Cheese production potential of milk of Dahlem Cashmere goats from a rheological point of view

Harnessing the untapped potential of indigenous cow milk in producing set-type yoghurts: case of Thamankaduwa White and Lankan cattle

This research paper assessed textural, microstructural, sensory and colour properties of set-yoghurts produced using milk from two indigenous cattle types, Thamankaduwa White (TW) and Lankan cattle (LC) compared to two generic cattle breeds, Friesian and Jersey. Instrumental texture profile (firmness, adhesiveness, cohesiveness and springiness), colour space (L* a* b*) and scanning electron micrographs of set-yoghurts during 21 d of storage (4 ± 1°C) were evaluated. Sensory quality attributes were evaluated with 40 untrained panellists using a five-point hedonic scale. Set-yoghurts prepared using indigenous cow milk showed higher (P < 0.05) firmness, cohesiveness and apparent viscosity values compared to those prepared using generic cow milk. As revealed by micrographs, set-yoghurts made from TW milk had lesser and smaller void spaces and a dense protein gel network than gels made from LC and the two generic breeds. The gel network made from Friesian milk showed a comparatively larger porous gel structure and thinner protein strands resulting in a weaker gel than other milk gels. The highest lightness (L*) and yellowness (b*) were observed from set-yoghurt produced from Friesian and LC milk, respectively. Set-yoghurts from TW milk had the highest (P < 0.05) sensory scores for all sensory attributes. The lowest sensory acceptance was recorded in set-yoghurt made from Friesian milk. Thus, milk from TW and LC is likely to be suitable in producing set-yoghurts with superior textural, microstructural and sensory properties, compared to milk from Jersey and Friesian. Our results suggest the merits of using indigenous cow milk in producing set-yoghurts and, thereby, prioritizing the preservation of the genetic pool of these indigenous breeds.

Rheological Properties of Goat Milk Coagulation as Affected by Rennet Concentration, pH and Temperature

Various factors affect rennet coagulation and consequently cheese yield, but the subject of research has been mainly the cow milk. For the purpose of goat cheese production optimization, this paper investigated the influence of enzyme concentration (0.01–0.054 g/L), pH (6.5–6.1) and temperature (27–35 °C) on rennet coagulation of goat milk. Coagulation time (RCT), aggregation rate (AR), and gel firmness (G’60 and GF), were measured by oscillatory rheometry. The decrease in rennet concentration extended RCT. At lower rennet concentrations, a lower AR was recorded, which ranged from 0.02 Pa/s to 0.05 Pa/s. The decrease in pH from 6.5 to 6.1 caused a two times shorter RCT, and a two times faster AR. There was no effect of pH on the firmness of the rennet gel. The increase in coagulation temperature from 27 °C to 35 °C reduced the RCT of pasteurized milk from 12.6 min to 8.6 min, and caused a linear increase in the AR, but did not significantly affect the firmness of the gel. The present study revealed that the optimization of the rennet coagulation process could be directed towards pH lowering, or temperature increase, since they accelerate the process, but do not alter the examined gel firmness parameters.

Rheology and Microstructures of Rennet Gels From Differently Heated Goat Milk

Rennet coagulation of goat milk heated to 65 °C/30 min (Gc), 80 °C/5 min (G8) and 90 °C/5 min (G9) was studied. A rheometer equipped with a vane geometry tool was used to measure milk coagulation parameters and viscoelastic properties of rennet gels. Yield parameters: curd yield, laboratory curd yield and curd yield efficiency were measured and calculated. Scanning electron microscopy of rennet gels was conducted. Storage moduli (G') of gels at the moment of cutting were 19.9 ± 1.71 Pa (Gc), 11.9 ± 1.96 Pa (G8) and 7.3 ± 1.46 Pa (G9). Aggregation rate and curd firmness decreased with the increase of milk heating temperature, while coagulation time did not change significantly. High heat treatment of goat milk had a significant effect on both laboratory curd yield and curd yield. However, laboratory curd yield (27.7 ± 1.84%) of the G9 treatment was unreasonably high compared to curd yield (15.4 ± 0.60%). The microstructure of G9 was notably different compared to Gc and G8, with a denser and more compact microstructure, smaller paracasein micelles and void spaces in a form of cracks indicating weaker cross links. The findings of this study might serve as the bases for the development of different cheese types produced from high-heat-treated goat milk.