Release characteristics of anionic drug compounds from liquid crystalline gels

Some observations on the liquid crystalline and gel behaviors of aqueous dispersions of a prodrug

BMS-830216 is a diprotic acid prodrug of two pK_a values (<2 and 6.8) with high apparent solubility at pH ≥ 7. At ∼ pH 4 solutions of BMS-830216 appear to be surface active, in which their surface tension can be reduced from 72 to 65 dynes when its concentrations is above the critical aggregation concentration (CAC∼0.2 mM). Additionally, at this pH, BMS-830216 tends to form liquid crystalline phases (at ≥ 2 mg/mL) in acetate buffer when using tris salt. Furthermore, after raising the concentration beyond 20 mg/g, formation of gel-like dispersions was noted. These gel-like dispersions exhibited a strong elastic strength, significantly impacting the dissolution behavior of the tris salt. Mechanistically, it is likely that BMS-830216 tris salt in solution first forms a lamellar phase followed by formation of a gel phase at higher concentrations (≥20 mg/mL). As indicated by SAXS, the lamellar phase formed seems to have two d-spacing values (∼5 nm and ∼10 nm (weak), which seems to correspond to two molecules connected tail by tail (5 nm). Further investigation is needed for phase identification, as their properties can affect the physical behavior of BMS-830216 in the development of pharmaceutical dosage forms.

Release characteristics of anionic drug compounds from liquid crystalline gels

This paper investigates the release and transport of a range of anionic drugs from liquid crystalline gels using chemical and physical enhancement techniques. Previous papers [Fitzpatrick, D., Corish, J., 2005. Release characteristics of anionic drug compounds from liquid crystalline gels. I. Passive release across non-rate limiting membranes. Int. J. Pharm. 301, 226-236; Fitzpatrick, D., Corish, J., 2006. Release characteristics of anionic drug compounds from liquid crystalline gels. II. The effects of ion pairing and buffering on the passive delivery of anionic drugs across non rate-limiting membranes. Int. J. Pharm.] have reported on the passive release profiles and those resulting from the incorporation of a chemical enhancer in the vehicle. This paper investigates the behaviour of the system under iontophoretic conditions and also under those of combined physical and chemical enhancement. The data presented here are directly comparable to previous work by Nolan et al. [; Nolan, L.M.A., Corish, J., Corrigan, O.I., Fitzpatrick, D., 2006. Combined effects of iontophoretic and chemical enhancement on drug delivery. II. Transport across human and hairless murine skin. Int. J. Pharm., submitted for publication] which investigated the behaviour of cationic compounds under analogous conditions. The iontophoretic release of diclofenac in the presence of model enhancers is thoroughly investigated. It is also shown that a range of anionic drug molecules undergo an electrochemical change during the course of the experiments which leads to their poor detection. This may be a factor in the under reporting of iontophoretic delivery of anionic drugs in the literature. However, it has been shown that the transport of the drugs is greatly enhanced by the application of an iontophoretic current. Results of combined enhancement studies provide a positive basis on which to proceed with in vitro studies of the system across human skin.