not only hydrogen evolution reaction but also oxygen evolution reaction. Similarly, the production of ammonia as a clean fuel via electrocatalytic nitrogen reduction reaction is portrayed, highlighting the potential of earth-abundant single metal species.

Silver nanoparticle-decorated NiFe2O4/CuWO4 heterostructure electrocatalyst for oxygen evolution reactions

In this work, Ag nanoparticles decorated with NiFe2O4/CuWO4 heterostructure were synthesized using the step-wise precipitation method. The influence of varying Ag loading on the NiFe2O4/CuWO4 heterostructure and its electrochemical OER performance was extensively studied in 1 M KOH electrolyte. The obtained LSV profile was analyzed to determine the overpotential, Tafel slope, and onset potential. The heterostructure with an optimal Ag loading of 5 wt% required the least overpotential (1.60 V vs. RHE) for generating a current density of 10 mA cm-2 with a lower Tafel slope of 44.5 mV dec-1, indicating its faster OER kinetics. Furthermore, the composite remained stable over a period of 24 hours with a minimum rise in the overpotential after the stability test. The enhanced OER performance of the as-prepared catalyst can be attributed to the presence of multiple metallic elements in the Ag-loaded NiFe2O4/CuWO4 composite, which created a diverse array of oxygen-vacant sites with varying reactivity, enhancing the charge-transfer kinetics; and thus contributing to the overall efficiency of OER. Therefore, optimizing the Ag concentration and engineering a microstructure represents an encouraging strategy for developing cost-effective catalysts for next-generation energy-conversion applications.

Potential-dependent transition of reaction mechanisms for oxygen evolution on layered double hydroxides

Oxygen evolution reaction (OER) is of crucial importance to sustainable energy and environmental engineering, and layered double hydroxides (LDHs) are among the most active catalysts for OER in alkaline conditions, but the reaction mechanism for OER on LDHs remains controversial. Distinctive types of reaction mechanisms have been proposed for the O-O coupling in OER, yet they compose a coupled reaction network with competing kinetics dependent on applied potentials. Herein, we combine grand-canonical methods and micro-kinetic modeling to unravel that the nature of dominant mechanism for OER on LDHs transitions among distinctive types as a function of applied potential, and this arises from the interplay among applied potential and competing kinetics in the coupled reaction network. The theory-predicted overpotentials, Tafel slopes, and findings are in agreement with the observations of experiments including isotope labelling. Thus, we establish a computational methodology to identify and elucidate the potential-dependent mechanisms for electrochemical reactions.

Electrochemical Metal Recycling: Recovery of Palladium from Solution and In Situ Fabrication of Palladium-Carbon Catalysts via Impact Electrochemistry

Recycling of critical materials, regeneration of waste, and responsible catalyst manufacture have been repeatedly documented as essential for a sustainable future with respect to the environment and energy production. Electrochemical methods have become increasingly recognized as capable of achieving these goals, and “impact” electrochemistry, with the advantages associated with dynamic nanoelectrodes, has recently emerged as a prime candidate for the recovery of metals from solution. In this report, the nanoimpact technique is used to generate carbon-supported palladium catalysts from low-concentration palladium(II) chloride solutions (i.e., a waste stream mimic) as a proof of concept. Subsequently, the catalytic properties of this material in both synthesis (Suzuki coupling reaction) and electrocatalysis (hydrogen evolution) are demonstrated. Transient reductive impact signals are shown and analyzed at potentials negative of +0.4 V (vs SCE) corresponding to the onset of palladium deposition in traditional voltammetry. Direct evidence of Pd modification was obtained through characterization by environmental scanning electron microscopy/energy-dispersive X-ray spectroscopy, inductively coupled plasma mass spectrometry, X-ray photoelectron spectroscopy, transmission electron microscopy, and thermogravimetric analysis of impacted particles. This showed the formation of deposits of Pd0 partially covering the 50 nm carbon black particles with approximately 14% Pd (wt %) under the conditions used. This material was then used to demonstrate the conversion of iodobenzene into its biphenyl product (confirmed through nuclear magnetic resonance) and the successful production of hydrogen as an electrocatalyst under acidic conditions (under cyclic voltammetry).

Implementing the donor-acceptor approach in electronically conducting copolymers via electropolymerization

Electropolymerization has become a convenient method for synthesizing and characterizing complex organic copolymers having intrinsic electronic conductivity, including the donor (D)-acceptor (A) class of electronically conducting polymers (ECPs). This review begins with an introduction to the electrosynthesis of common second-generation ECPs. The information obtainable from electroanalytical studies, charge carriers such as polarons (positive and negative) and bipolarons (positive and negative) and doping will be discussed. The evolutionary chain of ECPs is then presented. ECPs comprising electron-rich D and electron-deficient A moieties have been shown to possess intrinsic electronic conductivity and unique optical and electronic properties. They are third generation ECPs and electropolymerization of mixtures of D and A leads to stoichiometrically controlled block copolymers. These D-A type ECPs are discussed on the basis of selected representative materials. Since the discovery of electropolymerization as a powerful tool to synthesize copolymers of conjugated monomers with a pre-determined ratio of D and A repeat units present in the polymer, the field of D-A type ECPs has grown considerably and the literature available since 2004 to 2021 is summarized and tabulated. Electronic and optical properties of the materials determined by computational chemistry are presented. The data obtained from electrochemical and optical methods are compared with those obtained from computational methods and reasons for discrepancies are given. The literature on the concept of electropolymerization extended to synthesizing triblock and many-block copolymers is reviewed. Finally, applications of D-A polymers in optoelectronic devices (organic solar cells and field-effect transistors) and in bio-imaging are explained quoting appropriate examples.

Heterostructure of core-shell IrCo@IrCoOxas efficient and stable catalysts for oxygen evolution reaction

Although researches on non-noble metal electrocatalysts have been made some progress recently, their performance in proton exchange membrane water electrolyzer is still incomparable to that of noble-metal-based catalysts. Therefore, it is a more practical way to improve the utilization of precious metals in electrocatalysts for oxygen evolution reaction (OER) in the acidic medium. Herein, nanostructured IrCo@IrCoO_xcore-shell electrocatalysts composed of IrCo alloy core and IrCoO_xshell were synthesized through a simple colloidally synthesis and calcination method. As expected, the hybrid IrCo-200 NPs with petal-like morphology show the best OER activities in acidic electrolytes. They deliver lower overpotential and better electrocatalytic kinetics than pristine IrCo alloy and commercial Ir/C, reaching a low overpotential (j = 10 mA cm^-2) of 259 mV (versus RHE) and a Tafel slope of 59 mV dec^-1. The IrCo-200 NPs displayed robust durability with life time of about 55 h in acidic solution under a large current density of 50 mA cm^-2. The enhanced electrocatalytic activity may be associated with the unique metal/amorphous metal oxide core-shell heterostructure, allowing the improved charge transferability. Moreover, the *OH-rich amorphous shell functions as the active site for OER and prevents the further dissolution of the metallic core and thus ensures high stability.

Enhancing the electrocatalytic activity and stability of Prussian blue analogues by increasing their electroactive sites through the introduction of Au nanoparticles

Prussian blue analogues (PBAs) have been proven as excellent Earth-abundant electrocatalysts for the oxygen evolution reaction (OER) in acidic, neutral and alkaline media. Further improvements can be achieved by increasing their electrical conductivity, but scarce attention has been paid to quantify the electroactive sites of the electrocatalyst when this enhancement occurs. In this work, we have studied how the chemical design influences the specific density of electroactive sites in different Au-PBA nanostructures. Thus, we have first obtained and fully characterized a variety of monodisperse core@shell hybrid nanoparticles of Au@PBA (PBA of Ni^IIFe^II and Co^IIFe^II) with different shell sizes. Their catalytic activity is evaluated by studying the OER, which is compared to pristine PBAs and other Au-PBA heterostructures. By using the coulovoltammetric technique, we have demonstrated that the introduction of 5-10% of Au in weight in the core@shell leads to an increase in the electroactive mass and thus, to a higher density of active sites capable of taking part in the OER. This increase leads to a significant decrease in the onset potential (up to 100 mV) and an increase (up to 420%) in the current density recorded at an overpotential of 350 mV. However, the Tafel slope remains unchanged, suggesting that Au reduces the limiting potential of the catalyst with no variation in the reaction kinetics. These improvements are not observed in other Au-PBA nanostructures mainly due to a lower contact between both compounds and the Au oxidation. Hence, an Au core activates the PBA shell and increases the conductivity of the resulting hybrid, while the PBA shell prevents Au oxidation. The strong synergistic effect existing in the core@shell structure evidences the importance of the chemical design for preparing PBA-based nanostructures exhibiting better electrocatalytic performances and higher electrochemical stabilities.