Commercial paper as a promising carrier for biofilm cultivation of Chlorella sp. for the treatment of anaerobic digestate food effluent (ADFE): Effect on the photosynthetic efficiency

Enhancing mixed-species microalgal biofilms for wastewater treatment: Design, construction, evaluation and optimisation

Biofilm-based cultivation of microalgae is a powerful method for wastewater treatment with low harvesting costs, water and energy consumption. This article provides a detailed summary of the design, construction, evaluation, and optimisation (DCEO) of mixed-species biofilms including algal and bacteria, and discusses their relevant applications in the treatment of industrial and agricultural wastewater and new pollutants. Finally, it presents the problems faced by mixed-species microalgal biofilms, along with solutions. DCEO is a typical synthetic biology concept, in which design and construction are bottom-up, and evaluation and optimisation are top-down approaches. Detailed knowledge of the metabolic pathways and the regulation of microalgae and other microorganisms is helpful for designing mixed-species biofilms. Three dimensional bioprinting is a powerful tool for constructing structured biofilms. Further analysis after evaluation is beneficial to optimise such biofilms. This review provides a new insight into using DCEO to enhance mixed-species biofilms for wastewater treatment.

Effect of light intensity on Chlorella sp. biofilm growth on anaerobically digested food effluents (ADFE)

Optimizing light conditions in any culture design for effluent treatment is crucial for maximizing microalgae growth and nutrient uptake. We investigated the impact of low (53 ± 1 μmol m-2 s-1), medium (208 ± 12 μmol m-2 s-1), and high (518 ± 22 μmol m-2 s-1) light intensities on the diffused biofilm-based growth of Chlorella sp. for treating anaerobically digested food effluent (ADFE). The alga grew well across all treatments, irrespective of light intensity. However, biomass yields, and productivity positively correlated with light intensity, with the highest biomass yield (120 g m-2) and productivity (11.6 g m-2 d-1) occurring at high light intensity. Notably, specific growth rates peaked uniformly on day 2 across all treatments, indicating an initial surge in growth. A relatively stable photosynthetic performance occurred under medium light treatment, while stress evidence was noticed particularly after day 4 at high and low light treatments, with higher magnitude seen under low light treatments. Total ammonia nitrogen (TAN) and phosphate removal efficiencies increased with light intensities, reaching 100 % removal at high light after 10 days. Intriguingly, there was a notable enhancement in chemical oxygen demand (COD) removal under low light conditions, being 2.9- and 1.64-fold higher compared to medium and high light intensities, respectively. Despite the superior performance of Chlorella sp. biofilm under high-light conditions in biomass yield and uptake of nutrients, the low-light treatment also achieved remarkable results, indicating that this biofilm design offers enhanced exposure to light. Therefore, this biofilm configuration presents an enticing opportunity for treating ADFE at lower light intensities, potentially minimizing energy consumption while maximizing profitability.

Biomass and hydrocarbon production from Botryococcus braunii: A review focusing on cultivation methods

Botryococcus braunii has garnered significant attention in recent years due to its ability to produce high amounts of renewable hydrocarbons through photosynthesis. As the world shifts towards a greener future and seeks alternative sources of energy, the cultivation of B. braunii and the extraction of its hydrocarbons can potentially provide a viable solution. However, the development of a sustainable and cost-effective process for cultivating B. braunii is not without challenges. Compared to other microalgae, B. braunii grows very slowly, making it time-consuming and expensive to produce biomass. In response to these challenges, several efforts have been put into optimizing Botryococcus braunii cultivation systems to increase biomass growth and hydrocarbon production efficiency. This review presents a comparative analysis of different Botryococcus braunii cultivation systems, and the factors affecting the productivity of biomass and hydrocarbon in Botryococcus braunii are critically discussed. Attached microalgal growth offers several advantages that hold significant potential for enhancing the economic viability of microalgal fuels. Here, we propose that employing attached growth cultivation, coupled with the milking technique for hydrocarbon extraction, represents an efficient approach for generating renewable fuels from B. braunii. Nevertheless, further research is needed to ascertain the viability of large-scale implementation.

Biofilm and suspension-based cultivation of microalgae to treat anaerobic digestate food effluent (ADFE)

Anaerobic digestion of organic waste produces effluent (ADE) that requires further treatment. Biofilm-based microalgal cultivation is a favoured approach to ADE treatment. This study compared Chlorella sp. MUR 268 and Scenedesmus sp. MUR 269 in biofilm and suspension cultures to treat anaerobic digestate food effluent (ADFE). Chlorella sp. MUR 268 biofilm had significantly higher biomass (50.38 g m-2) than Scenedesmus sp. biofilm (9.39 g m-2). Conversely, Scenedesmus sp. yielded 1.5 times more biomass (1.2 g L-1) than Chlorella sp. in suspension. Chlorella sp. biofilm had 49.3 % higher areal productivity than suspension, while Scenedesmus sp. showed 87.3 % higher areal growth in suspension. Chlorella sp. MUR 268 and Scenedesmus sp. MUR 269 significantly removed nutrients in ADFE. In suspension, COD, ammoniacal nitrogen, and phosphate were reduced to 94.9, 5.2, and 5.98 mg L-1 for Chlorella sp. MUR 268, and 245, 2.89, and 3.22 mg L-1 for Scenedesmus sp. MUR 269, respectively. In biofilm, Chlorella sp. MUR 268 achieved reductions to 149.9, 1.16, and 3.57 mg L-1, while Scenedesmus sp. MUR 269 achieved 100.2, 6.9 and 2.07 mg L-1. Most of these values are below the recommended effluent discharge standard, highlighting the efficacy of this system in ADFE treatment. Biofilm cultures fixed 68-81 % of removed nitrogen in biomass, while in suspension, only 55-71 % ended in the biomass. Chlorella sp. MUR 268 biofilm fixed 88 % of removed phosphorus, while Scenedesmus sp. MUR 269 suspension fixed more phosphorus (55 %) than the biofilm counterpart (34 %). This biofilm design offers advantages like simplified, cost-effective operation, easy biomass recovery, and reduced water usage.

Biofilm cultivation of chlorella species. MUR 269 to treat anaerobic digestate food effluent (ADFE): Total ammonia nitrogen (TAN) concentrations effect

Microalgal-based treatment of anaerobic digestate food effluent (ADFE) has been found to be efficient and effective. However, turbidity and high total ammonia nitrogen (TAN)) content of ADFE is a major setback, requiring significant dilution. Although the possibility of growing microalgae in a high-strength ADFE with minimal dilution has been demonstrated in suspension cultures, such effluents remain highly turbid and affect the light path in suspension cultures. Here, the feasibility of growing Chlorella sp.MUR 269 in biofilm to treat ADFE with high TAN concentrations was investigated. Six different TAN concentrations in ADFE were evaluated for their effects on biofilm growth and nutrient removal by Chlorella sp. MUR 269 using the perfused biofilm technique. Biomass yields and productivities of this alga at various TAN concentrations (mg N NH3 L-1) were 55a (108 g m-2 and 9.80 g m-2 d-1)>100b > 200c = 300c = 500c > 1000d. Growth was inhibited, resulting in a 28% reduction in yield of Chlorella biofilm when this alga was grown at 1000 mg N NH3 L-1. A survey of the photosynthetic parameters reveals evidence of stress occurring in the following sequence: 55 < 100<200 < 300<1000. A significant nutrient removal was observed across various TAN concentrations. The removal pattern also followed the concentration gradients except COD, where the highest removal occurred at 500 mg N NH3 L-1. Higher removal rates were seen at higher nutrient concentrations and declined gradually over time. In general, our results indicated that the perfused biofilm strategy is efficient, minimizes water consumption, offers easy biomass harvesting, and better exposure to light. Therefore, it can be suitable for treating turbid and concentrated effluent with minimal treatment to reduce the TAN concentration.

Eco-friendly cultivation of microalgae using a horizontal twin layer system for treatment of real solid waste leachate

Solid waste leachate (SWL) requires dilution with water to offset the negative effects of high nutrient concentration and organic compounds for its microalgae-based treatment. Among attached cultivation systems, twin layer is a technology in which limited information is available on treatment of high strength wastewater using microalgae. Moreover, widespread application of twin layer technology is limited due to cost of substrate and source layer used. In the present study, potential of Scenedesmus sp. for the treatment of SWL was assessed on horizontal twin layer system (HTLS). Novel and cost-effective substrate layers were tested as attachment material. Wetland treated municipal wastewater (WMW) was used to prepare SWL dilutions viz, 5%, 10%, 15%, 20% and 25% SWL. Recycled printing paper showed maximum biomass productivity of 5.19 g m-2 d-1. Among all the SWL dilutions, Scenedesmus sp. achieved maximum growth of 103.05 g m-2 in 5% SWL which was 16% higher than WMW alone. The maximum removal rate of NH4+ -N, TKN, and PO43- P was obtained in 20% SWL which was 1371, 1588 and 153 mg m-2 d-1 respectively. Varying concentrations of nutrients in different SWL dilutions significantly affected lipid biosynthesis, with enhanced productivity of 2.28 g m-2 d-1 achieved in 5% SWL compared to 0.97 g m-2 d-1 in 20% SWL. Hence, it can be concluded that 5% SWL dilution was good for biomass and lipid production, while the highest nutrient removal rates were obtained at 20% SWL mainly attributed to biotic and abiotic processes. Based on these results HTLS can be a promising technology for pilot scale to explore industrialized application of wastewater treatment and algal production.

Nano-clay modified membranes: A promising green strategy for microalgal antifouling filtration

Membrane fouling is a major challenge which limits the sustainable application of membrane filtration-based microalgal harvesting at industrial level. Membrane fouling leads to increased operational and maintenance costs and represents a major obstacle to microalgal downstream processing. Nano-clays are promising naturally occurring nanoparticles in membrane fabrication due to their low-cost, facile preparation, and their superior properties in terms of surface hydrophilicity, mechanical stability, and resistance against chemicals. The membrane surface modification using nano-clays is a sustainable promising approach to improve membranes mechanical properties and their fouling resistance. However, the positive effects of nano-clay particles on membrane fouling are often limited by aggregation and poor adhesion to the base polymeric matrix. This review surveys the recent efforts to achieve anti-fouling behavior using membrane surface modification with nano-clay fillers. Further, strategies to achieve a better incorporation of nano-clay in the polymer matrix of the membrane are summarised, and the factors that govern the membrane fouling, stability, adhesion, agglomeration and leaching are discussed in depth.