Preparation of new polymeric phases for thin-film liquid phase microextraction (TF-LPME) of selected organic pollutants

Activated char embedded in biodegradable film for antimicrobials removal: Towards sustainable water purification

The development of sustainable materials toward efficient pollutant removal is crucial for water remediation. Following a waste-to-wealth approach, we report a novel preparation of biodegradable film embedded with a biomass-derived activated char and its effective application for the removal of fluoroquinolones from aqueous solutions. The presence of these antimicrobials contributes to the worrying increase of environmental antimicrobial resistance and ecotoxicity since they are emerging and harmful pollutants, and requires effective solution for their removal. The impact of different parameters on the sorptive performance was evaluated (e.g., type of polymeric support and char, amount of char), revealing that the removal process strongly depends on the type and amount of activated char used, whereas the polycaprolactone only acts as a support immobilizing the char and facilitating the sample treatment. By simply suspending the film in the aqueous sample, it is possible to adsorb the target contaminants, with removal efficiency up to 80 % in 240 min and satisfactory cumulative sorption capacity (Q up to 14,000 μg g-1) in competitive conditions. The sorption process obeys second-order kinetics in all the water samples tested (potable water, river water and wastewater). Notably, the film demonstrated continued stable removal capabilities over multiple uses (up to five). This work provides a new strategy for exploring a novel and efficient film for water purification.

Development of a Paper-Based Disposal Thin-Film Solid-Phase Microextraction Tool for the Quantification of Environmentally Hazardous 4-Chlorophenol in Water

The presence of chlorinated compounds in water resources presents various environmental and health risks. Therefore, there is a precise need to develop a potential technique for fast and efficient monitoring of chlorinated contaminants in water due to environmental protection and regulation compliance. Here, we designed a paper-based thin-film solid-phase microextraction (TF-SPME) patch to estimate 4-chlorophenol (4-CRP), a widely known environmentally hazardous pollutant in water samples. We fabricated the microextraction patch on the paper support utilizing the thin film applicator for uniform coating using divinylbenzene, polydimethylsiloxane, and a multiwalled carbon nanotube (MW-CNT) composite recipe. To check the performance of our fabricated tool, we directly exposed the TF-SPME patches to standard solutions with various concentrations of 4-CRP in water and finally quantified the analyte by exploiting the gas chromatography-mass spectrometer. Our experiments demonstrated the high extraction efficiency of the paper-based TF-SPME analytical tool for the estimation of 4-CRP in water with a limit of detection of ∼10 ng/mL, suggesting the practical applicability of the technique to monitor the analyte within the recommended range. To check the feasibility of the proposed technique for rapid determination, we performed the calibration curve of the analyte in the concentration range of 100-10,000 ng/mL and finally derived the curve fitting equation for the estimation of an unknown amount of 4-CRP. This study demonstrated the feasibility of using a simple paper-based thin-film solid-phase microextraction patch as a sampling kit for monitoring the environmentally hazardous 4-CRP pollutant from water. In the future, the proposed analytical method may be useful for the rapid quantification of chlorinated compounds from the water matrix.

New Materials for Thin-Film Solid-Phase Microextraction (TF-SPME) and Their Use for Isolation and Preconcentration of Selected Compounds from Aqueous, Biological and Food Matrices

Determination of a broad spectrum of analytes, carried out with analytical instruments in samples with complex matrices, including environmental, biological, and food samples, involves the development of new and selective sorption phases used in microextraction techniques that allow their isolation from the matrix. SPME solid-phase microextraction is compatible with green analytical chemistry among the sample preparation techniques, as it reduces the use of toxic organic solvents to the minimum necessary. Over the past two decades, it has undergone impressive progress, resulting in the development of the thin-film solid-phase microextraction technique, TF-SPME (the thin-film solid-phase microextraction), which is characterized by a much larger surface area of the sorption phase compared to that of the SPME fiber. TF-SPME devices, in the form of a mostly rectangular metal or polymer substrate onto which a thin film of sorption phase is applied, are characterized, among others, by a higher sorption capacity. In comparison with microextraction carried out on SPME fiber, they enable faster microextraction of analytes. The active phase on which analyte sorption occurs can be applied to the substrate through techniques such as dip coating, spin coating, electrospinning, rod coating, and spray coating. The dynamic development of materials chemistry makes it possible to use increasingly advanced materials as selective sorption phases in the TF-SPME technique: polymers, conducting polymers, molecularly imprinted polymers, organometallic frameworks, carbon nanomaterials, aptamers, polymeric ionic liquids, and deep eutectic solvents. Therefore, TF-SPME has been successfully used to prepare analytical samples to determine a broad spectrum of analytes in sample matrices: environmental, biological, and food. The work will be a review of the above-mentioned issues.

Deep eutectic solvents incorporated in a polymeric film for organophosphorus pesticide microextraction from water samples

BACKGROUND

Organophosphorus pesticides (OPPs) were extensively used in agriculture. Due to their adverse effect, there is a need for sensitive and reliable methods to determine these agrochemicals. Microextraction techniques (ME) afford the opportunity to substantially reduce the amount of organic solvent used in classical extraction methods for pesticide analysis. Moreover, deep eutectic solvents (DES) made of components of natural origin, have been applied in microextraction techniques as a green alternative to organic solvents. The combination of thin film microextraction and DES can be seen as an alternative for thin film microextraction of OPPs from water samples.

RESULTS

We describe a thin film microextraction-GC-MS method for the determination of OPPs from water samples. The thin film was prepared by solvent casting using cellulose triacetate (CTA) as the polymer and a deep eutectic solvent as the extracting phase. Lidocaine, menthol, dodecanoic acid, and camphor were tested as the components for DES-based film. With a film containing 70 % (w) of CTA and 30 % of the DES dodecanoic acid:lidocaine, quantitative results for the extraction of an OPPs mix were achieved. Then, the elution was performed with 2 mL of ethyl acetate. The validation of the TFME method was performed with a piece of the film suspended in 20 mL of sample solution with a contact time of 1 h. Limits of detection in the low μg L-1 range were obtained using a single quadrupole mass analyser. The thin film with pipette tip configuration was tested and preliminary results for chlorpyrifos were satisfactory.

SIGNIFICANCE

This represents the first approach to use polymeric films made of CTA and DES for TFME of OPPs, in two configuration the suspended film and pipette tip.

Sexual hormones monitoring in surface waters and wastewaters from Northern Italy by thin film microextraction coupled with HPLC-MS/MS

The occurrence of sex steroid hormones, viz. oestrogens and progestins, in aquatic ecosystems is of global concern due to their role as endocrine disrupting chemicals, even at low concentration (μg L-1 or less). Thus, it is essential to monitor these organic pollutants to get a realistic picture of their presence and to control their contamination levels in environmental water bodies. In this respect, we have explored the use of self-prepared polymeric films as novel sorptive phase for the microextraction of 17β-estradiol, 17α-ethinylestradiol, estrone, progesterone, medroxyprogesterone acetate and hydroxyprogesterone. The thin film microextraction procedure has been developed, evaluating different film compositions, sample volumes and elution conditions to recover the sorbed analytes. The overall method provides good reproducibility (RSD < 12%) and recoveries higher than 60%. The final method has been applied to environmental monitoring in surface waters (river and lake samples) and urban wastewater treatment plant effluents and influents from Northern Italy, to get a contamination snapshot of this highly urbanized area.

Biochar-based polymeric film as sustainable and efficient sorptive phase for preconcentration of steroid hormones in environmental waters and wastewaters

BACKGROUND

The environmental impact of sample preparation should be minimized through simplification of the procedures and the use of natural, renewable and/or reusable materials. In such scenario, thin-film microextraction fulfils the former criteria, as it enables few steps and miniaturization, thus small amount of extraction phase. At the same time, the use of sorbents such as biochars obtained from biomass waste is even more promoted due to their availability at low cost and increased life-cycle in a circular economy vision. However, it is not always easy to combine these criteria in sample preparation.

RESULTS

A thin film microextraction was developed for the determination of steroids in aqueous samples, entailing a membrane made of cellulose triacetate and a wood-derived biochar (Nuchar®) as carbon precursor. Different characterization techniques showed the successful preparation, whereas the sorption kinetics experiments demonstrated that biochar is responsible for the extraction with the polymer acting as a smart support. After a study about membranes' composition in terms of biochar amounts (4 %, 10 %, 16 % wt) and type of synthesis set up, the ceramic 3D-mold was selected, achieving reproducible and ready-to-use membranes with composition fixed as 10 %. Different elution conditions, viz. type and time of agitation, type, composition and volume of eluent, were evaluated. The final microextraction followed by HPLC-MS/MS quantification was successfully validated in river and wastewater treatment plant effluent samples in terms of accuracy (R% 64-123 %, RSD<19 % in river; R% 61-118 %, RSD <18 % in effluent, n = 4), sensitivity (MQLs 0.2-8.5 ng L-1) and robustness.

SIGNIFICANCE

This novel biochar-based polymeric film proved to be a valid and sustainable sorbent, in terms of extraction capability, ease of preparation and greenness. By comparison with literature and the greenness evaluation with the most recent metric tools, this method expands the potential applicability of the thin-film microextraction and opens up innovative scenarios for sustainable procedures entailing the use of biochars entrapped in bio-polymers.

Unpacking Phthalates from Obscurity in the Environment

Phthalates (PAEs) are a group of synthetic esters of phthalic acid compounds mostly used as plasticizers in plastic materials but are widely applied in most industries and products. As plasticizers in plastic materials, they are not chemically bound to the polymeric matrix and easily leach out. Logically, PAEs should be prevalent in the environment, but their prevalence, transport, fate, and effects have been largely unknown until recently. This has been attributed, inter alia, to a lack of standardized analytical procedures for identifying them in complex matrices. Nevertheless, current advancements in analytical techniques facilitate the understanding of PAEs in the environment. It is now known that they can potentially impact ecological and human health adversely, leading to their categorization as endocrine-disrupting chemicals, carcinogenic, and liver- and kidney-failure-causing agents, which has landed them among contaminants of emerging concern (CECs). Thus, this review article reports and discusses the developments and advancements in PAEs' standard analytical methods, facilitating their emergence from obscurity. It further explores the opportunities, challenges, and limits of their advancements.

Natural and Natural-Based Polymers: Recent Developments in Management of Emerging Pollutants

Anthropogenic activities lead to the issue of new classes of pollutants in the environment that are not currently monitored in environmental studies. This category of pollutants (known as emerging contaminants) includes a very wide range of target substances, such as pharmaceuticals, plant protection products, personal care products, dyes, toxins, microplastics and many other industrially important intermediaries. Together with an increasing demand for clean water (both for agricultural necessities and for the increasing population consumption), the need for the removal of emerging pollutants, simultaneously with the current "green chemistry" approach, opens the door for the industrial application of natural polymers in the area of environmental protection. Recent developments in this area are presented in this paper, as well as the application of these particular natural materials for the removal of other contaminants of interest (such as radioisotopes and nanoparticles). The current knowledge regarding the processes' kinetics is briefly presented, as well as the future development perspectives in this area.

Multiwalled Carbon Nanotubes Embedded in a Polymeric Matrix as a New Material for Thin Film Microextraction (TFME) in Organic Pollutant Monitoring

It is essential to monitor organic pollutants to control contamination levels in environmental water bodies. In this respect, the development of new materials based on functionalised polymeric films for the measurement of toxic compounds is of interest. In this study, we prepare new films based on polymer cellulose triacetate modified with multi-walled carbon nanotubes for the monitoring of selected compounds: a fungicide (chlorpyrifos) and two emerging contaminants, the musk tonalide and the bactericide triclosan, which are used in the formulation of personal care products. The films, upon contact with water samples and following the principles of thin film microextraction, allow the determination of organic pollutants at low concentration levels. The contact time of the film with a predetermined volume of water is fixed at 60 min, and the compounds are eluted with a small volume (1 mL) of organic solvent for GC-MS analysis. Parameters such as repeatability for different films and detection limits are found to be satisfactory. Applying the method to river water demonstrates its suitability and, in the cases of chlorpyrifos and tonalide, the absence of a significant matrix effect.

Preparation of monolith-based adsorbent containing abundant functional groups for field entrapment of nitrogen and sulfur containing aromatic compounds in environmental aqueous samples with portable multichannel in-tip microextraction device

Field sample preparation is important and interesting for analysis of nitrogen and sulfur containing aromatic compounds (N,S-CACs) in environmental aqueous samples. In this connection, a new functional groups-rich adsorbent based on porous monolith (ABM) was fabricated by in-situ copolymerization of allylaminocarbonylphenyl boronic acid/styrene and ethylene glycol dimethacrylate. The prepared ABM was employed as the extraction medium of homemade portable multichannel in-tip microextraction device (PMMD) for on-site entrapment of N,S-CACs in various waters. Because of the abundant functional groups, the obtained ABM/PMMD exhibited satisfactory capture capability towards studied N,S-CACs, and the enrichment factors varied from 454 to 491. Under the optimized fabrication conditions, adsorption and desorption parameters, the developed ABM/PMMD was used to field capture investigated N,S-CACs and followed by quantification with high performance liquid chromatography. The limits of detection were in the ranges of 0.00030-0.0016 µg/L. Recoveries with low, medium and high spiked contents located in the range of 82.1-118% with good repeatability (RSDs<9%). In addition, traditional laboratory sample pretreatment approach was employed to verify the reliability of the established method. Results well evidenced that the practicability of introduced ABM/PMMD in the field sample preparation of N,S-CACs in environmental waters.