As a single atom Pd outperforms Pt as the most active co-catalyst for photocatalytic H2 evolution

Stable and Highly Active Single Atom Configurations for Photocatalytic H2 Generation

The employment of single atoms (SAs), especially Pt SAs, as co-catalysts in photocatalytic H2 generation has gained significant attention due to their exceptional efficiency. However, a major challenge in their application is the light-induced agglomeration of these SAs into less active nanosized particles under photocatalytic conditions. This study addresses the stability and reactivity of Pt SAs on TiO2 surfaces by investigating various post-deposition annealing treatments in air, Ar, and Ar-H2 environments at different temperatures. It is described that annealing in an Ar-H2 atmosphere optimally stabilizes SA configurations, forming stable 2D rafts of assembled SAs ≈0.5-1 nm in diameter. These rafts not only resist light-induced agglomeration but also exhibit significantly enhanced H2 production efficiency. The findings reveal a promising approach to maintaining the high reactivity of Pt SAs while overcoming the critical challenge of their stability under photocatalytic conditions.

Long-Term Stability of Light-Induced Ti3+ Defects in TiO2 Nanotubes for Amplified Photoelectrochemical Water Splitting

This study shows that the simple approach of keeping anodic TiO2 nanotubes at 70 °C in ethanol for 1 h results in improved photoelectrochemical water splitting activity due to initiation of crystallization in the material amplified by the light-induced formation of a Ti3+ -Vo states under UV 365 nm illumination. For the first time, the light-induced Ti3+ -Vo states are generated when oxygen is present in the reaction solution and are stable when in contact with air (oxygen) for a long time (two months). We confirmed here that the amorphous or nearly amorphous structure of titania supports the survival of Ti3+ species in contact with oxygen. It is also shown that the ethanol treatment substantially improves the morphology of the titania nanotube arrays, specifically, less surface cracking and surface purification from C- and F-based contamination from the electrolyte used for anodizing.

2D Metal-Organic Framework Nanosheets based on Pd-TCPP as Photocatalysts for Highly Improved Hydrogen Evolution

In this report, a 2D MOF nanosheet derived Pd single-atom catalyst, denoted as Pd-MOF, was fabricated and examined for visible light photocatalytic hydrogen evolution reaction (HER). This Pd-MOF can provide a remarkable photocatalytic activity (a H2 production rate of 21.3 mmol/gh in the visible range), which outperforms recently reported Pt-MOFs (with a H2 production rate of 6.6 mmol/gh) with a similar noble metal loading. Notably, this high efficiency of Pd-MOF is not due to different chemical environment of the metal center, nor by changes in the spectral light absorption. The higher performance of the Pd-MOF in comparison to the analogue Pt-MOF is attributed to the longer lifetime of the photogenerated electron-hole pairs and higher charge transfer efficiency.

Pd Single-Atom Loaded Ce-Zr Solid Solution Catalysts Prepared by Flame Spray Pyrolysis for Efficient CO Catalytic Oxidation

Single-atom catalysts (SACs) exhibit remarkable catalytic activity at each metal site. However, conventionally synthesized single-atom catalysts often possess low metal loading, thereby constraining their overall catalytic performance. Here, a flame spray pyrolysis (FSP) method for the synthesis of a single-atom catalyst with a high loading capacity of up to 1.4 wt.% in practice is reported. CeZrO2 acts as a carrier and provides a large number of anchoring sites, which promotes the high-density generation of Pd, and the strong interaction between the metal and the support avoids atom aggregation. Pd-CeZrO2 series catalysts have excellent CO oxidation performance. When 0.97 wt.% Pd is added, the catalytic activity is the highest, and the temperature can be reduced to 120 °C. This work presented here demonstrates that FSP, as an inherently scalable technique, allows for elevating the single-atom loading to achieve an increase in its catalytic performance. The method presented here more options for the preparation of SACs.

Spontaneous Dewetting of Au-Thin Layers on Oxide- and Fluorine-Terminated Single Crystalline Anatase and Efficient Use in Photocatalytic H2 Production

In the present work, the spontaneous dewetting of thin Au layers on single crystalline anatase nanosheets into narrow-disperse Au nanoparticles is investigated. Patterns of the Au particles can be formed on the main facets of anatase that provide a high co-catalytic activity for photocatalytic generation of H2 . Dewetting is distinctly influenced by the respective facets (001) and (101), the deposit thickness, and secondary thermal dewetting, but most strongly by the surface termination of the nanosheets. Fluoride termination not only leads to an enhanced Au-phobic behavior but strongly affects the co-catalytic activity for photocatalytic generation of H2 . While fluoride termination with or without Au decoration is detrimental for hole transfer, the interplay of the Au co-catalyst and surface fluoride yields highly beneficial effect for electron transfer. This results in a three-times higher photocatalytic H2 production for the F-terminated surface. The findings suggest that dewetting of Au on surface fluorinated TiO2 is an effective way to modulate surface dewetting and achieve a strongly enhanced photocatalytic activity.

Reactive Deposition Versus Strong Electrostatic Adsorption (SEA): A Key to Highly Active Single Atom Co-Catalysts in Photocatalytic H2 Generation

In recent years, the use of single atoms (SAs) has become of a rapidly increasing significance in photocatalytic H2 generation; here SA noble metals (mainly Pt SAs) can act as highly effective co-catalysts. The classic strategy to decorate oxide semiconductor surfaces with maximally dispersed SAs relies on "strong electrostatic adsorption" (SEA) of suitable noble metal complexes. In the case of TiO2 - the classic benchmark photocatalyst - SEA calls for adsorption of cationic Pt complexes such as [(NH3 )4 Pt]2+ which then are thermally reacted to surface-bound SAs. While SEA is widely used in literature, in the present work it is shown by a direct comparison that reactive attachment based on the reductive anchoring of SAs, e.g., from hexachloroplatinic(IV) acid (H2 PtCl6 ) leads directly to SAs in a configuration with a significantly higher specific activity than SAs deposited with SEA - and this at a significantly lower Pt loading and without any thermal post-deposition treatments. Overall, the work demonstrates that the reactive deposition strategy is superior to the classic SEA concept as it provides a direct electronically well-connected SA-anchoring and thus leads to highly active single-atom sites in photocatalysis.

Recent Progress of Single-Atom Photocatalysts Applied in Energy Conversion and Environmental Protection

Photocatalysis driven by solar energy is a feasible strategy to alleviate energy crises and environmental problems. In recent years, significant progress has been made in developing advanced photocatalysts for efficient solar-to-chemical energy conversion. Single-atom catalysts have the advantages of highly dispersed active sites, maximum atomic utilization, unique coordination environment, and electronic structure, which have become a research hotspot in heterogeneous photocatalysis. This paper introduces the potential supports, preparation, and characterization methods of single-atom photocatalysts in detail. Subsequently, the fascinating effects of single-atom photocatalysts on three critical steps of photocatalysis (the absorption of incident light to produce electron-hole pairs, carrier separation and migration, and interface reactions) are analyzed. At the same time, the applications of single-atom photocatalysts in energy conversion and environmental protection (CO₂ reduction, water splitting, N₂ fixation, organic macromolecule reforming, air pollutant removal, and water pollutant degradation) are systematically summarized. Finally, the opportunities and challenges of single-atom catalysts in heterogeneous photocatalysis are discussed. It is hoped that this work can provide insights into the design, synthesis, and application of single-atom photocatalysts and promote the development of high-performance photocatalytic systems.

Light-Induced Agglomeration of Single-Atom Platinum in Photocatalysis

With recent advances in the field of single-atoms (SAs) used in photocatalysis, an unprecedented performance of atomically dispersed co-catalysts has been achieved. However, the stability and agglomeration of SA co-catalysts on the semiconductor surface may represent a critical issue in potential applications. Here, the photoinduced destabilization of Pt SAs on the benchmark photocatalyst, TiO₂ , is described. In aqueous solutions within illumination timescales ranging from few minutes to several hours, light-induced agglomeration of Pt SAs to ensembles (dimers, multimers) and finally nanoparticles takes place. The kinetics critically depends on the presence of sacrificial hole scavengers and the used light intensity. Density-functional theory calculations attribute the light induced destabilization of the SA Pt species to binding of surface-coordinated Pt with solution-hydrogen (adsorbed H atoms), which consequently weakens the Pt SA bonding to the TiO₂ surface. Despite the gradual aggregation of Pt SAs into surface clusters and their overall reduction to metallic state, which involves >90% of Pt SAs, the overall photocatalytic H₂ evolution remains virtually unaffected.

The Local Coordination Effects on the Reactivity and Speciation of Active Sites in Graphene-Embedded Single-Atom Catalysts over Wide pH and Potential Range

Understanding the catalytic performance of different materials is of crucial importance for achieving further technological advancements. This especially relates to the behaviors of different classes of catalysts under operating conditions. Here, we analyzed the effects of local coordination of metal centers (Mn, Fe, Co) in graphene-embedded single-atom catalysts (SACs). We started with well-known M@N₄-graphene catalysts and systematically replaced nitrogen atoms with oxygen or sulfur atoms to obtain M@O_xN_y-graphene and M@S_xN_y-graphene SACs (x + y = 4). We show that local coordination strongly affects the electronic structure and reactivity towards hydrogen and oxygen species. However, stability is even more affected. Using the concept of Pourbaix plots, we show that the replacement of nitrogen atoms in metal coordinating centers with O or S destabilized the SACs towards dissolution, while the metal centers were easily covered by O and OH, acting as additional ligands at high anodic potentials and high pH values. Thus, not only should local coordination be considered in terms of the activity of SACs, but it is also necessary to consider its effects on the speciation of SAC active centers under different potentials and pH conditions.

Single-Atom-Based Catalysts for Photocatalytic Water Splitting on TiO2 Nanostructures

H2 generation from photocatalytic water splitting is one of the most promising approaches to producing cost-effective and sustainable fuel. Nanostructured TiO2 is a highly stable and efficient semiconductor photocatalyst for this purpose. The main drawback of TiO2 as a photocatalyst is the sluggish charge transfer on the surface of TiO2 that can be tackled to a great extent by the use of platinum group materials (PGM) as co-catalysts. However, the scarcity and high cost of the PGMs is one of the issues that prevent the widespread use of TiO2/PGM systems for photocatalytic H2 generation. Single-atom catalysts which are currently the frontline in the catalysis field can be a favorable path to overcome the scarcity and further advance the use of noble metals. More importantly, single-atom (SA) catalysts simultaneously have the advantage of homogenous and heterogeneous catalysts. This mini-review specifically focuses on the single atom decoration of TiO2 nanostructures for photocatalytic water splitting. The latest progress in fabrication, characterization, and application of single-atoms in photocatalytic H2 generation on TiO2 is reviewed.

Facet-Control versus Co-Catalyst-Control in Photocatalytic H2 Evolution from Anatase TiO2 Nanocrystals

Titanium dioxide (TiO₂) and, in particular, its anatase polymorph, is widely studied for photocatalytic H₂ production. In the present work, we examine the importance of reactive facets of anatase crystallites on the photocatalytic H₂ evolution from aqueous methanol solutions. For this, we synthesized anatase TiO₂ nanocrystals with a large amount of either {001} facets, that is, nanosheets, or {101} facets, that is, octahedral nanocubes, and examined their photocatalytic H₂ evolution and then repeated this procedure with samples where Pt co‐catalyst is present on all facets. Octahedral nanocubes with abundant {101} facets produce >4 times more H₂ than nanosheets enriched in {001} facets if the reaction is carried out under co‐catalyst‐free conditions. For samples that carry Pt co‐catalyst on both {001} and {101} facets, faceting loses entirely its significance. This demonstrates that the beneficial role of faceting, namely the introduction of {101} facets that act as electron transfer mediator is relevant only for co‐catalyst‐free TiO₂ surfaces.

Techniques for the characterization of single atom catalysts

Single atom catalysts (SACs) are a hot research area recently. Over most of the SACs, the singly dispersed atoms are the active sites, which contribute to the catalytic activities significantly compared with a catalyst with continuously packed active sites. It is essential to determine whether SACs have been successfully synthesized. Several techniques have been applied for the characterization of the dispersion states of the active sites over SACs, such as Energy Dispersive X-ray spectroscopy (EDX), Electron Energy Loss Spectroscopy (EELS), etc. In this review, the techniques for the identification of the singly dispersed sites over SACs are introduced, the advantages and limitations of each technique are pointed out, and the future research directions have been discussed. It is hoped that this review will be helpful for a more comprehensive understanding of the characterization and detection methods involved in SACs, and stimulate and promote the further development of this emerging research field.