Zinc (II) modified hydroxyapatites for tetracycline removal: Zn (II) doping or ZnO deposition and their influence in the adsorption

The fate of antibiotics during phosphate recovery processes - A critical review

The principles of circular economy encourage the recovery of phosphorus from nutrient-rich waste streams such as animal manure, domestic wastewater, and urine to supplement existing sources of raw phosphorus. However, these waste streams also contain a wide variety of contaminants of emerging concern including antibiotics, and the recovery of phosphorus from these waste streams results in the co-occurrence of antibiotics with the recovered phosphorus products. This paper provides a comprehensive overview of the fate of environmentally relevant antibiotics in three major existing and upcoming phosphorus recovery processes: precipitation-, membrane-, and adsorption-based treatment. In general, the co-occurrence of antibiotics in recovered phosphorus increases with the presence of dissolved organic matter (DOM) and cations due to π-π interaction and cationic bridge formation, respectively. Additionally, antibiotics display pH-based speciation resulting in electrostatic interactions with recovered phosphorus at pH > 7.0. Furthermore, this critical review establishes a new metric, the relative antibiotic-to‑phosphorus (RAP), defined as the ratio of the concentration of antibiotics to phosphorus in recovered phosphorus to that of the phosphorus-rich waste. Precipitation-based methods, particularly struvite, demonstrated the lowest RAP, while the RAP in carbon-based adsorbents was 1.8 × 108 times higher than in membrane-based processes. In reviewing literature on the fate of antibiotics in phosphorus recovery processes, several research needs are also highlighted: the fate of non-tetracycline antibiotics, simultaneous investigation of phosphorus and antibiotic fate in membrane- and adsorption-based methods, treatment methods to mitigate the co-occurrence of antibiotics in recovered phosphorus product, and the release of antibiotics from recovered phosphate products.

Study on the Performance of Coal Gangue-Loaded Hydroxyapatite (CG@HAP) for the Adsorption of Malachite Green

In response to the issues of dye wastewater pollution and coal gangue accumulation, a novel adsorbent, coal gangue-loaded hydroxyapatite (CG@HAP) was prepared using coal gangue as the raw material for the adsorption of malachite green dye wastewater. Based on batch experiments, combined with adsorption kinetics and isotherm models, as well as XRF, FTIR, XRD, and SEM analysis, the characteristics of CG@HAP in adsorbing malachite green were investigated. The results show that CG@HAP can be prepared by adding 150 mL of 0.15 mol/L (NH4)2HPO4 solution and 150 mL of 0.25 mol/L CaCl2 solution to 10 g coal gangue under the condition of pH = 10, allowing it to stand at room temperature for 24 h. When the dosage of CG@HAP was 0.10 g and the adsorption time was 180 min, the adsorption removal rate and adsorption capacity of CG@HAP for 400 mg/L malachite green reached 92.62% and 370.49 mg/g, respectively. The adsorption of malachite green by CG@HAP followed the pseudo-second-order kinetic model and the Langmuir isotherm model. The adsorption of malachite green by CG@HAP was primarily governed by chemical reactions, adhering to the Langmuir monolayer adsorption principle. The maximum adsorption capacity of CG@HAP for malachite green was 386 mg/g. CG@HAP exhibited sustained and efficient dynamic adsorption of malachite green, maintaining a removal rate between 83.52% and 99.96%. CG@HAP proved to be an efficient adsorbent for malachite green, with great potential for application.

Polysaccharide Hydroxyapatite (Nano)composites and Their Biomedical Applications: An Overview of Recent Years

Hydroxyapatite can combine with polysaccharide originating biomaterials with special applications in the biomedical field. In this review, the synthesis of (nano)composites is discussed, focusing on natural polysaccharides such as alginate, chitosan, and pectin. In this way, advances in recent years in the development of preparing materials are revised and discussed. Therefore, an overview of the recent synthesis and applications of polyssacharides@hydroxyapatites is presented. Several studies based on chitosan@hydroxyapatite combined with other inorganic matrices are highlighted, while pectin@hydroxyapatite is present in a smaller number of reports. Biomedical applications as drug carriers, adsorbents, and bone implants are discussed, combining their dependence with the nature of interactions on the molecular scale and the type of polysaccharides used, which is a relevant aspect to be explored.

Synthesis and characterization of new composite from modified silica-coated MnFe2O4 nanoparticles for removal of tetracycline from aqueous solution

In this study, a new composite from silica coated MnFe2O4 nanoparticles, diethylenetriamine, 3-chloropropyl trimethoxysilane and Mg-Al Layered Double Hydroxide (Mg-Al LDH/DETA/CPTMS/SCNPs) composite was synthesized. The Mg-Al LDH/DETA/CPTMS/SCNPs composite was examined by Fourier transform infrared spectrometer (FT-IR), Scanning Electron Microscopy (SEM), Energy Dispersive X-ray (EDS), X-ray diffraction (XRD), Thermogravimetric Analysis (TGA) and Vibrating Sample Magnetometry (VSM). The synthesized composite exhibited magnetic property with a saturation magnetization of 0.40 emu g-1. The Mg-Al LDH/DETA/CPTMS/SCNPs composite was utilized as a successful adsorbent for removal of tetracycline from aqueous solutions. The effect of various operation factors such as initial drug concentration, adsorbent dosage, pH and contact time were investigated. The optimized variable conditions such as adsorbent dose of 60 mg L-1, drug concentration of 100 mg L-1, pH = 7 and contact time 30 min were obtained. For describing the adsorption isotherms, the Langmuir, Freundlich and Temkin adsorption models were utilized. The results indicated that the adsorption isotherm is in good agreement with Langmuir model. According to the Langmuir analysis, the maximum adsorption capacity (qm) of the Mg-Al LDH/DETA/CPTMS/SCNPs composite for tetracycline was obtained to be 40.16 mg g-1. The kinetic studies revealed that the adsorption in all cases to be a pseudo second-order process. The negative value of ΔG° and the positive value of ΔH° showed the adsorption process to be spontaneous and endothermic.

Adsorptive removal of tetracycline and ciprofloxacin drugs from water by using a magnetic rod-like hydroxyapatite and MIL-101(Fe) metal-organic framework nanocomposite

A novel porous nanocomposite composed of hydroxyapatite nanorods (HAP), a MIL-101(Fe) metal-organic framework, and Fe₃O₄ nanoparticles was successfully fabricated in this work. The magnetic HAP/MIL-101(Fe)/Fe₃O₄ ternary nanocomposite was identified by various techniques, namely FT-IR spectroscopy, XRD, Raman spectroscopy, SEM, EDX, TEM, BET specific surface area, zeta potential, and VSM measurements. Tetracycline (TC) and ciprofloxacin (CIP) aqueous solutions were used to evaluate the adsorption performance of the resulting HAP/MIL-101(Fe)/Fe₃O₄ composite. The adsorption rate and capacity of HAP/MIL-101(Fe)/Fe₃O₄ were increased as compared with HAP, MIL-101(Fe), and HAP/MIL-101(Fe) samples due to the increased attraction. The influence of initial drug concentration, adsorbent dosage, temperature, and pH on the adsorption process was investigated. The results showed that the removal efficiencies of HAP/MIL-101(Fe)/Fe₃O₄ for TC and CIP were 95% and 93%, under the determined optimum conditions: pH of 7, drug concentration of 50 mg L^-1, adsorbent dosage of 30 mg, and temperature of 25 °C. The maximum adsorption capacities of HAP/MIL-101(Fe)/Fe₃O₄ for TC and CIP were 120.48 mg g^-1 and 112.35 mg g^-1, respectively. Reusability of the prepared nanocomposite was easily achieved up to three times without significant change in its structure. As a result, the synthesized magnetic nanocomposite can be reused as a suitable absorbent for TC and CIP removal from aqueous solutions.

Assessing sediment organic pollution via machine learning models and resource performance

Due to the potential ecological risks of organic pollution in sediments, aquatic ecosystems are currently facing substantial environmental threats. Assessing and controlling sediment pollution has become a huge challenge. Therefore, this study proposes a novel strategy for predicting organic pollution indicators for sediment, as well as an effective resource-utilization method. Contaminated sediments were converted into catalysts for sulfate radical advanced oxidation technologies by a one-step calcination method. The results revealed that the catalyst excelled in activating peroxymonosulfate to degrade tetracycline via a non-radical pathway. Most importantly, a predictive model of organic pollution indicators was established by machine learning. This study provides a novel approach for resource utilization and a strategy for assessing organic pollution in sediments.

Applications of Nano Hydroxyapatite as Adsorbents: A Review

Nano hydroxyapatite (Ca10(PO4)6(OH)2, HAp) has aroused widespread attention as a green and environmentally friendly adsorbent due to its outstanding ability in removing heavy metal ions, radio nuclides, organic pollutants and fluoride ions for wastewater treatment. The hexagonal crystal structure of HAp supports the adsorption mechanisms including ionic exchange reaction, surface complexation, the co-precipitation of new partially soluble phases and physical adsorption such as electrostatic interaction and hydrogen bonding. However, nano HAp has some drawbacks such as agglomeration and a significant pressure drop during filtration when used in powder form. Therefore, instead of using nano HAp alone, researchers have worked on modificationsand composites of nano HAp to overcome these issues and enhance the adsorption capacity. The modification of cationic doping and organic molecule grafting for nano HAp can promote the immobilization of ions and then increase adsorption capacity. Developing nano HAp composite with biopolymers such as gelatin, chitosan and chitin has proven to obtain a synergetic effect for improving the adsorption capacity of composites, in which nano HAp fixed and dispersed in polymers can playmuch more of a role for adsorption. This review summarizes the adsorption properties and adsorbent applications of nano HAp as well as the methods to enhance the adsorption capacity of nano HAp.

Light-Activated Hydroxyapatite Photocatalysts: New Environmentally-Friendly Materials to Mitigate Pollutants

This review focuses on a reasoned search for articles to treat contaminated water using hydroxyapatite (HAp)-based compounds. In addition, the fundamentals of heterogeneous photocatalysis were considered, combined with parameters that affect the pollutants’ degradation using hydroxyapatite-based photocatalyst design and strategies of this photocatalyst, and the challenges of and perspectives on the development of these materials. Many critical applications have been analyzed to degrade dyes, drugs, and pesticides using HAp-based photocatalysts. This systematic review highlights the recent state-of-the-art advances that enable new paths and good-quality preparations of HAp-derived photocatalysts for photocatalysis.

Gallium-Containing Hydroxyapatite as a Promising Material for Photocatalytic Performance

The development of photocatalystsor their modification to obtain new photocatalytic performances for the removal of contaminants is a challenge. Hydroxyapatite (HAp), (Ca10(PO4)6(OH)2), is an inorganic component with a high superficial area and low toxicity and the presence of metal in its structure can be an interesting strategy for the photocatalytic approach. This work aimed to synthesize gallium-containing HAp (Ga-HAp) as a promising material for photocatalytic performance. The synthesis was performed by the suspension–precipitation method. The material was characterized by X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS). Morphological analysis employed field emission scanning electron microscope (FESEM) and the elemental analysis by energy-dispersive spectroscopy (EDS). To evaluate the photocatalytic activity, methylene blue (MB) dye was used as a pollutant model under UV light for 120 min. The influence of Ga-HAp concentration (0.25, 0.50, and 1.00 g·L−1) and kinetic reaction was also studied. The Ga-HAp was successfully obtained by the suspension–precipitation method. The structural characterization by XRD and FESEM-EDS elucidated the presence of gallium in the structure of hydroxyapatite. The XPS results indicated the substitution of gallium in the crystal lattice of the material. The discoloration rate of MB dye using Ga-Hap was calculated by pseudo first-order kinetics, and the best rate constant was 7.5 × 10−3 min−1 using 1.00 g·L−1 of photocatalyst. The concentration of Ga-HAp influenced the photocatalytic process, because the discoloration rate increased as a function of the concentration of material. Therefore, Ga-HAp is a promising material for environmental remediation.