First insights into the formation and long-term dynamic behaviors of nonextractable perfluorooctanesulfonate and its alternative 6:2 chlorinated polyfluorinated ether sulfonate residues in a silty clay soil

Occurrence, fate, and remediation for per-and polyfluoroalkyl substances (PFAS) in sewage sludge: A comprehensive review

Addressing per-and polyfluoroalkyl substances (PFAS) contamination is an urgent environmental concern. While most research has focused on PFAS contamination in water matrices, comparatively little attention has been given to sludge, a significant by-product of wastewater treatment. This critical review presents the latest information on emission sources, global distribution, international regulations, analytical methods, and remediation technologies for PFAS in sludge and biosolids from wastewater treatment plants. PFAS concentrations in sludge matrices are typically in hundreds of ng/g dry weight (dw) in developed countries but are rarely reported in developing and least-developed countries due to the limited analytical capability. In comparison to water samples, efficient extraction and cleaning procedures are crucial for PFAS detection in sludge samples. While regulations on PFAS have mainly focused on soil due to biosolids reuse, only two countries have set limits on PFAS in sludge or biosolids with a maximum of 100 ng/g dw for major PFAS. Biological technologies using microbes and enzymes present in sludge are considered as having high potential for PFAS remediation, as they are eco-friendly, low-cost, and promising. By contrast, physical/chemical methods are either energy-intensive or linked to further challenges with PFAS contamination and disposal. The findings of this review deepen our comprehension of PFAS in sludge and have guided future research recommendations.

Influence of grain size, organic carbon and organic matter residue content on the sorption of per- and polyfluoroalkyl substances in aqueous film forming foam contaminated soils - Implications for remediation using soil washing

A soil that was historically contaminated with Aqueous Film Forming Foam (AFFF) was dry sieved into size fractions representative of those produced during soil washing. Batch sorption tests were then conducted to investigate the effect of soil parameters on in situ per- and polyfluoroalkyl substances (PFAS) sorption of these different size fractions: < 0.063 mm, 0.063 to 0.5 mm, 0.5 to 2 mm, 2 to 4 mm, 4 to 8 mm, and soil organic matter residues (SOMR). PFOS (513 ng/g), 6:2 FTS (132 ng/g) and PFHxS (58 ng/g) were the most dominant PFAS in the AFFF contaminated soil. Non-spiked, in situ K_d values for 19 PFAS ranged from 0.2 to 138 L/Kg (log K_d -0.8 to 2.14) for the bulk soil and were dependant on the head group and perfluorinated chain length (spanning C₄ to C₁₃). The K_d values increased with decreasing grain size and increasing organic carbon content (OC), which were correlated to each other. For example, the PFOS K_d value for silt and clay (< 0.063 mm, 17.1 L/Kg, log K_d 1.23) were approximately 30 times higher compared to the gravel fraction (4 to 8 mm, 0.6 L/Kg, log K_d -0.25). The highest PFOS K_d value (116.6 L/Kg, log K_d 2.07) was found for the SOMR fraction, which had the highest OC content. K_oc values for PFOS ranged from 6.9 L/Kg (log K_oc 0.84) for the gravel fraction to 1906 L/Kg (log K_oc 3.28) for the silt and clay, indicating that the mineral composition of the different size fractions also influenced sorption. The results here emphasize the need to separate coarse-grained fractions and fine-grained fractions, and in particular the SOMR, to optimize the soil washing process. Higher K_d values for the smaller size fractions indicate that coarser soils are better suited for soil washing.

Stabilisation of PFAS in soils: Long-term effectiveness of carbon-based soil amendments

Immobilisation/stabilisation is one of the most developed and studied approaches for treating soils contaminated with per- and poly-fluoroalkyl substances (PFAS). However, its application has been inhibited by insufficient understanding of the effectiveness of added soil sorbents over time. Herein, we present results on the effectiveness of select carbon-based sorbents, over 4 years (longevity) and multiple laboratory leaching conditions (durability). Standard batch leaching tests simulating aggressive, worst-case scenario conditions for leaching (i.e., shaking for 24-48 h at high liquid/solid ratios) were employed to test longevity and durability of stabilisation in clay-loam and sandy-loam soils historically contaminated with PFAS (2 and 14 mg/kg ∑₂₈ PFAS). The different sorbents, which were applied at 1-6% (w/w), reduced leaching of PFAS from the soils to varying degrees. Among the 5 sorbents tested, initial assessments completed 1 week after treatment revealed that 2 powdered activated carbon (PAC) sorbents and 1 biochar were able to reduce leaching of PFAS in the soil by at least 95%. Four years after treatment, the performance of the PAC sorbents did not significantly change, whilst colloidal AC improved and was able to reduce leaching of PFAS by at least 94%. The AC-treated soils also appeared to be durable and achieved at least 95% reduction in PFAS leaching under repetitive leaching events (5 times extraction) and with minimal effect of pH (pH 4-10.5). In contrast, the biochars were affected by aging and were at least 22% less effective in reducing PFAS leaching across a range of leaching conditions. Sorbent performance was generally consistent with the sorbent's physical and chemical characteristics. Overall, the AC sorbents used in this study appeared to be better than the biochars in stabilising PFAS in the long term.

Phytoremediation of fluoroalkylethers (ether-PFASs): A review on bioaccumulation and ecotoxilogical effects

Fluoroalkylethers (ether-PFASs), as alternatives to phased-out per- and perfluoroalkyl substances (PFASs), have attracted mounting attention due to their ubiquitous detection in aquatic environment and their similarity to legacy PFASs in terms of persistence and toxicity. In this review, the sources and distribution of ether-PFASs in soil ecosystem as well as their toxic impacts on soil microbial community are summarized. The plant uptake and bioaccumulation potential of ether-PFASs are presented, and a wide range of the influencing factors for their uptake and translocation is discussed. In response to ether-PFASs, the corresponding phytotoxic effects, such as seed germination, plant growth, photosynthesis, oxidative damage, antioxidant enzymes activities, and genotoxicity, are systematically elucidated. Finally, the current knowledge gaps and future research prospective are highlighted. The findings of this review will advance our understanding for the environmental behavior and implications ether-PFASs in soil-plant systems and help explore the strategies for ether-PFASs remediation to minimize their adverse toxicity.

Effect of two sorbents on the distribution and transformation of N-ethyl perfluorooctane sulfonamido acetic acid (N-EtFOSAA) in soil-soybean systems

The broad application of perfluoroalkyl acid (PFAA) precursors has led to their occurrence in soil, resulting in potential uptake and bioaccumulation in plants. In this study, we investigated the effect of powdered activated carbon (PAC) and montmorillonite on the distribution and transformation of a perfluorooctanesulfonic acid (PFOS) precursor, N-ethyl perfluorooctane sulfonamido acetic acid (N-EtFOSAA), in soil-plant systems. The results showed that N-EtFOSAA at 300 μg/kg was taken up by soybean roots and shoots together with its transformation products (i.e., perfluorooctane sulfonamide (PFOSA), PFOS), while decreasing the biomass of shoots and roots by 47.63% and 61.16%, respectively. PAC amendment significantly reduced the water leachable and methanol extractable N-EtFOSAA and its transformation products in soil. In the presence of soybean and after 60 days, 73.5% of the initially spiked N-EtFOSAA became non-extractable bound residues. Compared to the spiked controls, the PAC addition also decreased the total plant uptake of N-EtFOSAA by 94.96%. In contrast, montmorillonite showed limited stabilization performance for N-EtFOSAA and its transformation products and was ineffective to lower their bioavailability. Overall, the combination of PAC and soybean was found to be effective in immobilizing N-EtFOSAA in soil.

Evaluation of the Transformation and Leaching Behavior of Two Polyfluoroalkyl Phosphate Diesters in a Field Lysimeter Study

In this study, 6:2 and 8:2 polyfluoroalkyl phosphate diester (diPAP) were individually investigated in lysimeters under near-natural conditions. Leachate was sampled for 2 years, as was the soil after the experiment. In the leachate of the diPAP-spiked soils, perfluorocarboxylic acids (PFCAs) of different chain lengths were detected [23.2% (6:2 diPAP variant) and 20.8% (8:2 diPAP variant) of the initially applied molar amount]. After 2 years, the soils still contained 36-37% 6:2 diPAP and 41-45% 8:2 diPAP, respectively, in addition to smaller amounts of PFCAs (1.5 and 10.6%, respectively). Amounts of PFCAs found in the grass were low (<0.1% in both variants). The recovery rate of both 6:2 diPAP and 8:2 diPAP did not reach 100% (63.9 and 83.2%, respectively). The transformation of immobile diPAPs into persistent mobile PFCAs and their transport into the groundwater shows a pathway for human exposure to hazardous PFCAs through drinking water and irrigation of crops.

Changing bioavailability of per- and polyfluoroalkyl substances (PFAS) to plant in biosolids amended soil through stabilization or mobilization

Biosolids containing per- and polyfluoroalkyl substances (PFAS) could contaminate the receiving environments once they are land applied. In this study, we evaluated the feasibility of controlling the bioavailability of PFAS in biosolids to timothy-grass through stabilization or mobilization approaches. Stabilization was accomplished by adding a sorbent (i.e. granular activated carbon (GAC), RemBind, biochar) to biosolids, while mobilization was achieved by adding a surfactant, sodium dodecyl sulphate (SDS), to biosolids. The results showed that the ΣPFAS concentration in grass shoots grown in biosolids amended soil treated by GAC or RemBind at 2% was only 2.77% and 3.35% of the ΣPFAS concentration detected in shoots grown in biosolids amended soil without a sorbent, respectively, indicating the effectiveness of GAC and RemBind for stabilizing PFAS and reduce their bioavailability. On the other hand, mobilization by adding SDS to biosolids at a dose range of 10-100 mg/kg significantly increased the plant uptake of ΣPFAS by 15.48%-108.57%. Thus, mobilization by adding SDS could be a valuable approach for enhancing the PFAS removal if phytoremediation is applied. Moreover, higher rate of PFAS uptake took place after grass cutting was observed in this study. Thus, proper mowing and regrowth of timothy-grass could lead to efficient and cost-effective removal of PFAS from biosolids amended soil through phytoremediation and leave the site clean to be used for other purposes.

Exploring the source, migration and environmental risk of perfluoroalkyl acids and novel alternatives in groundwater beneath fluorochemical industries along the Yangtze River, China

The widely used legacy perfluoroalkyl acids (PFAAs) with serious environmental hazards are gradually restricted and being replaced by novel alternatives. Here, for an efficient control of emerging environmental risks in groundwater, we systematically studied the source apportionment, spatial attenuation, composition change and risk zoning of 12 PFAAs and five novel alternatives within a region of ~200 km² around a mega fluorochemical industrial park (FIP) along the Yangtze River, and in-depth explored potential association between groundwater and soil pollution as well as influencing factors on contaminant migration and risk distribution in the aquifer. Short-chain PFAAs and novel alternatives together accounted for over 70% in groundwater, revealing their prevalence in replacing legacy perfluorooctanoic acid (PFOA) and perfluorooctane sulfonate (PFOS). Novel alternatives for PFOA were mainly hexafluoropropylene oxide dimer acid (GenX) and hexafluoropropylene oxide trimer acid (HFPO-TA), while those for PFOS were 6:2 chlorinated polyfluorinated ether sulfonic acid (6:2 Cl-PFESA) and 6:2 fluorotelomer sulfonic acid (6:2 FTS). PFAAs (maximum total: 1339 ng/L) and novel alternatives (maximum total: 208 ng/L) in groundwater were mostly derived from the FIP, and exhibited an exponentially decreasing trend with increasing distance. Compared with those in groundwater, more diverse sources of PFAAs and novel alternatives in surface soil were identified. The transport of these chemicals may be retarded by clayed surface soils with high organic matter contents. High aquifer permeability could generally promote the dilution and migration of PFAAs and novel alternatives in groundwater, as well as reduce the differences in their spatial distribution. Shorter-chain components with smaller molecules and higher hydrophilicity exhibited greater migration capacities in the aquifer. In addition, different levels of health risk from PFOS and PFOA were zoned based on drinking groundwater, and high risks tended to be distributed in areas with relatively poor aquifer water yield due to higher pollutant accumulation.

Per- and polyfluoroalkyl substances in the environment

Over the past several years, the term PFAS (per- and polyfluoroalkyl substances) has grown to be emblematic of environmental contamination, garnering public, scientific, and regulatory concern. PFAS are synthesized by two processes, direct fluorination (e.g., electrochemical fluorination) and oligomerization (e.g., fluorotelomerization). More than a megatonne of PFAS is produced yearly, and thousands of PFAS wind up in end-use products. Atmospheric and aqueous fugitive releases during manufacturing, use, and disposal have resulted in the global distribution of these compounds. Volatile PFAS facilitate long-range transport, commonly followed by complex transformation schemes to recalcitrant terminal PFAS, which do not degrade under environmental conditions and thus migrate through the environment and accumulate in biota through multiple pathways. Efforts to remediate PFAS-contaminated matrices still are in their infancy, with much current research targeting drinking water.