Effects of nebulizer fill volume on the efficacy and safety of the bronchodilator

Aerosol delivery through high flow nasal cannula compared to biphasic positive airway pressure, at two different pressure: an in-vitro study

Background

Both non-invasive ventilation and high flow oxygen therapy are preferred over low flow oxygen therapy in many conditions. Nebulizers, for aerosol delivery, can be used within them without interrupting the circuit. The present study aimed to compare the efficiency of drug delivery within high flow nasal cannula (HFNC) and biphasic positive airway pressure (BiPAP) ventilation mode using two different inspiratory positive airway pressures. The aerosol delivery was examined in HFNC system at low flow, 5 L min−1, and BiPAP non-invasive ventilation under 2 different pressures [high pressure; inspiratory positive airway pressure/expiratory positive airway pressure (IPAP/EPAP) of 20/5 cm water, and low pressure; IPAP/EPAP of 10/5 cm water]. The total inhalable dose (TID) was measured by inserting an Aerogen Solo nebulizer installed with 1 mL salbutamol respiratory solution (5000 μg mL−1) within the circuit, and the salbutamol was collected on an inhalation filter placed in a filter holder connected to a breathing simulator. The breathing simulator was adjusted at a tidal volume of 500 mL, respiratory rate of 15 breaths min−1, and inhalation to exhalation (I:E) ratio of 1:1 for the adult setting. In each technique of the three (HFNC, and low, and high-pressures BiPAP), TID was determined 5 times (n = 5). For particle size characterization, cooled Anderson Cascade Impactor (ACI) was inserted instead of the inhalation filter and the breathing simulator with the same scheme. In each technique of the three, particle size characterization was determined 3 times (n = 3).

Results

The BiPAP mode at low inspiratory pressure had the highest TID, followed by HFNC at flow 5 L min−1, then BiPAP mode at high inspiratory pressure. There was a significant difference only between low and high inspiratory pressure modes of BiPAP mode. Low-inspiratory pressure BiPAP delivered the highest mean ± SD fine particle dose (FPD). It was significantly higher than that delivered in high inspiratory pressure BiPAP, and HFNC. Also, FPD in HFNC was significantly higher than that in high inspiratory pressure BiPAP. HFNC system had the smallest mass median aerodynamic diameter (MMAD) and the highest FPF followed by low then high inspiratory pressure BiPAP.

Conclusions

Increasing the inspiratory positive airway pressure in BiPAP, from 10 to 20 cm water, decreased the total inhalable dose and FPF nearly by half. Low inspiratory pressure BiPAP delivered the highest TID and FPD. The HFNC system at low oxygen flow resulted in the least MMAD, and the highest FPF. Using HFNC delivered a TID that was non-significant from that delivered by low inspiratory pressure BiPAP.

Graphical Abstract

Lung deposition and systemic bioavailability of dose delivered to smoker compared with non-smoker COPD subjects

INTRODUCTION

Inhaled drugs are the most commonly used class of medications for COPD subjects. No studies have been performed to assess the influence of smoking on lung deposition of aerosolized medication, especially for the exacerbated COPD subject. The present study aimed to assess the influence of smoking on the lung deposition of the aerosol delivered to exacerbated COPD subjects.

METHODS

Twenty-four exacerbated COPD subjects using automatic continuous positive airway pressure (Auto-CPAP), 12 smokers (six females) and 12 non-smokers (six females) were recruited in the study. The subjects participated in the study received four salbutamol study doses; 1200 µg (12 puffs 100 µg/puff) of salbutamol emitted from pMDI canister connected to AeroChamber MV spacer; 1200 µg of salbutamol emitted from pMDI canister connected to Combihaler spacer; 1 mL of salbutamol respirable solution (5000 µg/mL) nebulized by Aerogen Solo connected to its T-piece; and 1 mL of salbutamol respirable solution nebulized by Aerogen Solo connected to Combihaler spacer with 2 puffs salbutamol MDI (200 µg salbutamol) before nebulisation. The subjects were randomised to receive the four selected dose-adaptor combination in a sealed envelope design on days 1, 3, 5 and 7. A washout period of 24 hours was provided between each salbutamol dosing. Auto-CPAP was adjusted at non-invasive ventilation mode with the integrated heated humidifier, as a source of humidity. Urine samples were provided by subjects, 30 minutes and cumulatively 24 hours post inhalation, as an index of the relative and systemic bioavailability, respectively, and aliquots were retained for salbutamol analysis using solid-phase extraction and high-performance liquid chromatography (HPLC). On day 2 of the study, a collecting filter was placed between the aerosol generator and the subject's mask so that the subjects would not inhale the salbutamol delivered. The same study doses and/or adapters were delivered to each subject, with filters changed with each dose-adapter combination. Salbutamol entrained on the filter was desorbed to be analysed by the HPLC.

RESULTS

Significantly higher lung deposition (30 minutes urinary salbutamol) was detected with the non-smoker compared with smokers (P < .05). Significantly higher systemic bioavailability (pooled 24-hour urinary salbutamol) for smokers compared with non-smokers was found with Aerogen Solo connected to its T-piece and CombiHaler spacer with pMDI (P < .05) only. Significantly higher amount desorbed from the ex-vivo filter were found from pMDI with both spacers in non-smokers (P < .05) compared with the smokers.

CONCLUSION

The study demonstrated that smoking reduced the lung deposition of inhaled salbutamol delivered by nebulizer or pMDI. However, the smoking effect on cytochrome p450 was observed to increase systemic absorption of the ingested portion of the inhaled dose. The lower lung deposition and possible higher systemic absorption should be taken into consideration while prescribing inhaled medication to COPD smokers especially exacerbated patients that need ventilation. Further studies are needed.