Modified sugar beet pulp and cellulose-based adsorbents as molasses quality enhancers: Assessing the treatment conditions

Dual Enzymolysis Assisted by Acrylate or Phosphate Grafting: Influences on the Structural and Functional Properties of Jujube Residue Dietary Fiber

Jujube residue is an abundant and low-cost dietary fiber resource, but its relatively lower hydration and functional properties limit its utilization as an ingredient of functional food. Thus, cellulase and hemicellulase hydrolysis, enzymatic hydrolysis assisted by phosphate grafting (EPG), and enzymatic hydrolysis assisted by acrylate grafting (EAG) were used to improve the functional properties of jujube residue dietary fiber (JRDF) in this study. The results evidenced that these modifications all increased the porosity of the microstructure of JRDF and increased the soluble fiber content, surface area, and hydration properties, but reduced its brightness (p < 0.05). Moreover, JRDF modified by enzymolysis combined with acrylate grafting offered the highest extractable polyphenol content, oil, sodium cholate, and nitrite ion sorption abilities. Meanwhile, JRDF modified via enzymolysis assisted by phosphate grafting showed the highest soluble fiber content (23.53 g∙100 g-1), water-retention ability (12.84 g∙g-1), viscosity (9.37 cP), water-swelling volume (10.80 mL∙g-1), and sorption ability of copper (II) and lead (II) ions. Alternatively, JRDF modified with cellulase hydrolysis alone exhibited the highest glucose adsorption capacity (21.9 g∙100 g-1) at pH 7.0. These results indicate that EPG is an effective way to improve the hypolipidemic effects of JRDF, while EAG is a good choice to enhance its hydration and hypoglycemic properties.

Nickel adsorption from waters onto Fe3O4/sugar beet pulp nanocomposite

In this study the magnetic nanocomposite material was synthesized with Fe₃O₄ impregnated to sugar beet pulp using chemical precipitation technique. Ni(II) removal performance of magnetic nanocomposite was investigated under different environmental conditions such as contact time, adsorbent dose, pH, initial heavy metal concentration, etc. The experimental studies have shown that, 81.2% Ni(II) removal efficiency was achieved at optimal conditions (25 mg/L initial Ni(II) concentration at 40 minute contact time, 200 rpm shaking speed, 5 g/L nanocomposite dose and pH 6.6). Freundlich and Langmuir isotherm experiments were performed and correlation coefficients were determined as 94.5% and 99.4%, respectively. The maximum adsorption capacity of material was achieved as 9.36 mg/g. These findings indicate that the adsorption that takes place is a monolayer process. The results of the pseudo-second order kinetic model (R² = 0.9947) indicate the chemisorptions process is used for Ni(II) removal using the electrostatic interaction. Thermodynamic studies illustrated that Ni(II) adsorption onto nanocomposite are exothermic and causes a decrease in the entropy. The adsorption of Ni(II) ions is non-spontaneous except for at low temperature and low initial concentrations. Nanocomposite characterization was illuminated with XRD, FT-IR, BET, TGA, TEM, SEM/EDX analysis.