Photodissolution of submillimeter-sized microplastics and its dependences on temperature and light composition

Wavelength Sensitive Plastic Photodissolution: Elucidating Quantum Yield Trends for Solar Activation Spectra

Plastic photodissolution into dissolved organic carbon (DOC) is a key proposed loss pathway for plastic in aquatic environments. However, the specific solar excitation wavelengths that drive photodissolution remain unknown, limiting our ability to model and predict photodissolution rates in natural aquatic environments. To better understand the impact of solar excitation wavelength on plastic photodissolution rates, we measured the wavelength sensitivity of photodissolution for a variety of transparent and semitransparent commercial and postconsumer plastic films with wide-spanning polymer chemistries. We irradiated plastic films using custom-built light-emitting diode (LED) photoreactors that emit light in the range of 275 to 445 nm and found that plastics exhibit a strong wavelength sensitivity, producing the highest DOC release rates for short wavelength ultraviolet (UV) light. We additionally calculated photodissolution quantum yield trends for transparent plastic films and then calculated photodissolution activation spectra. We found that solar UV light between 300-350 nm is responsible for most of the plastic photodissolution for all plastic compositions and predicted plastic photodissolution rates within water columns. Results advance our ability to model plastic photodissolution in natural aquatic environments.

A comprehensive review of microplastic aging: Laboratory simulations, physicochemical properties, adsorption mechanisms, and environmental impacts

As a new type of ecological environment problem, microplastic pollution is a severe challenge faced by the world, and its threat and potential risk to the ecosystem have become a hot research spot in the current environmental field. Microplastics (MPs) in the natural environment will experience aging effect, aging will change the physical and chemical properties of MPs and affect the adsorption behavior. Recently reported characterization techniques of MPs and laboratory simulation of aging are reviewed. The aging mechanism between MPs and different pollutants and the intervention mechanism of environmental factors (MPs, pollutants and water quality environment) were revealed. In addition, to further understand the potential ecological toxicity of MPs after aging, the release and harm of additives during aging, produce the environmentally persistent free radicals, and the mechanism of reactive oxygen species (ROS) removal of pollutants adsorbed on the surface of MPs were summarized. Future research efforts should focus more on bridging the disparity between laboratory aging simulations and natural environmental conditions to enhance the authenticity and ecological relevance of such studies. The ROS production mechanism of MPs provides a reference direction for removing pollutants adsorbed by aged MPs.

Microplastic dynamics and risk projections in West African coastal areas: Developing a vulnerability index, adverse ecological pathways, and mitigation framework using remote-sensed oceanographic profiles

Microplastic pollution presents a serious risk to marine ecosystems worldwide, with West Africa being especially susceptible. This study sought to identify the key factors driving microplastic dynamics in the region. Using NASA's Giovanni system, we analyzed environmental data from 2019 to 2024. Results showed uniform offshore air temperatures due to turbulence (25.22-45.62 K) with significant variations nearshore. Salinity levels remained largely stable (4 PSU) but slightly decreased in southern Nigeria. Surface wind speeds rose from 4.206-5.026 m/s in Nigeria to over 5.848 m/s off Mauritania, while eastward stress hotspots were prominent in Nigeria and from Sierra Leone to Senegal. Photosynthetically available radiation (PAR) beam values peaked off Mauritania and dipped from Nigeria to Sierra Leone, with the inverse pattern observed for diffuse PAR. Hotspots of high absorption, particulate backscattering, elevated aerosol optical depth, and remote sensing reflectance all pointed to substantial particulate matter concentrations. The Microplastic Vulnerability Index (MVI) identifies the coastal stretch from Nigeria to Guinea-Bissau as highly vulnerable to microplastic accumulation due to conditions that favor buildup. In contrast, moderate vulnerability was observed from Guinea-Bissau to Senegal and in Mauritania, where conditions were less extreme, such as higher offshore temperatures that could promote widespread microplastic suspension and cooler nearshore temperatures that favor sedimentation. Increased turbulence and temperatures in coastal areas of Senegal and Mauritania may enhance microplastic transport and impact marine life. In Nigeria, stable coastal conditions-characterized by consistent temperatures, low turbulence, and uniform salinity-may lead to increased persistence and accumulation of microplastics in sensitive habitats like mangroves and coral reefs. These findings highlight the need for region-specific management strategies to address microplastic pollution and effectively protect marine ecosystems.

Plastics in the environment in the context of UV radiation, climate change and the Montreal Protocol: UNEP Environmental Effects Assessment Panel, Update 2023

This Assessment Update by the Environmental Effects Assessment Panel (EEAP) of the United Nations Environment Programme (UNEP) considers the interactive effects of solar UV radiation, global warming, and other weathering factors on plastics. The Assessment illustrates the significance of solar UV radiation in decreasing the durability of plastic materials, degradation of plastic debris, formation of micro- and nanoplastic particles and accompanying leaching of potential toxic compounds. Micro- and nanoplastics have been found in all ecosystems, the atmosphere, and in humans. While the potential biological risks are not yet well-established, the widespread and increasing occurrence of plastic pollution is reason for continuing research and monitoring. Plastic debris persists after its intended life in soils, water bodies and the atmosphere as well as in living organisms. To counteract accumulation of plastics in the environment, the lifetime of novel plastics or plastic alternatives should better match the functional life of products, with eventual breakdown releasing harmless substances to the environment.

Sunlight-Driven Photochemical Removal of Polypropylene Microplastics from Surface Waters Follows Linear Kinetics and Does Not Result in Fragmentation

Floating microplastics are susceptible to sunlight-driven photodegradation, which can convert plastic carbon to dissolved organic carbon (DOC) and can facilitate microplastic fragmentation by mechanical forces. To understand the photochemical fate of sub-millimeter buoyant plastics, ∼0.6 mm polypropylene microplastics were photodegraded while tracking plastic mass, carbon, and particle size distributions. Plastic mass loss and carbon loss followed linear kinetics. At most time points DOC accumulation accounted for under 50% of the total plastic carbon lost. DOC accumulation followed sigmoidal kinetics, not the exponential kinetics previously reported for shorter irradiations. Thus, we suggest that estimates of plastic lifespan based on exponential DOC accumulation are inaccurate. Instead, linear plastic-C mass and plastic mass loss kinetics should be used, and these methods result in longer estimates of photochemical lifetimes for plastics in surface waters. Scanning electron microscopy revealed that photoirradiation produced two distinct patterns of cracking on the particles. However, size distribution analyses indicated that fragmentation was minimal. Instead, the initial population of microplastics shrank in size during irradiations, indicating photoirradiation in tranquil waters (i.e., without mechanical forcing) dissolved sub-millimeter plastics without fragmentation.

Tracking Dynamic Chemical Reactivity Networks with High-Resolution Mass Spectrometry: A Case of Microplastic-Derived Dissolved Organic Carbon

Chemical degradation testing often involves monitoring the loss of a chemical or the evolution of a single diagnostic product through time. Here, we demonstrate a novel approach to tracing complex degradation networks using mass-spectrometry-based methods and open cheminformatics tools. Ester- and ether-based thermoplastic polyurethane (TPU_Ester and TPU_Ether) microplastics (350 μm) and microplastics-derived dissolved organic carbon (MP-DOC) were photoweathered in a simulated marine environment and subsequently analyzed by liquid chromatography coupled to high-resolution mass spectrometry. We formula-annotated 1342 and 2344 unique features in the MP-DOC of TPU_Ester and TPU_Ether, respectively. From these, we extracted 199 and 568 plausible parent-transformation product pairs via matching of features (a) with complementary increasing and decreasing trends (Spearman's correlation coefficient between normalized intensity and time), (b) spectral similarities of at least three accurate mass MS2 fragments, and (c) at least 3 ppm agreement between the theoretical and measured change in m/z between the parent-transformation product formula. Molecular network analysis revealed that both chain scission and cross-linking reactions occur dynamically rather than degradation proceeding in a monotonic progression to smaller or more oxygenated structures. Network nodes with the highest degree of centrality were tentatively identified using in silico fragmentation and can be prioritized for toxicity screening or other physicochemical properties of interest. This work has important implications for chemical transformation tracking in complex mixtures and may someday enable improved elucidation of environmental transformation rules (i.e., structure-reactivity relationships) and fate modeling.

Spatial distribution, source apportionment and potential ecological risk assessment of suspended atmosphere microplastics in different underlying surfaces in Harbin

Although suspended atmospheric microplastics (SAMPs) have been found to be ubiquitous and have potential impacts on human health, whereas studies related to source apportionment and potential ecological risk assessment in the atmospheric environment are still limited. This study investigated spatial distribution, source apportionment and potential ecological risk of SAMPs in six underlying surfaces of Harbin, China. The results show that all six underlying surfaces existed SAMPs, including polypropylene (PP), polyethylene terephthalate (PET) polyethylene (PE), polystyrene (PS) and polyvinyl chloride (PVC), with approximate 26.13 %, 24.10 %, 23.87 %, 13.51 %, and 12.39 %, respectively. SAMPs abundances from filtered air were relatively high and averaged 1.76 n/m3. The SAMPs mainly contained fibrous (59.01 %), fragmented (30.18 %), and granular (10.81 %) with transparent (62.39 %), black 13.74 %), red (7.43 %), white (6.53 %), blue, and yellow (3.60 %), and particle size ranged from 1.3 to 518 μm. In addition, source apportionment of SAMPs shows that SAMPs were originated from five emission sources including living source (19.53 %), construction source (12.08 %), transportation source (47.25 %), industrial source (5.11 %), and agricultural source (16.13 %) in Harbin. A significant correction was observed between SAMPs abundances and human activity (R = 0.68, P = 0.66), atmospheric humidity (R = -0.40, P = 0.02), and wind direction (R = 0.22, P = 0.04) in different underlying surface. Furthermore, potential ecological hazardous single index (EI) of PVC and PS were higher than PP, PET, and PS in the construction land, cultivated land, forest land, grassland, water area, and unused land. An estimation of the potential ecological risk index (RI) from SAMPs using Positive Matrix Factorization (PMF) model indicated that Harbin presented a minor ecological risk with average 16.59 of RI index of microplastics in environments. In conclusion, data in this study indicate that SAMPs are existed in atmospheric environments, which have possible risks for human health via inhalation.

Hot and Cold: Photochemical Weathering Mediates Oil Properties and Fate Differently Depending on Seawater Temperature

Photochemical weathering transforms petroleum oil and changes its bulk physical properties, as well as its partitioning into seawater. This transformation process is likely to occur in a cold water marine oil spill, but little is known about the behavior of photochemically weathered oil in cold water. We quantified the effect of photochemical weathering on oil properties and partitioning across temperatures. Compared to weathering in the dark, photochemical weathering increases oil viscosity and water-soluble content, decreases oil-seawater interfacial tension, and slightly increases density. Many of these photochemical changes are much larger than changes caused by evaporative weathering. Further, the viscosity and water-soluble content of photochemically weathered oil are more temperature-sensitive compared to evaporatively weathered oil, which changes the importance of key fate processes in warm versus cold environments. Compared to at 30 °C, photochemically weathered oil at 5 °C would have a 16× higher viscosity and a 7× lower water-soluble content, resulting in lower entrainment and dissolution. Collectively, the physical properties and thus fate of photochemically weathered oil in a cold water spill may be substantially different from those in a warm water spill. These differences could affect the choice of oil spill response options in cold, high-light environments.